The DOI matches its Crossref record; 4 of the 4 references it cites were found in a registry or an index.
Towards uniformly distributed heat, mass and charge: A flow field design study for high pressure and high current density operation of PEM electrolysis cells
Open accessAbstract
In this work, a state-of-the-art, full-scale, Proton Exchange Membrane (PEM) electrolysis cell model is presented. The developed three-dimensional (3D) model accounts for compressible, two-phase flow including species, heat and charge transport in the anode and membrane. By incorporating electrochemistry as well as detailed heat and two-phase flow transport phenomena, the model is capable of studying cells at full-scale and for high current densities with high accuracy. To enable the modeling of thin catalyst layers (CL) for high current density operation in a 3D framework, the CL is modeled as an interfacial boundary. The necessary electrochemical parameters are obtained by fitting polarization curves of a two-dimensional version of the devised model to experimental measurements from a small cell. It is found that the obtained parameters are in agreement with literature values and that the fitted model is able to capture the performance for temperatures from 323 to 353 K and for current densities up to 5 A cm−2. Furthermore, it is identified that for high current density operation, three types of overpotential losses are nearly equally dominant: the anode kinetics, the PEM ohmic resistance and the non-membrane ohmic resistance due to poor electrical contact between layers and current constrictions in the CL. The developed 3D model is applied to three different circular, interdigitated anode flow fields aimed a high pressure and high current density operation. When operating the cell at a cathode pressure of 100 bar, a current density of 5 A cm−2 and stoichiometric constant of 350, it is found that the cell potential shows little dependence on the applied flow field. However, large in-plane variations can occur that may impact lifetime significantly. Particularly for the temperature field, an in-plane difference of up to 20.2 K relative to the intended cell temperature is found in the worst case. For all three cases, the occurrence of hot spots is linked to the maldistribution of two-phase flow and current density. Out of the studied cases, it was found that equal land width between the channels gives the best distribution of charge, mass and heat.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Two-equation eddy-viscosity turbulence models for engineering applications
Menter, F. R. (1994) · AIAA Journal · doi:10.2514/3.12149 · Cited by 21,593
Transport in Polymer-Electrolyte Membranes
Weber, A. Z., & Newman, J. (2004) · Journal of The Electrochemical Society · doi:10.1149/1.1639157 · Cited by 462
Transport in Polymer-Electrolyte Membranes
Weber, A. Z., & Newman, J. (2003) · Journal of The Electrochemical Society · doi:10.1149/1.1580822 · Cited by 411
Understanding the Effects of Compression and Constraints on Water Uptake of Fuel-Cell Membranes
Kusoglu, A., Kienitz, B. L., & Weber, A. Z. (2011) · Journal of The Electrochemical Society · doi:10.1149/2.097112jes · Cited by 72
Cited by
Wang, C. R., Stansberry, J. M., Mukundan, R., Chang, H.-M. J., Kulkarni, D., Park, A. M., Plymill, A. B., Firas, N. M., Liu, C. P., Lang, J. T., et al. (2025) · Chemical Reviews · doi:10.1021/acs.chemrev.3c00904 · Cited by 402
Bubble evolution and transport in PEM water electrolysis: Mechanism, impact, and management
Yuan, S., Zhao, C., Cai, X., An, L., Shen, S., Yan, X., & Zhang, J. (2023) · Progress in Energy and Combustion Science · doi:10.1016/j.pecs.2023.101075 · Cited by 393
Salehmin, M. N. I., Husaini, T., Goh, J., & Sulong, A. B. (2022) · Energy Conversion and Management · doi:10.1016/j.enconman.2022.115985 · Cited by 329
Mass transport in PEM water electrolysers: A review
Maier, M., Smith, K., Dodwell, J., Hinds, G., Shearing, P. R., & Brett, D. J. L. (2022) · International Journal of Hydrogen Energy · doi:10.1016/j.ijhydene.2021.10.013 · Cited by 268
Metadata
- Authors
- Olesen, A. C., Frensch, S. H., & Kær, S. K.
- Venue
- Electrochimica Acta
- Publisher
- Elsevier BV
- Published
- 2019-01
- Volume
- 293
- Pages
- 476-495
- ISSN
- 0013-4686 (ISSN-L)
- OpenAlex
- W2897047081
- Cited by
- 185
- References
- 4
- FWCI
- 3.01
- Type
- journal article
- Language
- en
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.