The DOI matches its Crossref record; 2 of the 2 references it cites were found in a registry or an index.
Vibration suppression of cables using tuned inerter dampers
Open accessAbstract
This paper considers the use of a tuned inerter damper (TID) system for suppressing unwanted cable vibrations. The TID consists of an inerter, a device that exerts a force proportional to relative acceleration, coupled with a parallel spring and damper. It may be thought of as similar to a tuned-mass-damper, but requiring two terminals. As a two terminal device, the performance of the TID is compared to the classical use of viscous dampers (VD) located close to one of the cable supports. We show that the limitation that exists with VDs, where the modal damping of the cable cannot exceed a maximum level for a given damper location, can be overcome through the use of the TID at the same location. A practical design methodology, based on the minimisation of the displacement amplitude at the mid-span of the cable subjected to support excitation, is proposed. An example where a cable is subjected to the El-Centro earthquake demonstrates that the system’s response is improved when a TID is used instead of a VD.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Synthesis of mechanical networks: the inerter
Smith, M. C. (2002) · IEEE Transactions on Automatic Control · doi:10.1109/tac.2002.803532 · Cited by 1,828
Marian, L., & Giaralis, A. (2014) · Probabilistic Engineering Mechanics · doi:10.1016/j.probengmech.2014.03.007 · Cited by 828
Cited by
Inerter-based structural vibration control: A state-of-the-art review
Ma, R., Bi, K., & Hao, H. (2021) · Engineering Structures · doi:10.1016/j.engstruct.2021.112655 · Cited by 445
Xu, K., Bi, K., Han, Q., Li, X., & Du, X. (2019) · Engineering Structures · doi:10.1016/j.engstruct.2018.12.067 · Cited by 211
Hu, Y., Wang, J., Chen, M. Z. Q., Li, Z., & Sun, Y. (2018) · Engineering Structures · doi:10.1016/j.engstruct.2018.09.063 · Cited by 200
An inertial nonlinear energy sink
Zhang, Z., Lu, Z.-Q., Ding, H., & Chen, L.-Q. (2019) · Journal of Sound and Vibration · doi:10.1016/j.jsv.2019.03.014 · Cited by 167
Tuned mass-damper-inerter (TMDI) for suppressing edgewise vibrations of wind turbine blades
Zhang, Z., & Fitzgerald, B. (2020) · Engineering Structures · doi:10.1016/j.engstruct.2020.110928 · Cited by 132
Metadata
- Authors
- Lazar, I. F., Neild, S. A., & Wagg, D. J.
- Venue
- Engineering Structures
- Publisher
- Elsevier BV
- Published
- 2016-09
- Volume
- 122
- Pages
- 62-71
- ISSN
- 0141-0296 (ISSN-L)
- OpenAlex
- W2346123067
- Cited by
- 281
- References
- 2
- FWCI
- 27.18
- Type
- journal article
- Language
- en
- Open access
- hybrid
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Vibration suppression of cables using tuned inerter dampers. https://app.cochat.ai/papers/10.1016/j.engstruct.2016.04.017
- The paper
- Lazar, I. F., Neild, S. A., & Wagg, D. J. (2016). Vibration suppression of cables using tuned inerter dampers. Engineering Structures. https://doi.org/10.1016/j.engstruct.2016.04.017
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.
