The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.
Frost formation and anti-icing performance of a hydrophobic coating on aluminum
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“This may result from the fact that the frost layer is always uneven during the entire frosting process, regardless of the types of plate surfaces, as seen in Fig. 13 (a) [115], (b) [117], (c) [116], and (d) [106].”
From Review on the measurement and calculation of frost characteristics (2018) · cites this paper as [116]
Citations
Cites
A fundamental understanding of factors affecting frost nucleation
Na, B., & Webb, R. L. (2003) · International Journal of Heat and Mass Transfer · doi:10.1016/s0017-9310(03)00194-7 · Cited by 225
Flagged first, then by citations
Research works printed but not linked: 33
- Kraj, 2010, Ses of icing on wind turbine blades characterized by ice accumulation, Renewable Energy, 35, 966, 10.1016/j.renene.2009.09.013 · DOI
- Menini, 2009, Elaboration of Al2O3/PTFE icephobic coatings for protecting aluminum surfaces, Surf. Coat. Technol., 203, 1941, 10.1016/j.surfcoat.2009.01.030 · DOI
- Lee, 2004, Frost formation on a plate with different surface hydrophilicity, Int. J. Heat Mass Transf., 47, 4881, 10.1016/j.ijheatmasstransfer.2004.05.021 · DOI
- Wang, 2004, Discussions on hydrophobic surface for preventing frosting and speeding defrosting of heat pump, Energy Conserv. Technol., 22, 37
- Nikulshina, 1979, The study of the influence of hydrophobic coating on thermal and aerodynamic characteristics of air coolers, Kholodilnaya Technika, 6, 28
- Liu, 2007, Influences of surface hydrophilicity on frost formation on a vertical cold plate under natural convection conditions, Exp. Thermal Fluid Sci., 31, 789, 10.1016/j.expthermflusci.2006.08.004 · DOI
- Liu, 2008, Frost formation on a super-hydrophobic surface under natural convection conditions, Int. J. Heat Mass Transf., 51, 5975, 10.1016/j.ijheatmasstransfer.2008.03.026 · DOI · Paper page
- Farhadi, 2011, Anti-icing performance of superhydrophobic surfaces, Appl. Surf. Sci., 257, 6264, 10.1016/j.apsusc.2011.02.057 · DOI
- Antonini, 2011, Understanding the effect of superhydrophobic coatings on energy reduction in anti-icing systems, Cold Reg. Sci. Technol., 67, 58, 10.1016/j.coldregions.2011.02.006 · DOI
- Shin, 2003, Experimental study on frost structure on surfaces with different hydrophilicity: density and thermal conductivity, ASME J. Heat Transf., 125, 84, 10.1115/1.1518496 · DOI · Paper page
- Xie, 2004, Facile creation of a bionic super-hydrophobic block copolymer surface, Adv. Mater., 16, 1830, 10.1002/adma.200400074 · DOI
- He, 2010, Super-hydrophobic film retards frost formation, Soft Matter, 6, 2396, 10.1039/c0sm00024h · DOI
- Wang, 2012, Effects of nano-fluorocarbon coating on icing, Appl. Surf. Sci., 258, 7219, 10.1016/j.apsusc.2012.04.043 · DOI
- Su, 2006, A simple way to fabricate multi-dimension bionic superhydrophobic surface, Chin. J. Inorg. Chem., 22, 785
- Song, 2006, Experimental research to fabricate super hydrophobic aluminum surface, J. Yangtze Univ., 3, 28
- Feng, 2002, Super-hydrophobic surfaces: from natural to artificial, Adv. Mater., 14, 1857, 10.1002/adma.200290020 · DOI
- Hsieh, 2006, Influence of fluorine/carbon atomic ratio on superhydrophobic behavior of carbon nanofiber arrays, J. Vac. Sci. Technol. B, 24, 113, 10.1116/1.2150224 · DOI
- Jeong, 2001, Preparation of water-repellent glass by sol–gel process using perfluoroalkylsilane and tetraethoxysilane, J. Colloid Interface Sci., 235, 130, 10.1006/jcis.2000.7313 · DOI
- Wu, 2002, Thin films with nanotextures for transparent and ultra water-repellent coatings produced from trimethylmethoxysilane by microwave plasma CVD, Chem. Vap. Deposition, 8, 47, 10.1002/1521-3862(20020304)8:2<47::AID-CVDE47>3.0.CO;2-# · DOI
- Miwa, 2000, Effects of the surface roughness on sliding angles of water droplets on superhydrophobic surfaces, Langmuir, 16, 5754, 10.1021/la991660o · DOI
- Bico, 1999, Pearl drops, Europhys. Lett., 47, 220, 10.1209/epl/i1999-00548-y · DOI
- Wu, 2005, Fabrication of superhydrophobic surfaces from microstructured ZnO-based surfaces via a wet-chemical route, Langmuir, 21, 2665, 10.1021/la050275y · DOI
- Zhao, 2006, A lotus-leaf-like superhydrophobic surface prepared by solvent-induced crystallization, ChemPhysChem, 7, 824, 10.1002/cphc.200500698 · DOI
- Kulinich, 2009, Ice adhesion on super-hydrophobic surfaces, Appl. Surf. Sci., 255, 8153, 10.1016/j.apsusc.2009.05.033 · DOI
- Kulinich, 2011, On ice-releasing properties of rough hydrophobic coatings, Cold Reg. Sci. Technol., 65, 60, 10.1016/j.coldregions.2010.01.001 · DOI
- Menini, 2011, Highly resistant icephobic coatings on aluminum alloys, Cold Reg. Sci. Technol., 65, 65, 10.1016/j.coldregions.2010.03.004 · DOI
- Wang, 2010, Ice accretion on superhydrophobic aluminum surfaces under low-temperature conditions, Cold Reg. Sci. Technol., 62, 29, 10.1016/j.coldregions.2010.02.005 · DOI
- Park, 2009, Interfacial and hydrophobic evaluation of glass fiber/CNT–epoxy nanocomposites using electro-micromechanical technique and wettability test, Compos. A, 40, 1722, 10.1016/j.compositesa.2009.08.006 · DOI
- Karim, 1998, Phase-separation-induced surface patterns in thin polymer blend films, Macromolecules, 31, 857, 10.1021/ma970687g · DOI
- Wang, 2012, Surface control and cryogenic durability of transparent CNT coatings on dip-coated glass substrates, J. Colloid Interface Sci., 386, 415, 10.1016/j.jcis.2012.07.056 · DOI
- Good, 1996, Hydrogen bonding and the interfacial component of adhesion: acid/base interactions of corona-treated polypropylene, J. Adhes., 59, 25, 10.1080/00218469608011074 · DOI
- Dilsiz, 2000, Effect of acid-base properties of unsized and sized carbon fibers on fiber/epoxy matrix adhesion, Colloids Surf. A, 164, 325, 10.1016/S0927-7757(99)00400-8 · DOI
- Owen, 1969, Estimation of the surface free energy of polymer, J. Appl. Polym. Sci., 13, 1741, 10.1002/app.1969.070130815 · DOI
Cited by
Sorted by citations
Items 101–103 of 103
Hydrophilic and Hydrophobic Coatings: Production and Application
Evdokimova, E. N., & Kochina, T. A. (2026) · Protection of Metals and Physical Chemistry of Surfaces · doi:10.1134/s2070205126700164
Enhancing corrosion resistance in aircraft fuselage skin by using hydrophobic coatings
Sathiyalingam, K., Rathnaraj, J. D., Sri, R. C., Dinesh, C., & Senthamizhselvan, T. (2017) · 2017 First International Conference on Recent Advances in Aerospace Engineering (ICRAAE) · doi:10.1109/icraae.2017.8297234
“Anti-icing properties on aluminium metal can be implemented by fabricating hydrophobic surface with water contact angle (WCA) of 147o[3].”
Background
Metadata
- Authors
- Wang, Z.-J., Kwon, D.-J., Lawrence DeVries, K., & Park, J.-M.
- Affiliations
- Gyeongsang National University (KR)
- Corresponding author
- Park, Joung-Man
- Venue
- Experimental Thermal and Fluid Science
- Publisher
- Elsevier BV
- Published
- 2015-01
- Volume
- 60
- Pages
- 132-137
- ISSN
- 0894-1777 (ISSN-L)
- OpenAlex
- W1982062205
- Cited by
- 116
- References
- 0
- Citations by year
- 2026: 6 · 2025: 11 · 2024: 8 · 2023: 9 · 2022: 8 · 2021: 10 · 2020: 11 · 2019: 10 · 2018: 20 · 2017: 12 · 2016: 9 · 2015: 2
- FWCI
- 3.02
- Type
- journal article
- Language
- en
- Open access
- closed
- Locations
- Experimental Thermal and Fluid Science (publishedVersion)
- Topics
- Physical Sciences › Materials Science › Surfaces, Coatings and Films › Surface Modification and Superhydrophobicity
- Physical Sciences › Engineering › Aerospace Engineering › Icing and De-icing Technologies
- Physical Sciences › Chemistry › Physical and Theoretical Chemistry › nanoparticles nucleation surface interactions
- Keywords
- hydrophobic coatings, frost formation, anti-icing, aluminum surfaces, aluminate coupling agent, contact angle, surface energy, interfacial adhesion, coating durability, fatigue testing
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review