The DOI matches its Crossref record; 38 of the 38 references it cites were found in a registry or an index.
Assessment of widely used methods to derive depositional ages from detrital zircon populations
Open accessAbstract
The calculation of a maximum depositional age (MDA) from a detrital zircon sample can provide insight into a variety of geological problems. However, the impact of sample size and calculation method on the accuracy of a resulting MDA has not been evaluated. We use large populations of synthetic zircon dates ( N ≈ 25,000) to analyze the impact of varying sample size ( n ), measurement uncertainty, and the abundance of near-depositional-age zircons on the accuracy and uncertainty of 9 commonly used MDA calculation methods. Furthermore, a new method, the youngest statistical population is tested. For each method, 500 samples of n synthetic dates were drawn from the parent population and MDAs were calculated. The mean and standard deviation of each method over the 500 trials at each n -value (50–1000, in increments of 50) were compared to the known depositional age of the synthetic population and used to compare the methods quantitatively in two simulation scenarios. The first simulation scenario varied the proportion of near-depositional-age grains in the synthetic population. The second scenario varied the uncertainty of the dates used to calculate the MDAs. Increasing sample size initially decreased the mean residual error and standard deviation calculated by each method. At higher n -values (>∼300 grains), calculated MDAs changed more slowly and the mean residual error increased or decreased depending on the method used. Increasing the proportion of near-depositional-age grains and lowering measurement uncertainty decreased the number of measurements required for the calculated MDAs to stabilize and decreased the standard deviation in calculated MDAs of the 500 samples. Results of the two simulation scenarios show that the most successful way to increase the accuracy of a calculated MDA is by acquiring a large number of low-uncertainty measurements (300 < n < 600). This maximizes the number of near-depositional-age grains that are dated. Ideally, a low-uncertainty (1%–2%, 2 σ ), large- n ( n > 300) approach is used if the calculation of accurate MDAs are key to research goals. Other acquisition methods, such as high- to moderate-precision measurement methods (e.g., 1%–5%, 2 σ ) acquiring low- to moderate- n datasets (50 < n < 300), will typically calculate MDAs with larger residual error and higher variance between samples. In general, the most successful and accurate methods tested are: the youngest single grain (YSG), youngest detrital zircon (YDZ), and the weighted average of the youngest three grains (Y3Z). These methods, however, are liable to calculate MDAs younger than the true depositional age if derived from populations with abundant near-depositional ages, or from large- n datasets ( n > 300). Additionally, they are most susceptible to producing erroneous MDAs due to contamination in the field or laboratory, or through disturbances of the youngest zircon's U–Pb systematics (e.g., lead loss). More conservative methods that still produce accurate MDAs and are less susceptible to contamination or lead loss include: youngest grain cluster at 1 σ uncertainty (YGC 1 σ ), youngest grain cluster at 2 σ uncertainty (YGC 2 σ ), and youngest statistical population (YSP). The ages calculated by these methods may be more useful and appealing when fitting calculated MDAs in to pre-existing chronostratigraphic frameworks, as they are less likely to be younger than the true depositional age. From the results of our numerical models we illustrate what geologic processes (i.e., tectonic or sedimentary) can be resolved using MDAs derived from strata of different ages.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Jackson, S. E., Pearson, N. J., Griffin, W. L., & Belousova, E. A. (2004) · Chemical Geology · doi:10.1016/j.chemgeo.2004.06.017 · Cited by 5,253
Dickinson, W. R., & Gehrels, G. E. (2009) · Earth and Planetary Science Letters · doi:10.1016/j.epsl.2009.09.013 · Cited by 1,581
Mattinson, J. M. (2005) · Chemical Geology · doi:10.1016/j.chemgeo.2005.03.011 · Cited by 1,476
Detrital zircon record and tectonic setting
Cawood, P. A., Hawkesworth, C. J., & Dhuime, B. (2012) · Geology · doi:10.1130/g32945.1 · Cited by 1,455
Horstwood, M., Košler, J., Gehrels, G. E., Jackson, S. E., McLean, N. M., Paton, C., Pearson, N. J., Sircombe, K., Sylvester, P., Vermeesch, P., et al. (2016) · Geostandards and Geoanalytical Research · doi:10.1111/j.1751-908x.2016.00379.x · Cited by 1,109
Detrital Zircon Analysis of the Sedimentary Record
Fedo, C. M. (2003) · Reviews in Mineralogy and Geochemistry · doi:10.2113/0530277 · Cited by 948
Woodhead, J. D., Hergt, J., Shelley, M., Eggins, S. M., & Kemp, R. (2004) · Chemical Geology · doi:10.1016/j.chemgeo.2004.04.026 · Cited by 918
On the Treatment of Concordant Uranium-Lead Ages
Ludwig, K. R. (1998) · Geochimica et Cosmochimica Acta · doi:10.1016/s0016-7037(98)00059-3 · Cited by 837
Detrital Zircon U-Pb Geochronology Applied to Tectonics
Gehrels, G. (2014) · Annual Review of Earth and Planetary Sciences · doi:10.1146/annurev-earth-050212-124012 · Cited by 812
How many grains are needed for a provenance study?
Vermeesch, P. (2004) · Earth and Planetary Science Letters · doi:10.1016/j.epsl.2004.05.037 · Cited by 773
Cited by
Maximum depositional age estimation revisited
Vermeesch, P. (2021) · Geoscience Frontiers · doi:10.1016/j.gsf.2020.08.008 · Cited by 296
Interpreting and reporting 40Ar/39Ar geochronologic data
Schaen, A. J., Jicha, B. R., Hodges, K. V., Vermeesch, P., Stelten, M. E., Mercer, C. M., Phillips, D., Rivera, T. A., Jourdan, F., Matchan, E. L., et al. (2021) · GSA Bulletin · doi:10.1130/b35560.1 · Cited by 283
Culshaw, N., Van De Kerckhove, S., Slagstad, T., Marsh, J., & Easton, R. M. (2023) · Precambrian Research · doi:10.1016/j.precamres.2023.106963 · Cited by 16
Metadata
- Authors
- Coutts, D. S., Matthews, W. A., & Hubbard, S. M.
- Venue
- Geoscience Frontiers
- Publisher
- Elsevier BV
- Published
- 2019-07
- Volume
- 10
- Issue
- 4
- Pages
- 1421-1435
- ISSN
- 1674-9871 (ISSN-L)
- OpenAlex
- W2908923699
- Cited by
- 439
- References
- 38
- FWCI
- 31.57
- Type
- journal article
- Language
- en
- Open access
- hybrid
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Assessment of widely used methods to derive depositional ages from detrital zircon populations. https://app.cochat.ai/papers/10.1016/j.gsf.2018.11.002
- The paper
- Coutts, D. S., Matthews, W. A., & Hubbard, S. M. (2019). Assessment of widely used methods to derive depositional ages from detrital zircon populations. Geoscience Frontiers. https://doi.org/10.1016/j.gsf.2018.11.002
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.