The DOI matches its Crossref record; 5 of the 5 references it cites were found in a registry or an index.
Accelerated carbonation curing of cement mortars containing cement kiln dust: An effective way of CO2 sequestration and carbon footprint reduction
Abstract
Abstract Accelerated Carbonation curing (ACC) is an innovative curing procedure for precast concrete units, which results in sequestration of the carbon dioxide gas and its conversion into stable products. The effect of carbonation curing on mortar mixes incorporating cement kiln dust (CKD) as partial replacement of cement has been investigated in the present study. Carbonation curing was carried out for 12 h, followed by either sealed bag curing or water spray curing for 3 days. The effect of carbonation curing was studied in terms of compressive strength, porosity and pH of the mix, along with SEM to study the resultant morphology. It was observed that ACC led to better early age strength and lower porosity as compared to water cured mortars with at least 20% increase in the strength for each mix. The later age strength decreased slightly by ACC due to water loss, but could be compensated by adopting subsequent water spray. The microstructure analysis showed presence of C-S-H gel and CaCO3 for the carbonated mortars, contributing to the additional strength and reduced porosity. Stoichiometric analysis of the control mix at 3 days of casting also confirmed that carbonation curing enhances the compressive strength and decreases porosity of the mix. It was observed that the finer particle size of CKD particles and presence of alkali in CKD further promotes the carbonation reaction, and hence led to large improvement in the properties of the resultant mix.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Bernal, S. A., San Nicolas, R., Myers, R. J., Mejía de Gutiérrez, R., Puertas, F., van Deventer, J. S. J., & Provis, J. L. (2014) · Cement and Concrete Research · doi:10.1016/j.cemconres.2013.12.003 · Cited by 493
A reaction engineering approach to the problem of concrete carbonation
Papadakis, V. G., Vayenas, C. G., & Fardis, M. N. (1989) · AIChE Journal · doi:10.1002/aic.690351008 · Cited by 404
Early age carbonation curing for precast reinforced concretes
Zhang, D., & Shao, Y. (2016) · Construction and Building Materials · doi:10.1016/j.conbuildmat.2016.03.048 · Cited by 236
Ahmad, S., Assaggaf, R. A., Maslehuddin, M., Al-Amoudi, O. S. B., Adekunle, S. K., & Ali, S. I. (2017) · Construction and Building Materials · doi:10.1016/j.conbuildmat.2017.01.069 · Cited by 208
Use of cement kiln dust in cement concrete and its leachate characteristics
Kunal, Siddique, R., & Rajor, A. (2012) · Resources, Conservation and Recycling · doi:10.1016/j.resconrec.2012.01.006 · Cited by 148
Cited by
Liu, Z., & Meng, W. (2021) · Journal of CO2 Utilization · doi:10.1016/j.jcou.2020.101428 · Cited by 465
Biochar as green additives in cement-based composites with carbon dioxide curing
Wang, L., Chen, L., Tsang, D. C. W., Guo, B., Yang, J., Shen, Z., Hou, D., Ok, Y. S., & Poon, C. S. (2020) · Journal of Cleaner Production · doi:10.1016/j.jclepro.2020.120678 · Cited by 373
An overview of utilizing CO2 for accelerated carbonation treatment in the concrete industry
Li, L., & Wu, M. (2022) · Journal of CO2 Utilization · doi:10.1016/j.jcou.2022.102000 · Cited by 305
Application of biochar in concrete – A review
Senadheera, S. S., Gupta, S., Kua, H. W., Hou, D., Kim, S., Tsang, D. C. W., & Ok, Y. S. (2023) · Cement and Concrete Composites · doi:10.1016/j.cemconcomp.2023.105204 · Cited by 255
Wang, D., Noguchi, T., & Nozaki, T. (2019) · Journal of Cleaner Production · doi:10.1016/j.jclepro.2019.117980 · Cited by 179
Metadata
- Authors
- Sharma, D., & Goyal, S.
- Venue
- Journal of Cleaner Production
- Publisher
- Elsevier BV
- Published
- 2018-08
- Volume
- 192
- Pages
- 844-854
- ISSN
- 0959-6526 (ISSN-L)
- OpenAlex
- W2803012167
- Cited by
- 201
- References
- 5
- FWCI
- 10.33
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.