Student or educator? Sign up with your school email and get 6 months of Pro free.
Cited by 303

The DOI matches its Crossref record; 52 of the 52 references it cites were found in a registry or an index.

Waste Valorisation using biochar for cement replacement and internal curing in ultra-high performance concrete

Open access
Dixit, Anjaneya, Gupta, Souradeep, Pang, Sze Dai, Kua, Harn Wei·2019·Journal of Cleaner Production

Abstract

Abstract The degree of hydration in ultra-high performance concrete (UHPC) is known to be low due to low water-cement ratio, leading to a substantial portion of cement merely being an expensive filler. The study presented herein demonstrates the potential of biochar as a mineral additive for cement replacement in UHPC, enhancing hydration due to its internal curing and nucleation effects. Biochar was prepared by pyrolysis of locally available mixed wood saw dust and segregated into three size ranges: coarse (C): 250–500 μm, medium (M): 125–250 μm, and fine (F): smaller than 125 μm. These were then used to replace cement at 2, 5 and 8% by weight in pre-soaked condition. The rate and total heat of hydration measured by isothermal calorimetry were consistently higher for biochar samples, with coarse biochar samples generating up to 30% more heat at 96-h mark compared to the control mix. The degree of hydration, estimated from thermo-gravimetric analysis using Bhatty's method, was found to increase from 42% (in control mix) to 59% (in samples with 5% by wt. fine biochar). Fine biochar at 5% replacement also showed comparable 28-days compressive strength (144 MPa) as the control mix (150 MPa). Microstructure of hydrated pastes studied through scanning electron microscopy showed deposition of cement hydrates on the surface and inside the surface pores of biochar, with dense interfacial transition zone, further suggesting the efficacy of biochar in improving hydration.

Overview

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1016/j.jclepro.2019.117876

Cites

52 of 52 references verified0 citation errors · 0 not checkable

Statistics

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Show all 52 references

Research works printed but not linked: 9

  1. Baker, 1971, Structural damage in graphite occurring during pore size measurements by high pressure mercury, Carbon N. Y., 9, 687, 10.1016/0008-6223(71)90092-3 · doi:10.1016/0008-6223(71)90092-3
  2. Bhatty, 1986, vol. 106, 93
  3. Frías, 2000, vol. 30, 209
  4. Gao, 2013, Estimating permeability using median pore-throat radius obtained from mercury intrusion porosimetry, J. Geophys. Eng., 10
  5. Katz, 1987, Prediction of rock electrical conductivity from mercury injection measurements, J. Geophys. Res. Solid Earth, 92, 599, 10.1029/JB092iB01p00599 · doi:10.1029/jb092ib01p00599
  6. Liu, 2018, Effect of slag cement on the properties of ultra-high performance concrete, Constr. Build. Mater., 190, 830, 10.1016/j.conbuildmat.2018.09.173 · doi:10.1016/j.conbuildmat.2018.09.173
  7. Wang, 2017, Influence of curing conditions on properties of normal and high strength concrete with and without pre-wetted lightweight Aggregates, J. Adv. Concr. Technol., 15, 300, 10.3151/jact.15.300 · doi:10.3151/jact.15.300
  8. Wang, 2017, Mix design and characteristics evaluation of an eco-friendly Ultra-High Performance Concrete incorporating recycled coral based materials, J. Clean. Prod., 165, 70, 10.1016/j.jclepro.2017.07.096 · doi:10.1016/j.jclepro.2017.07.096
  9. Wu, 2017, Comparative study on flexural properties of ultra-high performance concrete with supplementary cementitious materials under different curing regimes, Constr. Build. Mater., 136, 307, 10.1016/j.conbuildmat.2017.01.052 · doi:10.1016/j.conbuildmat.2017.01.052

Cited by

See all 303

Metadata

Authors
Dixit, A., Gupta, S., Pang, S. D., & Kua, H. W.
Venue
Journal of Cleaner Production
Publisher
Elsevier BV
Published
2019-11
Volume
238
Pages
117876
ISSN
0959-6526 (ISSN-L)
OpenAlex
W2964675506
Cited by
303
References
52
FWCI
15.88
Type
journal article
Language
en
Open access
bronze
Licence
Funders
Ministry of Education - Singapore

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

How to cite

Cite CoChat for the checks on this page, and the paper for its own findings.

This page
CoChat. (2026). Citation check: Waste Valorisation using biochar for cement replacement and internal curing in ultra-high performance concrete. https://app.cochat.ai/papers/10.1016/j.jclepro.2019.117876
The paper
Dixit, A., Gupta, S., Pang, S. D., & Kua, H. W. (2019). Waste Valorisation using biochar for cement replacement and internal curing in ultra-high performance concrete. Journal of Cleaner Production. https://doi.org/10.1016/j.jclepro.2019.117876

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.