The DOI matches its Crossref record; 27 of the 27 references it cites were found in a registry or an index.
Nanofluids effects on the evaporation rate in a solar still equipped with a heat exchanger
Abstract
In this paper, the performance of a solar still equipped with a heat exchanger using nanofluids has been studied both experimentally and theoretically through three key parameters, i.e., freshwater yield, energy efficiency and exergy efficiency. First, experiments are performed on a set-up, which is mainly composed of two flat plate solar collectors connected in series, and a solar still equipped with a heat exchanger. After heated in the collectors, the nanofluid enters the heat exchanger installed in the solar still basin to exchange heat with brackish water. The research question is to know how much the effect of nanofluids on the evaporation rate inside the solar desalination system is. The experiments are conducted for different nanoparticle volume fractions, two sizes of nanoparticles (7 and 40 nm), two depths of water in the solar still basin (4 and 8 cm), and three mass flow rates of nanofluids during various weather conditions. It is found that the weather conditions (mainly the sun radiation intensity) have a dominant influence on the solar still performance. To discover the effects of nanofluids, a mathematical model is developed and validated by experimental data at given weather conditions. The results reveal that using the heat exchanger at temperatures lower than 60 °C is not advantageous and the corresponding yield is smaller than that of solar still without the heat exchanger; although in such a case, using nanofluids as the working fluid in the heat exchanger can enhance the performance indices about 10%. At higher temperatures (e.g. 70 °C), the use of heat exchanger is beneficial; however, using nanofluids instead of water can augment the performance indices marginally i.e. just around 1%. In addition, it is found that in high temperatures using SiO 2 /water nanofluids, which have a lower effective thermal conductivity than that of Cu/water nanofluids, provides higher performance indices.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
RESISTANCE OF SOLID SURFACES TO WETTING BY WATER
Wenzel, R. N. (1936) · Industrial & Engineering Chemistry · doi:10.1021/ie50320a024 · Cited by 13,316 · cited 1×
“In addition, in 1936, Wenzel indicated that the wettability of liquid increases with increasing the surface roughness [41].”
BackgroundSolar engineering of thermal processes
(1982) · Solar Energy · doi:10.1016/0038-092x(82)90232-8 · Cited by 9,534
Piezoelectric Nanogenerators Based on Zinc Oxide Nanowire Arrays
Wang, Z. L., & Song, J. (2006) · Science · doi:10.1126/science.1124005 · Cited by 7,922 · cited 1×
“During recent decades, researchers have attempted to a ply nanotechnology to various energy and power systems such as electric generators, fuel cells, batteries, and solar cells [1-5].”
BackgroundSolar engineering of thermal processes
(1982) · Design Studies · doi:10.1016/0142-694x(82)90016-3 · Cited by 5,310
(2011) · Introduction to Thermal and Fluid Engineering · doi:10.1201/b12301-22 · Cited by 4,217
Direct-Current Nanogenerator Driven by Ultrasonic Waves
Wang, X., Song, J., Liu, J., & Wang, Z. L. (2007) · Science · doi:10.1126/science.1139366 · Cited by 2,260
A review on applications and challenges of nanofluids
Saidur, R., Leong, K. Y., & Mohammed, H. A. (2011) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2010.11.035 · Cited by 1,959
Silicon based lithium-ion battery anodes: A chronicle perspective review
Zuo, X., Zhu, J., Müller-Buschbaum, P., & Cheng, Y.-J. (2017) · Nano Energy · doi:10.1016/j.nanoen.2016.11.013 · Cited by 1,478
Heat transfer of aqueous suspensions of carbon nanotubes (CNT nanofluids)
Ding, Y., Alias, H., Wen, D., & Williams, R. A. (2006) · International Journal of Heat and Mass Transfer · doi:10.1016/j.ijheatmasstransfer.2005.07.009 · Cited by 1,426
Self-citationA review of the applications of nanofluids in solar energy
Mahian, O., Kianifar, A., Kalogirou, S. A., Pop, I., & Wongwises, S. (2013) · International Journal of Heat and Mass Transfer · doi:10.1016/j.ijheatmasstransfer.2012.10.037 · Cited by 1,288
Self-citationHAYHURST, A. N. (1997) · Food engineering series · doi:10.1007/978-1-4615-3864-6_3 · Cited by 999
He, Y., Jin, Y., Chen, H., Ding, Y., Cang, D., & Lu, H. (2007) · International Journal of Heat and Mass Transfer · doi:10.1016/j.ijheatmasstransfer.2006.10.024 · Cited by 918
Correlation equation for hourly diffuse radiation on a horizontal surface
Orgill, J. F., & Hollands, K. G. T. (1977) · Solar Energy · doi:10.1016/0038-092x(77)90006-8 · Cited by 701
Volumetric solar heating of nanofluids for direct vapor generation
Ni, G., Miljkovic, N., Ghasemi, H., Huang, X., Boriskina, S. V., Lin, C.-T., Wang, J., Xu, Y., Rahman, M. M., Zhang, T., et al. (2015) · Nano Energy · doi:10.1016/j.nanoen.2015.08.021 · Cited by 417
Solar Water Distillation : The Roof Type Still and a Multiple Effect Diffusion Still
Dunkle, R. V. (1961) · Medical Entomology and Zoology · Cited by 376
Steam generation in a nanoparticle-based solar receiver
Jin, H., Lin, G., Bai, L., Zeiny, A., & Wen, D. (2016) · Nano Energy · doi:10.1016/j.nanoen.2016.08.011 · Cited by 295
Self-citationEffect of Al2O3 nanoparticles on the performance of passive double slope solar still
Sahota, L., & Tiwari, G. N. (2016) · Solar Energy · doi:10.1016/j.solener.2016.02.018 · Cited by 289
A new methodology for the optimal design and production schedule of multipurpose batch plants
Cerda, J., Vicente, M., Gutierrez, J. M., Esplugas, S., & Mata, J. (1989) · Industrial & Engineering Chemistry Research · doi:10.1021/ie00091a016 · Cited by 233
Mahian, O., Kianifar, A., Şahin, A. Z., et al. (2014) · International Journal of Heat and Mass Transfer · doi:10.1016/j.ijheatmasstransfer.2014.06.051 · Cited by 209
Self-citationSahota, L., & Tiwari, G. N. (2016) · Desalination · doi:10.1016/j.desal.2016.02.039 · Cited by 209
Performance analysis of a minichannel-based solar collector using different nanofluids
Mahian, O., Kianifar, A., Şahin, A. Z., et al. (2014) · Energy Conversion and Management · doi:10.1016/j.enconman.2014.08.021 · Cited by 193
Self-citationRecent developments on fractal-based approaches to nanofluids and nanoparticle aggregation
Cai, J., Hu, X., Xiao, B., Zhou, Y., & Wei, W. (2017) · International Journal of Heat and Mass Transfer · doi:10.1016/j.ijheatmasstransfer.2016.10.011 · Cited by 169
Electrospun nanofibre composite polymer electrolyte fuel cell and electrolysis membranes
Sood, R., Cavaliere, S., Jones, D. J., & Rozière, J. (2016) · Nano Energy · doi:10.1016/j.nanoen.2016.06.027 · Cited by 166
Convective Heat Transfer of a Cu/Water Nanofluid Flowing Through a Circular Tube
Heris, S. Z., Etemad, S. G., & Esfahany, M. N. (2009) · Experimental Heat Transfer · doi:10.1080/08916150902950145 · Cited by 116
Self-citationThree-dimensional nanostructured electrodes for efficient quantum-dot-sensitized solar cells
Sun, J., Jiang, Y. L., Zhong, X., Hu, J., & Wan, L. (2016) · Nano Energy · doi:10.1016/j.nanoen.2016.12.022 · Cited by 92
Novel thermal switch based on magnetic nanofluids with remote activation
Puga, J. B., Bordalo, B. D., Silva, D. J., Dias, M. M., Belo, J. H., Araújo, J. P., Oliveira, J. C. R. E., Pereira, A. M., & Ventura, J. O. (2016) · Nano Energy · doi:10.1016/j.nanoen.2016.11.031 · Cited by 60
Modeling of double-loop fluidized bed solar reactor for efficient thermochemical fuel production
Milanese, M., Colangelo, G., Iacobazzi, F., & de Risi, A. (2016) · Solar Energy Materials and Solar Cells · doi:10.1016/j.solmat.2016.10.028 · Cited by 20
Cited by
Recent advances in modeling and simulation of nanofluid flows-Part I: Fundamentals and theory
Mahian, O., Kolsi, L., Amani, M., Estellé, P., Ahmadi, G., Kleinstreuer, C., Marshall, J. S., Siavashi, M., Taylor, R. A., Niazmand, H., et al. (2019) · Physics Reports · doi:10.1016/j.physrep.2018.11.004 · Cited by 949
Self-citationQiu, L., Zhu, N., Feng, Y., Michaelides, E. E., Żyła, G., Jing, D., Zhang, X., Norris, P. M., Markides, C. N., & Mahian, O. (2020) · Physics Reports · doi:10.1016/j.physrep.2019.12.001 · Cited by 523
Self-citationRecent advances in modeling and simulation of nanofluid flows—Part II: Applications
Mahian, O., Kolsi, L., Amani, M., Estellé, P., Ahmadi, G., Kleinstreuer, C., Marshall, J. S., Taylor, R. A., Abu-Nada, E., Rashidi, S., et al. (2019) · Physics Reports · doi:10.1016/j.physrep.2018.11.003 · Cited by 501
Self-citationSaid, Z., Sundar, L. S., Tiwari, A. K., Ali, H. M., Sheikholeslami, M., Bellos, E., & Babar, H. (2022) · Physics Reports · doi:10.1016/j.physrep.2021.07.002 · Cited by 391
Effects of nanoparticle-enhanced phase change material (NPCM) on solar still productivity
Dsilva Winfred Rufuss, D., Suganthi, L., Iniyan, S., & Davies, P. A. (2018) · Journal of Cleaner Production · doi:10.1016/j.jclepro.2018.04.201 · Cited by 316
Metadata
- Authors
- Mahian, O., Kianifar, A., Heris, S. Z., Wen, D., Sahin, A. Z., & Wongwises, S.
- Venue
- Nano Energy
- Publisher
- Elsevier BV
- Published
- 2017-06
- Volume
- 36
- Pages
- 134-155
- ISSN
- 2211-2855 (ISSN-L)
- OpenAlex
- W2606904263
- Cited by
- 404
- References
- 27
- FWCI
- 15.01
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.