The DOI matches its Crossref record; 15 of the 15 references it cites were found in a registry or an index.
Towards the development of an efficient low-NOx ammonia combustor for a micro gas turbine
Open accessAbstract
Abstract Recent studies have demonstrated stable generation of power from pure ammonia combustion in a micro gas turbine (MGT) with a high combustion efficiency, thus overcoming some of the challenges that discouraged such applications of ammonia in the past. However, achievement of low NOx emission from ammonia combustors remains an important challenge. In this study, combustion techniques and combustor design for efficient combustion and low NOx emission from an ammonia MGT swirl combustor are proposed. The effects of fuel injection angle, combustor inlet temperature, equivalence ratio, and ambient pressure on flame stabilization and emissions were investigated in a laboratory high pressure combustion chamber. An FTIR gas analyser was employed in analysing the exhaust gases. Numerical modeling using OpenFOAM was done to better understand the dependence of NO emissions on the equivalence ratio. The result show that inclined fuel injection as opposed to vertical injection along the combustor central axis resulted to improved flame stability, and lower NH3 and NOx emissions. Numerical and experimental results showed that a control of the equivalence ratio upstream of the combustor is critical for low NOx emission in a rich-lean ammonia combustor. NO emission had a minimum value at an upstream equivalence ratio of 1.10 in the experiments. Furthermore, NO emission was found to decrease with ambient pressure, especially for premixed combustion. For the rich-lean combustion strategy employed in this study, lower NOx emission was recorded in premixed combustion than in non-premixed combustion indicating the importance of mixture uniformity for low NOx emission from ammonia combustion. A prototype liner developed to enhance the control and uniformity of the equivalence ratio upstream of the combustor further improved ammonia combustion. With the proposed liner design, NOx emission of 42 ppmv and ammonia combustion efficiency of 99.5% were achieved at 0.3 MPa for fuel input power of 31.44 kW.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Subgrid-scale stress modelling based on the square of the velocity gradient tensor
Nicoud, F., & Ducros, F. (1999) · Flow, Turbulence and Combustion · doi:10.1023/a:1009995426001 · Cited by 4,161
Experimental and numerical study of the laminar burning velocity of CH4–NH3–air premixed flames
Okafor, E. C., Naito, Y., Colson, S., Ichikawa, A., Kudo, T., Hayakawa, A., & Kobayashi, H. (2018) · Combustion and Flame · doi:10.1016/j.combustflame.2017.09.002 · Cited by 1,068
Self-citationSyred, N. (2006) · Progress in Energy and Combustion Science · doi:10.1016/j.pecs.2005.10.002 · Cited by 1,031
Laminar burning velocity and Markstein length of ammonia/air premixed flames at various pressures
Hayakawa, A., Goto, T., Mimoto, R., Arakawa, Y., Kudo, T., & Kobayashi, H. (2015) · Fuel · doi:10.1016/j.fuel.2015.06.070 · Cited by 854
Self-citationAn experimental and kinetic modeling study of premixed NH3/CH4/O2/Ar flames at low pressure
Tian, Z., Li, Y., Zhang, L., Glarborg, P., & Qi, F. (2009) · Combustion and Flame · doi:10.1016/j.combustflame.2009.03.005 · Cited by 635
Kurata, O., Iki, N., Matsunuma, T., Inoue, T., Tsujimura, T., Furutani, H., Kobayashi, H., & Hayakawa, A. (2017) · Proceedings of the Combustion Institute · doi:10.1016/j.proci.2016.07.088 · Cited by 582
Self-citationAmmonia–methane combustion in tangential swirl burners for gas turbine power generation
Valera-Medina, A., Marsh, R., Runyon, J., Pugh, D., Beasley, P., Hughes, T., & Bowen, P. (2017) · Applied Energy · doi:10.1016/j.apenergy.2016.02.073 · Cited by 480
Kinetic Modeling of the Oxidation of Ammonia in Flames
Miller, J. A., Smooke, M. D., Green, R. M., & Kee, R. J. (1983) · Combustion Science and Technology · doi:10.1080/00102208308923691 · Cited by 426
Hayakawa, A., Arakawa, Y., Mimoto, R., Somarathne, K. D. K. A., Kudo, T., & Kobayashi, H. (2017) · International Journal of Hydrogen Energy · doi:10.1016/j.ijhydene.2017.01.046 · Cited by 385
Self-citationAmmonia combustion properties and performance in gas-turbine burners
Verkamp, F. J., Hardin, M. C., & Williams, J. R. (1967) · Symposium (International) on Combustion · doi:10.1016/s0082-0784(67)80225-x · Cited by 339
Somarathne, K. D. K. A., Hatakeyama, S., Hayakawa, A., & Kobayashi, H. (2017) · International Journal of Hydrogen Energy · doi:10.1016/j.ijhydene.2017.09.089 · Cited by 319
Self-citationA pyrolysis mechanism for ammonia
Davidson, D. F., Kohse‐Höinghaus, K., Chang, A. Y., & Hanson, R. K. (1990) · International Journal of Chemical Kinetics · doi:10.1002/kin.550220508 · Cited by 245
Contino, F., Jeanmart, H., Lucchini, T., & D’Errico, G. (2011) · Proceedings of the Combustion Institute · doi:10.1016/j.proci.2010.08.002 · Cited by 185
Xiao, H., Valera-Medina, A., Marsh, R., & Bowen, P. J. (2017) · Fuel · doi:10.1016/j.fuel.2017.01.095 · Cited by 137
PERFORMANCE OF AMMONIA-FIRED GAS-TURBINE COMBUSTORS
Pratt, D. T. (1967) · doi:10.21236/ad0657585 · Cited by 86
Cited by
Review on Ammonia as a Potential Fuel: From Synthesis to Economics
Valera-Medina, A., Amer-Hatem, F., Azad, A. K., Dedoussi, I. C., de Joannon, M., Fernandes, R. X., Glarborg, P., Hashemi, H., He, X., Mashruk, S., et al. (2021) · Energy & Fuels · doi:10.1021/acs.energyfuels.0c03685 · Cited by 1,061
A review on ammonia, ammonia-hydrogen and ammonia-methane fuels
Chai, W. S., Bao, Y., Jin, P., Tang, G., & Zhou, L. (2021) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2021.111254 · Cited by 1,028
Review on the recent advances on ammonia combustion from the fundamentals to the applications
Elbaz, A. M., Wang, S., Guiberti, T. F., & Roberts, W. L. (2022) · Fuel Communications · doi:10.1016/j.jfueco.2022.100053 · Cited by 639
Okafor, E. C., Naito, Y., Colson, S., Ichikawa, A., Kudo, T., Hayakawa, A., & Kobayashi, H. (2019) · Combustion and Flame · doi:10.1016/j.combustflame.2019.03.008 · Cited by 593
Self-citationAdvancements of combustion technologies in the ammonia-fuelled engines
Chiong, M.-C., Chong, C. T., Ng, J.-H., Mashruk, S., Chong, W. W. F., Samiran, N. A., Mong, G. R., & Valera-Medina, A. (2021) · Energy Conversion and Management · doi:10.1016/j.enconman.2021.114460 · Cited by 529
Metadata
- Authors
- Okafor, E. C., Somarathne, K. D. K. A., Hayakawa, A., Kudo, T., Kurata, O., Iki, N., & Kobayashi, H.
- Venue
- Proceedings of the Combustion Institute
- Publisher
- Elsevier BV
- Published
- 2019
- Volume
- 37
- Issue
- 4
- Pages
- 4597-4606
- ISSN
- 1540-7489 (ISSN-L)
- OpenAlex
- W2887679581
- Cited by
- 439
- References
- 15
- FWCI
- 15.29
- Type
- journal article
- Language
- en
- Open access
- bronze
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.