The DOI matches its Crossref record; 8 of the 8 references it cites were found in a registry or an index.
Electrochemical Pretreatment of Polycrystalline Gold Electrodes To Produce a Reproducible Surface Roughness for Self-Assembly: A Study in Phosphate Buffer pH 7.4
Abstract
It has been emphasized in several studies that the state of the surface, including the surface roughness, is very important for the reproducible formation of high-quality self-assembled monolayers on gold. The pulsed-potential pretreatment procedure described in this paper can, in a reproducible way, reduce the surface roughness of mechanically polished polycrystalline gold electrodes by a factor 2. The developed procedure, in which the gold is alternately oxidized and reduced, has been optimized for use in a flow system (100 mM phosphate buffer pH 7.4). The influence of the pretreatment procedure on the surface roughness of the electrodes has been studied by in-situ oxygen adsorption measurements using cyclic voltammetry. The most effective pulse regime in producing a gold surface with a reproducible and relatively low surface roughness is a triple-potential pulse waveform, with potentials of +1.6, 0.0, and -0.8 Vvs SCE and pulse widths of 100 ms for each potential. Prolonged pulsing for 2000-5000 s with the gold working electrode in a flow-through cell showed an electropolishing effect, i.e., a decrease of the roughness in time. Flow conditions are very important: the roughness decreased faster at higher flow rates, while an increase was observed without flow. A process of reconstruction and dissolution of gold during application of the potential pulses under flow conditions is assumed to account for the observed phenomena. A self-assembled monolayer of thioctic acid with reproducible characteristics, determined with impedance measurements, could be formed on a pretreated gold surface.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Surface plasmon resonance sensors: review
Homola, J., Yee, S. S., & Gauglitz, G. (1999) · Sensors and Actuators B: Chemical · doi:10.1016/s0925-4005(98)00321-9 · Cited by 5,453
Real surface area measurements in electrochemistry
Trasatti, S., & Petrii, O. A. (1991) · Pure and Applied Chemistry · doi:10.1351/pac199163050711 · Cited by 1,832
Electroanalytical Chemistry: A Series of Advances
(2010) · Electroanalytical chemistry, a series of advances · doi:10.1201/crcelecheadv · Cited by 740
Self-assembled Monolayers for Biosensors
Wink, T., van Zuilen, S. J., Bult, A., & van Bennekom, W. P. (1997) · The Analyst · doi:10.1039/a606964i · Cited by 634
Self-citationOesch, U., & Janata, J. (1983) · Electrochimica Acta · doi:10.1016/0013-4686(83)85011-7 · Cited by 237
Ron, H., Matlis, S., & Rubinstein, I. (1998) · Langmuir · doi:10.1021/la970785v · Cited by 235
Electrochemical Interfaces: Modern Techniques for In-Situ Interface Characterization
Abruña, H. D. (1991) · Medical Entomology and Zoology · Cited by 149
Chialvo, A. C., Triaca, W. E., & Arvía, A. J. (1983) · Journal of Electroanalytical Chemistry · doi:10.1016/s0022-0728(83)80114-4 · Cited by 133
Cited by
Label‐Free Impedance Biosensors: Opportunities and Challenges
Daniels, J. S., & Pourmand, N. (2007) · Electroanalysis · doi:10.1002/elan.200603855 · Cited by 1,192
Moysiadou, A., Lee, S., Hsu, C.-S., Chen, H. M., & Hu, X. (2020) · Journal of the American Chemical Society · doi:10.1021/jacs.0c04867 · Cited by 987
Liu, Y.-C., Koza, J. A., & Switzer, J. A. (2014) · Electrochimica Acta · doi:10.1016/j.electacta.2014.04.036 · Cited by 427
Impedance Spectroscopy: A Powerful Tool for Rapid Biomolecular Screening and Cell Culture Monitoring
K'Owino, I. O., & Sadik, O. A. (2005) · Electroanalysis · doi:10.1002/elan.200503371 · Cited by 292
Impurity Ion Complexation Enhances Carbon Dioxide Reduction Catalysis
Wuttig, A., & Surendranath, Y. (2015) · ACS Catalysis · doi:10.1021/acscatal.5b00808 · Cited by 287
Yang, W., Justin Gooding, J., & Brynn Hibbert, D. (2001) · Journal of Electroanalytical Chemistry · doi:10.1016/s0022-0728(01)00649-0 · Cited by 274
Wang, Y., Laborda, E., Ward, K. R., Tschulik, K., & Compton, R. G. (2013) · Nanoscale · doi:10.1039/c3nr02340k · Cited by 37
Metadata
- Authors
- Hoogvliet, J. C., Dijksma, M., Kamp, B., & van Bennekom, W. P.
- Venue
- Analytical Chemistry
- Publisher
- American Chemical Society (ACS)
- Published
- 2000-03-24
- Volume
- 72
- Issue
- 9
- Pages
- 2016-2021
- ISSN
- 0003-2700 (ISSN-L)
- 1520-6882
- OpenAlex
- W2050137045
- Cited by
- 283
- References
- 8
- FWCI
- 4.33
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.