The DOI matches its Crossref record; 25 of the 25 references it cites were found in a registry or an index.
Thin-Film Deposition and Characterization of a Sn-Deficient Perovskite Derivative Cs2SnI6
Open accessAbstract
In this work, we describe details of a two-step deposition approach that enables the preparation of continuous and well-structured thin films of Cs 2 SnI 6, which is a one-half Sn-deficient 0-D perovskite derivative (i.e., the compound can also be written as CsSn 0.5 I 3, with a structure consisting of isolated SnI 6 4– octahedra). The films were characterized using powder X-ray diffraction (PXRD), scanning electron microscopy (SEM), thermogravimetric analysis (TGA), UV–vis spectroscopy, photoluminescence (PL), photoelectron spectroscopy (UPS, IPES, XPS), and Hall effect measurements. UV–vis and PL measurements indicate that the obtained Cs 2 SnI 6 film is a semiconductor with a band gap of 1.6 eV. This band gap was further confirmed by the UPS and IPES spectra, which were well reproduced by the calculated density of states with the HSE hybrid functional. The Cs 2 SnI 6 films exhibited n -type conduction with a carrier density of 6(1) × 10 16 cm –3 and mobility of 2.9(3) cm 2 /V·s. While the computationally derived band structure for Cs 2 SnI 6 shows significant dispersion along several directions in the Brillouin zone near the band edges, the valence band is relatively flat along the Γ–X direction, indicative of a more limited hole minority carrier mobility compared to analogous values for the electrons. The ionization potential ( IP ) and electron affinity ( EA ) were determined to be 6.4 and 4.8 eV, respectively. The Cs 2 SnI 6 films show some enhanced stability under ambient air, compared to methylammonium lead(II) iodide perovskite films stored under similar conditions; however, the films do decompose slowly, yielding a CsI impurity. These findings are discussed in the context of suitability of Cs 2 SnI 6 for photovoltaic and related optoelectronic applications.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Efficient iterative schemes for ab initio total-energy calculations using a plane-wave basis set
Kresse, G., & Furthmüller, J. (1996) · Physical Review B · doi:10.1103/physrevb.54.11169 · Cited by 123,652
Projector augmented-wave method
Blöchl, P. E. (1994) · Physical Review B · doi:10.1103/physrevb.50.17953 · Cited by 92,732
Hybrid functionals based on a screened Coulomb potential
Heyd, J., Scuseria, G. E., & Ernzerhof, M. (2003) · The Journal of Chemical Physics · doi:10.1063/1.1564060 · Cited by 19,629
High-performance photovoltaic perovskite layers fabricated through intramolecular exchange
Yang, W. S., Noh, J. H., Jeon, N. J., Kim, Y. C., Ryu, S., Seo, J., & Seok, S. I. (2015) · Science · doi:10.1126/science.aaa9272 · Cited by 6,251
Electron-hole diffusion lengths > 175 μm in solution-grown CH 3 NH 3 PbI 3 single crystals
Dong, Q., Fang, Y., Shao, Y., Mulligan, P., Qiu, J., Cao, L., & Huang, J. (2015) · Science · doi:10.1126/science.aaa5760 · Cited by 5,643
Stoumpos, C. C., Malliakas, C. D., & Kanatzidis, M. G. (2013) · Inorganic Chemistry · doi:10.1021/ic401215x · Cited by 5,416
A hole-conductor–free, fully printable mesoscopic perovskite solar cell with high stability
Mei, A., Li, X., Liu, L., Ku, Z., Liu, T., Rong, Y., Xu, M., Hu, M., Chen, J., Yang, Y., et al. (2014) · Science · doi:10.1126/science.1254763 · Cited by 3,043
Lead-free solid-state organic–inorganic halide perovskite solar cells
Hao, F., Stoumpos, C. C., Cao, D. H., Chang, R. P. H., & Kanatzidis, M. G. (2014) · Nature Photonics · doi:10.1038/nphoton.2014.82 · Cited by 3,026
Efficient and stable large-area perovskite solar cells with inorganic charge extraction layers
Chen, W., Wu, Y., Yue, Y., Liu, J., Zhang, W., Yang, X., Chen, H., Bi, E., Ashraful, I., Grätzel, M., et al. (2015) · Science · doi:10.1126/science.aad1015 · Cited by 2,279
The light and shade of perovskite solar cells
Grätzel, M. (2014) · Nature Materials · doi:10.1038/nmat4065 · Cited by 2,258
Intrinsic Thermal Instability of Methylammonium Lead Trihalide Perovskite
Conings, B., Drijkoningen, J., Gauquelin, N., Babayigit, A., D'Haen, J., D'Olieslaeger, L., Ethirajan, A., Verbeeck, J., Manca, J., Mosconi, E., et al. (2015) · Advanced Energy Materials · doi:10.1002/aenm.201500477 · Cited by 2,234
A Layered Hybrid Perovskite Solar‐Cell Absorber with Enhanced Moisture Stability
Smith, I. C., Hoke, E. T., Solis‐Ibarra, D., McGehee, M. D., & Karunadasa, H. I. (2014) · Angewandte Chemie International Edition · doi:10.1002/anie.201406466 · Cited by 2,011
Habisreutinger, S. N., Leijtens, T., Eperon, G. E., Stranks, S. D., Nicholas, R. J., & Snaith, H. J. (2014) · Nano Letters · doi:10.1021/nl501982b · Cited by 1,210
Chung, I., Song, J.-H., Im, J., Androulakis, J., Malliakas, C. D., Li, H., Freeman, A. J., Kenney, J. T., & Kanatzidis, M. G. (2012) · Journal of the American Chemical Society · doi:10.1021/ja301539s · Cited by 1,203
Paier, J., Hirschl, R., Marsman, M., & Kresse, G. (2005) · The Journal of Chemical Physics · doi:10.1063/1.1926272 · Cited by 1,051
Templating and structural engineering in organic–inorganic perovskites
Mitzi, D. B. (2001) · Journal of the Chemical Society, Dalton Transactions · doi:10.1039/b007070j · Cited by 945
Self-citationBrandt, R. E., Stevanović, V., Ginley, D. S., & Buonassisi, T. (2015) · MRS Communications · doi:10.1557/mrc.2015.26 · Cited by 817
Thin-Film Preparation and Characterization of Cs3Sb2I9: A Lead-Free Layered Perovskite Semiconductor
Saparov, B., Hong, F., Sun, J.-P., Duan, H.-S., Meng, W., Cameron, S., Hill, I. G., Yan, Y., & Mitzi, D. B. (2015) · Chemistry of Materials · doi:10.1021/acs.chemmater.5b01989 · Cited by 812
Self-citationHodes, G. (2013) · Science · doi:10.1126/science.1245473 · Cited by 805
Moisture assisted perovskite film growth for high performance solar cells
You, J., Yang, Y. (., Hong, Z., Song, T.-B., Meng, L., Liu, Y., Jiang, C., Zhou, H., Chang, W.-H., Li, G., et al. (2014) · Applied Physics Letters · doi:10.1063/1.4901510 · Cited by 786
Lee, B., Stoumpos, C. C., Zhou, N., Hao, F., Malliakas, C., Yeh, C.-Y., Marks, T. J., Kanatzidis, M. G., & Chang, R. P. H. (2014) · Journal of the American Chemical Society · doi:10.1021/ja508464w · Cited by 721
Interface energetics in organo-metal halide perovskite-based photovoltaic cells
Schulz, P., Edri, E., Kirmayer, S., Hodes, G., Cahen, D., & Kahn, A. (2014) · Energy & Environmental Science · doi:10.1039/c4ee00168k · Cited by 710
Lehner, A. J., Fabini, D. H., Evans, H. A., Hébert, C.-A., Smock, S. R., Hu, J., Wang, H., Zwanziger, J. W., Chabinyc, M. L., & Seshadri, R. (2015) · Chemistry of Materials · doi:10.1021/acs.chemmater.5b03147 · Cited by 507
Electrical Properties of n -Type CdTe
Segall, B., Lorenz, M., & Halsted, R. E. (1963) · Physical Review · doi:10.1103/physrev.129.2471 · Cited by 224
Ligand-Hole in [SnI6] Unit and Origin of Band Gap in Photovoltaic Perovskite Variant Cs2SnI6
Xiao, Z., Lei, H., Zhang, X., Zhou, Y., Hosono, H., & Kamiya, T. (2015) · Bulletin of the Chemical Society of Japan · doi:10.1246/bcsj.20150110 · Cited by 167
Self-citation
Cited by
Luminescent zero-dimensional organic metal halide hybrids with near-unity quantum efficiency
Zhou, C., Lin, H., Tian, Y., Yuan, Z., Clark, R., Chen, B., van de Burgt, L. J., Wang, J. C., Zhou, Y., Hanson, K., et al. (2018) · Chemical Science · doi:10.1039/c7sc04539e · Cited by 657
Synthetic Approaches for Halide Perovskite Thin Films
Dunlap-Shohl, W. A., Zhou, Y., Padture, N. P., & Mitzi, D. B. (2019) · Chemical Reviews · doi:10.1021/acs.chemrev.8b00318 · Cited by 631
Self-citation“Unleaded” Perovskites: Status Quo and Future Prospects of Tin‐Based Perovskite Solar Cells
Ke, W., Stoumpos, C. C., & Kanatzidis, M. G. (2019) · Advanced Materials · doi:10.1002/adma.201803230 · Cited by 533
Rational Design of Halide Double Perovskites for Optoelectronic Applications
Zhao, X.-G., Yang, D., Ren, J.-C., Sun, Y., Xiao, Z., & Zhang, L. (2018) · Joule · doi:10.1016/j.joule.2018.06.017 · Cited by 508
Self-citationLyu, M., Yun, J., Chen, P., Hao, M., & Wang, L. (2017) · Advanced Energy Materials · doi:10.1002/aenm.201602512 · Cited by 432
Metadata
- Authors
- Saparov, B., Sun, J.-P., Meng, W., Xiao, Z., Duan, H.-S., Gunawan, O., Shin, D., Hill, I. G., Yan, Y., & Mitzi, D. B.
- Venue
- Chemistry of Materials
- Publisher
- American Chemical Society (ACS)
- Published
- 2016-03-22
- Volume
- 28
- Issue
- 7
- Pages
- 2315-2322
- ISSN
- 0897-4756 (ISSN-L)
- 1520-5002
- OpenAlex
- W2295658443
- Cited by
- 434
- References
- 25
- FWCI
- 19.51
- Type
- journal article
- Language
- en
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.