CoChat

Low-Temperature Electrochemical Upgrading of Bio-oils Using Polymer Electrolyte Membranes

Lister, Tedd E., Diaz, Luis A., Lilga, Michael A., Padmaperuma, Asanga B., Lin, YuPo, Palakkal, Varada Menon, Arges, Christopher G. · 2018 · Energy & Fuels
Cited by 54

The DOI matches its Crossref record; 2 of the 2 references it cites were found in a registry or an index.

Abstract

While bio-oil-derived fuels hold much promise as a replacement for petroleum, transformation of the highly oxygenated mixture has proven challenging. In particular, bio-oils are reactive and difficult to upgrade through catalytic pyrolysis. To reach a stabilized product capable of deep deoxygenation at elevated pressure and temperature, conversion or separation of reactive groups is required. This paper describes an electrochemical process for stabilization and upgrading of bio-oils prior to hydrotreating at high pressure and temperature. This electrolytic process uses a three-compartment cell designed to hydrogenate reactive carbonyl components while separating small acid molecules, such as acetic and formic acids, which act as catalysts for condensation reactions and consume hydrogen gas to produce low-value gases in hydrotreating. To avoid conductivity issues, electrodes are appended to anion- and cation-exchange membranes. The cell was tested using a mixed acetic acid and formic acid surrogate fed to the cathode compartment, where the decrease in the concentration followed the applied charge to the cell. Experiments performed using pine pyrolysis oil demonstrated a significant reduction in the total acid number (TAN), an increase in pH from 2.6 to over 4, and a modest reduction of the carbonyl concentration. Analysis showed the reduction in TAN was primarily due to removal of carboxylic compounds. Experiments observed a decrease in the reactive carbonyl (aldehydes and ketones) concentration that followed applied charge. The results with the newly devised reactor show promise for the electrochemical route for upgrading bio-oils, but significant improvements in TAN removal and carbonyl conversion are needed. Given the distributed nature of biomass, an electrochemical process paired with pyrolysis could be used to densify and stabilize an oil product near the source. The densified liquid could then be shipped to centralized refineries for final upgrading to fuel and/or chemical products.

Overview

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1021/acs.energyfuels.8b00134

Cites

2 of 2 references verified0 citation errors · 0 not checkable

Statistics

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Cited by

See all 54

Metadata

Authors
Lister, T. E., Diaz, L. A., Lilga, M. A., Padmaperuma, A. B., Lin, Y., Palakkal, V. M., & Arges, C. G.
Venue
Energy & Fuels
Published
2018-04-09
Volume
32
Issue
5
Pages
5944-5950
ISSN
  • 0887-0624 (ISSN-L)
  • 1520-5029
OpenAlex
W2797171420
Cited by
54
References
2
FWCI
2.83
Type
journal article
Language
en
Open access
closed

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.