The DOI matches its Crossref record; 27 of the 27 references it cites were found in a registry or an index.
Improved Dielectric Properties and Energy Storage Density of Poly(vinylidene fluoride-co-hexafluoropropylene) Nanocomposite with Hydantoin Epoxy Resin Coated BaTiO3
Abstract
Energy storage materials are urgently demanded in modern electric power supply and renewable energy systems. The introduction of inorganic fillers to polymer matrix represents a promising avenue for the development of high energy density storage materials, which combines the high dielectric constant of inorganic fillers with supernal dielectric strength of polymer matrix. However, agglomeration and phase separation of inorganic fillers in the polymer matrix remain the key barriers to promoting the practical applications of the composites for energy storage. Here, we developed a low-cost and environmentally friendly route to modifying BaTiO3 (BT) nanoparticles by a kind of water-soluble hydantoin epoxy resin. The modified BT nanoparticles exhibited homogeneous dispersion in the ferroelectric polymer poly(vinylidene fluoride-co-hexafluoropropylene) (P(VDF-HFP)) matrix and strong interfacial adhesion with the polymer matrix. The dielectric constants of the nanocomposites increased significantly with the increase of the coated BT loading, while the dielectric loss of the nanocomposites was still as low as that of the pure P(VDF-HFP). The energy storage density of the nanocomposites was largely enhanced with the coated BT loading at the same electric field. The nanocomposite with 20 vol % BT exhibited an estimated maximum energy density of 8.13 J cm(-3), which was much higher than that of pure P(VDF-HFP) and other dielectric polymers. The findings of this research could provide a feasible approach to produce high energy density materials for practical application in energy storage.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Atom Transfer Radical Polymerization
Matyjaszewski, K., & Xia, J. (2001) · Chemical Reviews · doi:10.1021/cr940534g · Cited by 7,654
Wang, J.-S., & Matyjaszewski, K. (1995) · Journal of the American Chemical Society · doi:10.1021/ja00125a035 · Cited by 4,622
Room-temperature stationary sodium-ion batteries for large-scale electric energy storage
Pan, H., Hu, Y.-S., & Chen, L. (2013) · Energy & Environmental Science · doi:10.1039/c3ee40847g · Cited by 3,319
A Dielectric Polymer with High Electric Energy Density and Fast Discharge Speed
Chu, B., Zhou, X., Ren, K., Neese, B., Lin, M., Wang, Q., Bauer, F., & Zhang, Q. M. (2006) · Science · doi:10.1126/science.1127798 · Cited by 2,453
Graphene based new energy materials
Sun, Y., Wu, Q., & Shi, G. (2011) · Energy & Environmental Science · doi:10.1039/c0ee00683a · Cited by 1,928
An all-organic composite actuator material with a high dielectric constant
Zhang, Q. M., Li, H., Poh, M., Xia, F., Cheng, Z.-Y., Xu, H., & Huang, C. (2002) · Nature · doi:10.1038/nature01021 · Cited by 1,073
Polymer nanocomposite dielectrics - the role of the interface
Roy, M., Nelson, J. K., MacCrone, R. K., Schadler, L. S., Reed, C. W., Keefe, R. J., & Zenger, W. (2005) · IEEE Transactions on Dielectrics and Electrical Insulation · doi:10.1109/tdei.2005.1511089 · Cited by 857
Yi, P., Khoshmanesh, K., Chrimes, A. F., Campbell, J. L., Ghorbani, K., Nahavandi, S., Rosengarten, G., & Kalantar‐Zadeh, K. (2013) · Advanced Energy Materials · doi:10.1002/aenm.201300537 · Cited by 849
High Energy Density Nanocomposites Based on Surface-Modified BaTiO3 and a Ferroelectric Polymer
Kim, P., Doss, N. M., Tillotson, J. P., Hotchkiss, P. J., Pan, M.-J., Marder, S. R., Li, J., Calame, J. P., & Perry, J. W. (2009) · ACS Nano · doi:10.1021/nn9006412 · Cited by 818
Interfaces: nanometric dielectrics
Lewis, T. J. (2005) · Journal of Physics D: Applied Physics · doi:10.1088/0022-3727/38/2/004 · Cited by 460
Role of Interface on the Thermal Conductivity of Highly Filled Dielectric Epoxy/AlN Composites
Huang, X., Iizuka, T., Jiang, P., Ohki, Y., & Tanaka, T. (2012) · The Journal of Physical Chemistry C · doi:10.1021/jp3026545 · Cited by 455
Huang, F. (2014) · Materials and Energy/Materials and energy · doi:10.1142/9789814513289_0001 · Cited by 387
Li, Y., Huang, X., Hu, Z., Jiang, P., Li, S., & Tanaka, T. (2011) · ACS Applied Materials & Interfaces · doi:10.1021/am2010459 · Cited by 386
Xie, L., Huang, X., Wu, C., & Jiang, P. (2011) · Journal of Materials Chemistry · doi:10.1039/c0jm04574h · Cited by 378
Li, J., Claude, J., Norena-Franco, L. E., Seok, S. I., & Wang, Q. (2008) · Chemistry of Materials · doi:10.1021/cm8021648 · Cited by 360
Hierarchical electrospun nanofibers for energy harvesting, production and environmental remediation
Kumar, P. S., Sundaramurthy, J., Sundarrajan, S., Babu, V. J., Singh, G., Allakhverdiev, S. I., & Ramakrishna, S. (2014) · Energy Environ. Sci. · doi:10.1039/c4ee00612g · Cited by 322
Wang, D., Bao, Y., Zha, J.-W., Zhao, J., Dang, Z.-M., & Hu, G.-H. (2012) · ACS Applied Materials & Interfaces · doi:10.1021/am3018652 · Cited by 308
The effect of grain and particle size on the microwave properties of barium titanate (BaTiO3)
McNeal, M. P., Jang, S.-J., & Newnham, R. E. (1998) · Journal of Applied Physics · doi:10.1063/1.367097 · Cited by 286
A graphite nanoplatelet/epoxy composite with high dielectric constant and high thermal conductivity
Min, C., Yu, D., Cao, J., Wang, G., & Feng, L. (2013) · Carbon · doi:10.1016/j.carbon.2012.12.017 · Cited by 261
Hao, X., Zhai, J., & Yao, X. (2009) · Journal of the American Ceramic Society · doi:10.1111/j.1551-2916.2009.03015.x · Cited by 255
Xie, L., Huang, X., Huang, Y., Yang, K., & Jiang, P. (2013) · The Journal of Physical Chemistry C · doi:10.1021/jp407340n · Cited by 247
AGET ATRP in the Presence of Air in Miniemulsion and in Bulk
Min, K., Jakubowski, W., & Matyjaszewski, K. (2006) · Macromolecular Rapid Communications · doi:10.1002/marc.200600060 · Cited by 235
Aqueous Processing of Low-Band-Gap Polymer Solar Cells Using Roll-to-Roll Methods
Andersen, T. R., Larsen-Olsen, T. T., Andreasen, B., Böttiger, A. P. L., Carlé, J. E., Helgesen, M., Bundgaard, E., Norrman, K., Andreasen, J. W., Jørgensen, M., et al. (2011) · ACS Nano · doi:10.1021/nn200933r · Cited by 227
Yang, K., Huang, X., Zhu, M., Xie, L., Tanaka, T., & Jiang, P. (2014) · ACS Applied Materials & Interfaces · doi:10.1021/am4048267 · Cited by 184
Yang, K., Huang, X., Fang, L., He, J., & Jiang, P. (2014) · Nanoscale · doi:10.1039/c4nr03957b · Cited by 154
Guo, N., DiBenedetto, S. A., Kwon, D., Wang, L., Russell, M. T., Lanagan, M. T., Facchetti, A. F., & Marks, T. J. (2007) · Journal of the American Chemical Society · doi:10.1021/ja066965l · Cited by 115
Calame, J. P. (2011) · Journal of Applied Physics · doi:10.1063/1.3633763 · Cited by 15
Cited by
Luo, S., Shen, Y., Yu, S., Wan, Y., Liao, W.-H., Sun, R., & Wong, C.-P. (2017) · Energy & Environmental Science · doi:10.1039/c6ee03190k · Cited by 313
Pan, Z., Yao, L., Zhai, J., Fu, D., Shen, B., & Wang, H. (2017) · ACS Applied Materials & Interfaces · doi:10.1021/acsami.6b13663 · Cited by 267
Metadata
- Authors
- Luo, H., Zhang, D., Jiang, C., Yuan, X., Chen, C., & Zhou, K.
- Venue
- ACS Applied Materials & Interfaces
- Publisher
- American Chemical Society (ACS)
- Published
- 2015-04-13
- Volume
- 7
- Issue
- 15
- Pages
- 8061-8069
- ISSN
- 1944-8244 (ISSN-L)
- 1944-8252
- OpenAlex
- W2319500417
- Cited by
- 286
- References
- 27
- FWCI
- 17.61
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.
