The DOI matches its Crossref record.
The effect of grain and particle size on the microwave properties of barium titanate (BaTiO3)
Abstract
The use of ferroelectric ceramics and thin films in microwave devices requires that they possess frequency-stable, low-loss dielectric properties. At microwave frequencies, ferroelectric polycrystalline ceramic materials typically exhibit a large dielectric relaxation, characterized by a decrease in the relative permittivity (εr) and a peak in the dielectric loss (tan δ). Mechanisms attributed to the relaxation phenomenon include piezoelectric resonance of grains and domains, inertia to domain wall movement, and the emission of gigahertz shear waves from ferroelastic domain walls. As a result, the relaxation phenomenon appears to be intimately linked to the domain state of the ferroelectric. The domain state of a ferroelectric is, in part, dependent upon its microstructure. In this study, the microwave dielectric properties of ferroelectric barium titanate were measured as a function of grain and particle size. Polycrystalline ceramic ferroelectric BaTiO3 (having average grain sizes of 14.4, 2.14, and 0.26 μm) and BaTiO3 powder-polymer matrix composites (possessing average particle sizes of 1.33 μm, 0.19 μm, and ∼66 nm) were employed. The composite samples were used to decouple resonances between adjacent grains as well as reduce the three dimensional clamping experienced by grains in ceramic. Characterization studies were performed to determine the effects of grain size and particle size on the crystal structure and degree of tetragonality. Microwave dielectric measurements through 6 GHz were carried out using lumped impedance, cavity perturbation, and post resonance experiments. All samples exhibited evidence of relaxation or resonance phenomena in their dielectric spectra. Except for the 0.26 μm grain size ceramics and the 66 nm particle size composites, all other samples exhibited relaxation in their dielectric spectra. The 0.26 μm ceramic and 66 nm composite showed evidence of resonance in their dielectric spectra. This work clearly shows the potential to tune the microwave properties of ferroelectrics through control of grain/particle size and the domain state. In general, relaxation frequencies increased and loss tangents decreased with decreasing grain/particle size. The relaxation mechanisms were identified and correlated with the material characterization results and theoretical models. Relaxation frequencies were generally governed by the smallest resonant width, i.e., the domain width.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Dielectric relaxation, resonance and scaling behaviors in Sr3Co2Fe24O41 hexaferrite
Tang, R., Jiang, C., Qian, W., Jian, J., Zhang, X., Wang, H., & Yang, H. (2015) · Scientific Reports · doi:10.1038/srep13645 · Cited by 258
Chelladurai, D., Kohli, M., Winiger, J., Moor, D., Messner, A., Fedoryshyn, Y., Eleraky, M., Liu, Y., Wang, H., & Leuthold, J. (2025) · Nature Materials · doi:10.1038/s41563-025-02158-1 · Cited by 73
Metadata
- Authors
- McNeal, M. P., Jang, S.-J., & Newnham, R. E.
- Venue
- Journal of Applied Physics
- Publisher
- AIP Publishing
- Published
- 1998-03-15
- Volume
- 83
- Issue
- 6
- Pages
- 3288-3297
- ISSN
- 0021-8979 (ISSN-L)
- 1089-7550
- OpenAlex
- W2061014297
- Cited by
- 286
- References
- 0
- FWCI
- 10.70
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: The effect of grain and particle size on the microwave properties of barium titanate (BaTiO3). https://app.cochat.ai/papers/10.1063/1.367097
- The paper
- McNeal, M. P., Jang, S.-J., & Newnham, R. E. (1998). The effect of grain and particle size on the microwave properties of barium titanate (BaTiO3). Journal of Applied Physics. https://doi.org/10.1063/1.367097
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.