The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.
Enhancing the Thermal and Upper Voltage Performance of Ni-Rich Cathode Material by a Homogeneous and Facile Coating Method: Spray-Drying Coating with Nano-Al2O3
Abstract
The electrochemical performance of Ni-rich cathode material at high temperature (>50 °C) and upper voltage operation (>4.3 V) is a challenge for next-generation lithium-ion batteries (LIBs) because of the rapid capacity degradation over cycling. Here we report improved performance of LiNi0.8Co0.15Al0.05O2 materials via a LiAlO2 coating, which was prepared from a Ni0.80Co0.15Al0.05(OH)2 precursor by spray-drying coating with nano-Al2O3. Investigations by X-ray diffraction, scanning electron microscopy, energy-dispersive X-ray spectroscopy, and transmission electron microscopy revealed that an Al2O3 layer is uniformly distributed on the precursor and a LiAlO2 layer on the as-prepared cathode material. Such a coating shell acts as a scavenger to protect the cathode material from attack by HF and serious side reactions, which remarkably enhances the cycle performance at 55 °C and upper operating voltage (4.4 and 4.5 V). In particular, the sample with a 2% Al2O3 coating shows capacity retentions of 90.40%, 85.14%, 87.85%, and 81.1% after 150 cycles at a rate of 1.0C at room temperature, 55 °C, 4.4 V, and 4.5 V, respectively, which are significantly higher than those of the pristine one. This is mainly due to the significant improvement of the structural stability led by the effective coating technique, which could be extended to other cathode materials to obtain LIBs with enhanced safety and excellent cycling stability.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Thackeray, M. M., Wolverton, C., & Isaacs, E. D. (2012) · Energy & Environmental Science · doi:10.1039/c2ee21892e · Cited by 2,515
Cited by
Fast Charging of Lithium‐Ion Batteries: A Review of Materials Aspects
Weiss, M., Ruess, R., Kasnatscheew, J., Levartovsky, Y., Levy, N. R., Minnmann, P., Stolz, L., Waldmann, T., Wohlfahrt‐Mehrens, M., Aurbach, D., et al. (2021) · Advanced Energy Materials · doi:10.1002/aenm.202101126 · Cited by 1,055
Xia, Y., Zheng, J., Wang, C., & Gu, M. (2018) · Nano Energy · doi:10.1016/j.nanoen.2018.04.062 · Cited by 556
Oxygen Release Degradation in Li‐Ion Battery Cathode Materials: Mechanisms and Mitigating Approaches
Sharifi‐Asl, S., Lu, J., Amine, K., & Shahbazian‐Yassar, R. (2019) · Advanced Energy Materials · doi:10.1002/aenm.201900551 · Cited by 532
Du, H., Wang, Y., Kang, Y., Zhao, Y., Tian, Y., Wang, X., Tan, Y., Liang, Z., Wozny, J., Li, T., et al. (2024) · Advanced Materials · doi:10.1002/adma.202401482 · Cited by 376
Xu, G., Liu, X., Daali, A., Amine, R., Chen, Z., & Amine, K. (2020) · Advanced Functional Materials · doi:10.1002/adfm.202004748 · Cited by 313
Metadata
- Authors
- Du, K., Xie, H., Hu, G., Peng, Z., Cao, Y., & Yu, F.
- Venue
- ACS Applied Materials & Interfaces
- Publisher
- American Chemical Society (ACS)
- Published
- 2016-06-30
- Volume
- 8
- Issue
- 27
- Pages
- 17713-17720
- ISSN
- 1944-8244 (ISSN-L)
- 1944-8252
- OpenAlex
- W2464136238
- Cited by
- 168
- References
- 1
- FWCI
- 9.45
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Enhancing the Thermal and Upper Voltage Performance of Ni-Rich Cathode Material by a Homogeneous and Facile Coating Method: Spray-Drying Coating with Nano-Al2O3. https://app.cochat.ai/papers/10.1021/acsami.6b05629
- The paper
- Du, K., Xie, H., Hu, G., Peng, Z., Cao, Y., & Yu, F. (2016). Enhancing the Thermal and Upper Voltage Performance of Ni-Rich Cathode Material by a Homogeneous and Facile Coating Method: Spray-Drying Coating with Nano-Al2O3. ACS Applied Materials & Interfaces. https://doi.org/10.1021/acsami.6b05629
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.