The DOI matches its Crossref record; 28 of the 28 references it cites were found in a registry or an index.
A Fast Method to Produce Strong NFC Films as a Platform for Barrier and Functional Materials
Open accessAbstract
In this study, we present a rapid method to prepare robust, solvent-resistant, nanofibrillated cellulose (NFC) films that can be further surface-modified for functionality. The oxygen, water vapor, and grease barrier properties of the films were measured, and in addition, mechanical properties in the dry and wet state and solvent resistance were evaluated. The pure unmodified NFC films were good barriers for oxygen gas and grease. At a relative humidity below 65%, oxygen permeability of the pure and unmodified NFC films was below 0.6 cm(3) μm m(-2) d(-1) kPa(-1), and no grease penetrated the film. However, the largest advantage of these films was their resistance to various solvents, such as water, methanol, toluene, and dimethylacetamide. Although they absorbed a substantial amount of solvent, the films could still be handled after 24 h of solvent soaking. Hot-pressing was introduced as a convenient method to not only increase the drying speed of the films but also enhance the robustness of the films. The wet strength of the films increased due to the pressing. Thus, they can be chemically or physically modified through adsorption or direct chemical reaction in both aqueous and organic solvents. Through these modifications, the properties of the film can be enhanced, introducing, for example, functionality, hydrophobicity, or bioactivity. Herein, a simple method using surface coating with wax to improve hydrophobicity and oxygen barrier properties at very high humidity is described. Through this modification, the oxygen permeability decreased further and was below 17 cm(3) μm m(-2) d(-1) kPa(-1) even at 97.4% RH, and the water vapor transmission rate decreased from 600 to 40 g/m(2) day. The wax treatment did not deteriorate the dry strength of the film. Possible reasons for the unique properties are discussed. The developed robust NFC films can be used as a generic, environmentally sustainable platform for functional materials.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Cellulose nanomaterials review: structure, properties and nanocomposites
Moon, R. J., Martini, A., Nairn, J., Simonsen, J., & Youngblood, J. (2011) · Chemical Society Reviews · doi:10.1039/c0cs00108b · Cited by 6,756
Cellulose nanofibers prepared by TEMPO-mediated oxidation of native cellulose
Saito, T., Kimura, S., Nishiyama, Y., & Isogai, A. (2007) · Biomacromolecules · doi:10.1021/bm0703970 · Cited by 2,493
Pääkkö, M., Ankerfors, M., Kosonen, H., Nykänen, A., Ahola, S., Österberg, M., Ruokolainen, J., Laine, J., Larsson, P. T., Ikkala, O., et al. (2007) · Biomacromolecules · doi:10.1021/bm061215p · Cited by 1,962
Self-citationLavoine, N., Desloges, I., Dufresne, A., & Bras, J. (2012) · Carbohydrate Polymers · doi:10.1016/j.carbpol.2012.05.026 · Cited by 1,791
Cellulose Nanopaper Structures of High Toughness
Henriksson, M., Berglund, L. A., Isaksson, P., Lindström, T., & Nishino, T. (2008) · Biomacromolecules · doi:10.1021/bm800038n · Cited by 1,299
Optically Transparent Nanofiber Paper
Nogi, M., Iwamoto, S., Nakagaito, A. N., & Yano, H. (2009) · Advanced Materials · doi:10.1002/adma.200803174 · Cited by 1,074
Wågberg, L., Decher, G., Norgren, M., Lindström, T., Ankerfors, M., & Axnäs, K. (2008) · Langmuir · doi:10.1021/la702481v · Cited by 867
Recent innovations in barrier technologies for plastic packaging—a review
Lange, J., & Wyser, Y. (2003) · Packaging Technology and Science · doi:10.1002/pts.621 · Cited by 842
Oxygen and oil barrier properties of microfibrillated cellulose films and coatings
Aulin, C., Gällstedt, M., & Lindström, T. (2010) · Cellulose · doi:10.1007/s10570-009-9393-y · Cited by 749
Potential of biobased materials for food packaging
Petersen, K., Væggemose Nielsen, P., Bertelsen, G., Lawther, M., Olsen, M. B., Nilsson, N. H., & Mortensen, G. (1999) · Trends in Food Science & Technology · doi:10.1016/s0924-2244(99)00019-9 · Cited by 696
Cited by
Nanocellulose, a Versatile Green Platform: From Biosources to Materials and Their Applications
Thomas, B., Raj, M. C., B, A. K., H, R. M., Joy, J., Moores, A., Drisko, G. L., & Sanchez, C. (2018) · Chemical Reviews · doi:10.1021/acs.chemrev.7b00627 · Cited by 1,714
Production of cellulose nanofibrils: A review of recent advances
Nechyporchuk, O., Belgacem, M. N., & Bras, J. (2016) · Industrial Crops and Products · doi:10.1016/j.indcrop.2016.02.016 · Cited by 1,687
Wood-Derived Materials for Green Electronics, Biological Devices, and Energy Applications
Zhu, H., Luo, W., Ciesielski, P. N., Fang, Z., Zhu, J. Y., Henriksson, G., Himmel, M. E., & Hu, L. (2016) · Chemical Reviews · doi:10.1021/acs.chemrev.6b00225 · Cited by 1,532
Moisture and Oxygen Barrier Properties of Cellulose Nanomaterial-Based Films
Wang, J., Gardner, D. J., Stark, N. M., Bousfield, D. W., Tajvidi, M., & Cai, Z. (2018) · ACS Sustainable Chemistry & Engineering · doi:10.1021/acssuschemeng.7b03523 · Cited by 675
Wood-based nanotechnologies toward sustainability
Jiang, F., Li, T., Li, Y., Zhang, Y., Gong, A., Dai, J., Hitz, E., Luo, W., & Hu, L. (2018) · Advanced Materials · doi:10.1002/adma.201703453 · Cited by 599
Transparent paper: fabrications, properties, and device applications
Zhu, H., Fang, Z., Preston, C., Li, Y., & Hu, L. (2014) · Energy Environ. Sci. · doi:10.1039/c3ee43024c · Cited by 550
Nanocellulose in Thin Films, Coatings, and Plies for Packaging Applications: A Review
Hubbe, M. A., Ferrer, A., Tyagi, P., Yin, Y., Salas, C., Pal, L., & Rojas, O. J. (2017) · BioResources · doi:10.15376/biores.12.1.2143-2233 · Cited by 508
Understanding Nanocellulose–Water Interactions: Turning a Detriment into an Asset
Solhi, L., Guccini, V., Heise, K., Solala, I., Niinivaara, E., Xu, W., Mihhels, K., Kröger, M., Meng, Z., Wohlert, J., et al. (2023) · Chemical Reviews · doi:10.1021/acs.chemrev.2c00611 · Cited by 506
Cellulose Nanopaper: Fabrication, Functionalization, and Applications
Liu, W., Liu, K., Du, H., Zheng, T., Zhang, N., Xu, T., Pang, B., Zhang, X., Si, C., & Zhang, K. (2022) · Nano-Micro Letters · doi:10.1007/s40820-022-00849-x · Cited by 435
Osong, S. H., Norgren, S., & Engstrand, P. (2016) · Cellulose · doi:10.1007/s10570-015-0798-5 · Cited by 434
Nanocellulose in packaging: Advances in barrier layer technologies
Ferrer, A., Pal, L., & Hubbe, M. (2017) · Industrial Crops and Products · doi:10.1016/j.indcrop.2016.11.012 · Cited by 382
High performance green barriers based on nanocellulose
Nair, S. S., Zhu, J., Deng, Y., & Ragauskas, A. J. (2014) · Sustainable Chemical Processes · doi:10.1186/s40508-014-0023-0 · Cited by 368
Strong, Ductile, and Waterproof Cellulose Nanofibril Composite Films with Colloidal Lignin Particles
Farooq, M., Zou, T., Riviere, G., Sipponen, M. H., & Österberg, M. (2019) · Biomacromolecules · doi:10.1021/acs.biomac.8b01364 · Cited by 337
Self-citationCellulose Nanofibril Film as a Piezoelectric Sensor Material
Rajala, S., Siponkoski, T., Sarlin, E., Mettänen, M., Vuoriluoto, M., Pammo, A., Juuti, J., Rojas, O. J., Franssila, S., & Tuukkanen, S. (2016) · ACS Applied Materials & Interfaces · doi:10.1021/acsami.6b03597 · Cited by 320
Benítez, A. J., Torres-Rendon, J., Poutanen, M., & Walther, A. (2013) · Biomacromolecules · doi:10.1021/bm401451m · Cited by 287
Nanocellulose Processing Properties and Potential Applications
Dufresne, A. (2019) · Current Forestry Reports · doi:10.1007/s40725-019-00088-1 · Cited by 279
Tardy, B. L., Mattos, B. D., Otoni, C. G., Beaumont, M., Majoinen, J., Kämäräinen, T., & Rojas, O. J. (2021) · Chemical Reviews · doi:10.1021/acs.chemrev.0c01333 · Cited by 267
Preparation of Double Pickering Emulsions Stabilized by Chemically Tailored Nanocelluloses
Cunha, A. G., Mougel, J.-B., Cathala, B., Berglund, L. A., & Capron, I. (2014) · Langmuir · doi:10.1021/la5017577 · Cited by 256
Ductile nanocellulose-based films with high stretchability and tear resistance
Spoljaric, S., Salminen, A., Luong, N. D., & Seppälä, J. (2015) · European Polymer Journal · doi:10.1016/j.eurpolymj.2015.06.019 · Cited by 40
Self-citation
Metadata
- Authors
- Österberg, M., Vartiainen, J., Lucenius, J., Hippi, U., Seppälä, J., Serimaa, R., & Laine, J.
- Venue
- ACS Applied Materials & Interfaces
- Publisher
- American Chemical Society (ACS)
- Published
- 2013-05-15
- Volume
- 5
- Issue
- 11
- Pages
- 4640-4647
- ISSN
- 1944-8244 (ISSN-L)
- 1944-8252
- OpenAlex
- W2080071804
- Cited by
- 336
- References
- 28
- FWCI
- 8.75
- Type
- journal article
- Language
- en
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.