The DOI matches its Crossref record.
Mass-Transfer Properties of Microbubbles. 1. Experimental Studies
Abstract
Synthesis-gas fermentations have typically been gas-to-liquid mass-transfer-limited due to low solubilities of the gaseous substrates. A potential method to enhance mass-transfer rates is to sparge with microbubble dispersions. Mass-transfer coefficients for microbubble dispersions were measured in a bubble column. Oxygen microbubbles were formed in a dilute Tween 20 solution using a spinning disk apparatus. Axial dispersion coefficients measured for the bubble column ranged from 1.5 to 7.2 cm2/s and were essentially independent of flow rate. A laser-diffraction technique was used to determine the interfacial area per unit gas volume, a. The mass-transfer coefficient, KL, was determined by fitting a plug-flow model to the experimental, steady-state, liquid-phase oxygen-concentration profile. The KL values ranged from 2.9 x 10(-5) to 2.2 x 10(-4) m/s. Volumetric mass-transfer coefficients, KLa, for microbubbles with an average initial diameter of 60 microns ranged from 200 to 1800 h-1. Enhancement of mass transfer using microbubbles was demonstrated for a synthesis-gas fermentation. Butyribacterium methylotrophicum was grown in a continuous, stirred-tank reactor using a tangential filter for total cell recycle. The fermentation KLa values were 14 h-1 for conventional gas sparging through a stainless steel frit and 91 h-1 for microbubble sparging. The Power number of the microbubble generator was determined to be 0.036. Using this value, an incremental power-to-volume ratio to produce microbubbles for a B. methylotrophicum fermentation was estimated to be 0.01 kW/m3 of fermentation capacity.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Surfactants in microbiology and biotechnology: Part 2. Application aspects
Singh, A., Van Hamme, J. D., & Ward, O. P. (2007) · Biotechnology Advances · doi:10.1016/j.biotechadv.2006.10.004 · Cited by 757
Biomass-derived syngas fermentation into biofuels: Opportunities and challenges
Munasinghe, P. C., & Khanal, S. K. (2010) · Bioresource Technology · doi:10.1016/j.biortech.2009.12.098 · Cited by 559
Borden, M. A., & Longo, M. L. (2002) · Langmuir · doi:10.1021/la026082h · Cited by 340
Bioconversion of natural gas to liquid fuel: Opportunities and challenges
Fei, Q., Guarnieri, M. T., Tao, L., Laurens, L. M. L., Dowe, N., & Pienkos, P. T. (2014) · Biotechnology Advances · doi:10.1016/j.biotechadv.2014.03.011 · Cited by 305
Reactor Design Issues for Synthesis‐Gas Fermentations
Bredwell, M. D., Srivastava, P., & Worden, R. M. (1999) · Biotechnology Progress · doi:10.1021/bp990108m · Cited by 274
Self-citationBiological conversion of carbon monoxide: rich syngas or waste gases to bioethanol
Abubackar, H. N., Veiga, M. C., & Kennes (2011) · Biofuels Bioproducts and Biorefining · doi:10.1002/bbb.256 · Cited by 244
Metadata
- Authors
- Bredwell, M. D., & Worden, R. M.
- Venue
- Biotechnology Progress
- Publisher
- Wiley
- Published
- 1998-02-06
- Volume
- 14
- Issue
- 1
- Pages
- 31-38
- ISSN
- 1520-6033 (ISSN-L)
- 8756-7938
- OpenAlex
- W2024050640
- Cited by
- 183
- References
- 0
- FWCI
- 2.53
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.