The DOI matches its Crossref record; 18 of the 18 references it cites were found in a registry or an index.
Use of Epoxides in the Sol−Gel Synthesis of Porous Iron(III) Oxide Monoliths from Fe(III) Salts
Abstract
Iron oxide-based porous solids were prepared by a sol−gel process using Fe(III) salts in various solvents. It was observed that the addition of propylene oxide to Fe(III) solutions resulted in the formation of transparent red-brown monolithic gels. The resulting gels were converted to either xerogels by atmospheric drying or aerogels by supercritical extraction with CO 2 (l). Some of the dried materials were characterized by nitrogen adsorption and desorption analysis and transmission electron microscopy (TEM). The results of those analyses indicate that the materials have high surface areas (∼300−400 m 2 /g), pore sizes with mesoporic dimensions (2−23 nm), and a microstructure made up of 5−10 nm diameter clusters of iron(III) oxide. The dependence of both gel formation and its rate was studied by varying the epoxide/Fe(III) ratio, the Fe(III) precursor salt, amount of water (H 2 O/Fe(III)) present, and the solvent employed. All of these variables were shown to affect the rate of gel formation and provide a convenient control of this parameter. Finally, an investigation of the mechanism of Fe 2 O 3 gel formation was performed. Both pH and nuclear magnetic resonance (NMR) studies suggest that the added epoxide acts as an irreversible proton scavenger that induces the Fe(III) species to undergo hydrolysis and condensation to form an inorganic iron oxide framework. This method can be extended to prepare other transition- and main-group metal oxide materials.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Sol-gel chemistry of transition metal oxides
Livage, J., Henry, M., & Sanchez, C. (1988) · Progress in Solid State Chemistry · doi:10.1016/0079-6786(88)90005-2 · Cited by 2,323
Low-Temperature Oxidation of CO over Gold Supported on TiO2, α-Fe2O3, and Co3O4
Haruta, M., Tsubota, S., Kobayashi, T., Kageyama, H., Genet, M. J., & Delmon, B. (1993) · Journal of Catalysis · doi:10.1006/jcat.1993.1322 · Cited by 2,214
Hydrolysis of inorganic iron(III) salts
Flynn, C. M. (1984) · Chemical Reviews · doi:10.1021/cr00059a003 · Cited by 738
Micro-Raman investigation of iron oxide films and powders produced by sol-gel syntheses
Bersani, D., Lottici, P. P., & Montenero, A. (1999) · Journal of Raman Spectroscopy · doi:10.1002/(sici)1097-4555(199905)30:5<355::aid-jrs398>3.0.co;2-c · Cited by 523
Binuclear oxo-bridged iron(iii) complexes
Murray, K. S. (1974) · Coordination Chemistry Reviews · doi:10.1016/s0010-8545(00)80384-7 · Cited by 323
Characterization of Iron Oxide Nanoparticles in an Fe2O3−SiO2 Composite Prepared by a Sol−Gel Method
Ennas, G., Musinu, A., Piccaluga, G., Zedda, D., Gatteschi, D., Sangregorio, C., Stanger, J. L., Concas, G., & Spano, G. (1998) · Chemistry of Materials · doi:10.1021/cm970400u · Cited by 275
Structural and Magnetic Properties of Fe2O3 Nanoparticles Dispersed over a Silica Matrix
Cannas, C., Gatteschi, D., Musinu, A., Piccaluga, G., & Sangregorio, C. (1998) · The Journal of Physical Chemistry B · doi:10.1021/jp981355w · Cited by 232
Surface Characterization Study of Au/α-Fe2O3and Au/Co3O4Low-Temperature CO Oxidation Catalysts
Epling, W. S., Hoflund, G. B., Weaver, J. F., Tsubota, S., & Haruta, M. (1996) · The Journal of Physical Chemistry · doi:10.1021/jp960593t · Cited by 197
Preparation and characterization of nanocrystalline α-Fe2O3 by a sol-gel process
Liu, X. Q., Tao, S. W., & Shen, Y. S. (1997) · Sensors and Actuators B: Chemical · doi:10.1016/s0925-4005(97)80256-0 · Cited by 178
Dousma, J., & De Bruyn, P. L. (1976) · Journal of Colloid and Interface Science · doi:10.1016/0021-9797(76)90119-3 · Cited by 173
PUTTING THE 'NANO' INTO COMPOSITES
DAGANI, R. (1999) · Chemical & Engineering News · doi:10.1021/cen-v077n023.p025 · Cited by 137
Characterization of Nanocrystalline γ–Fe2O3Prepared by Wet Chemical Method
Ennas, G., Marongiu, G., Musinu, A., Falqui, A., Ballirano, P., & Caminiti, R. (1999) · Journal of materials research/Pratt's guide to venture capital sources · doi:10.1557/jmr.1999.0210 · Cited by 112
Structure of a Nanophase Iron Oxide Catalyst
Zhao, J., Huggins, F. E., Feng, Z., Lu, F., Shah, N., & HUFFMAN, G. P. (1993) · Journal of Catalysis · doi:10.1006/jcat.1993.1293 · Cited by 96
Hydrolysis of Iron(III)…Chaotic Olation Versus Nucleation
Schneider, W. F. (1984) · Comments on Inorganic Chemistry · doi:10.1080/02603598408078138 · Cited by 89
Synthesis of lanthanide and lanthanide-silicate aerogels
Tillotson, T. M., Sunderland, W. E., Thomas, I. M., & Hrubesh, L. W. (1994) · Journal of Sol-Gel Science and Technology · doi:10.1007/bf00486167 · Cited by 57
Self-citationItoh, H., Tabata, T., Kokitsu, M., Okazaki, N., Imizu, Y., & Tada, A. (1993) · Journal of the Ceramic Society of Japan · doi:10.2109/jcersj.101.1081 · Cited by 56
Chang, H., Chiou, C.-C., Chen, Y., & Sheen, S. R. (1997) · Journal of Solid State Chemistry · doi:10.1006/jssc.1996.7159 · Cited by 27
Kojima, K., Miyazaki, M., Mizukami, F., & Maeda, K. (1997) · Journal of Sol-Gel Science and Technology · doi:10.1007/bf02436821 · Cited by 25
Cited by
The Evolution of “sol-Gel” Chemistry as a Technique for Materials Synthesis
Danks, A. E., Hall, S. R., & Schnepp, Z. (2016) · Materials Horizons · doi:10.1039/c5mh00260e · Cited by 1,718
Sol–gel based materials for biomedical applications
Owens, G. J., Singh, R. K., Foroutan, F., Alqaysi, M., Han, C.-M., Mahapatra, C., Kim, H.-W., & Knowles, J. C. (2016) · Progress in Materials Science · doi:10.1016/j.pmatsci.2015.12.001 · Cited by 958
Metal-based reactive nanomaterials
Dreizin, E. L. (2009) · Progress in Energy and Combustion Science · doi:10.1016/j.pecs.2008.09.001 · Cited by 956
Organic Phase Syntheses of Magnetic Nanoparticles and Their Applications
Wu, L., Mendoza-Garcia, A., Li, Q., & Sun, S. (2016) · Chemical Reviews · doi:10.1021/acs.chemrev.5b00687 · Cited by 601
A Special Material or a New State of Matter: A Review and Reconsideration of the Aerogel
Du, A., Zhou, B., Zhang, Z., & Shen, J. (2013) · Materials · doi:10.3390/ma6030941 · Cited by 481
Metadata
- Authors
- Gash, A. E., Tillotson, T. M., Satcher, J. H., Poco, J. F., Hrubesh, L. W., & Simpson, R. L.
- Venue
- Chemistry of Materials
- Publisher
- American Chemical Society (ACS)
- Published
- 2001-02-23
- Volume
- 13
- Issue
- 3
- Pages
- 999-1007
- ISSN
- 0897-4756 (ISSN-L)
- 1520-5002
- OpenAlex
- W2033533848
- Cited by
- 520
- References
- 18
- FWCI
- 5.93
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.