CoChat

Nanoscale Metal Oxide Particles/Clusters as Chemical Reagents. Unique Surface Chemistry on Magnesium Oxide As Shown by Enhanced Adsorption of Acid Gases (Sulfur Dioxide and Carbon Dioxide) and Pressure Dependence

The DOI matches its Crossref record; 45 of the 45 references it cites were found in a registry or an index.

Abstract

Surface adsorptive properties of nanoscale MgO particles have been compared with more conventional samples. Morphologically the nanoparticles (autoclave prepared = AP-MgO) are unique and very different from the conventional samples (conventionally prepared = CP-MgO), and AP-MgO possesses more defects, edge and corner sites, higher surface area and more higher index surfaces. The number of residual surface −OH groups/nm 2 is similar for both types of samples. Differences in adsorptivity of SO 2 and CO 2 at relatively low pressure (20 Torr) were determined by gravimetric means. Much larger quantities were adsorbed by AP-MgO. This process of chemisorption was dynamic, and oxygen scrambling occurred when SO 2 and Mg 18 O nanoparticles were in contact. These results, complying with FTIR studies, are rationalized as due to higher intrinsic surface reactivity coupled with higher concentrations of lower coordination ions on the nanoparticle. Pressure studies showed, however, that as 100 Torr of SO 2 or CO 2 was reached, the CP-MgO samples exhibited higher adsorptive capacities. Quantitative determinations of SO 2 (CO 2 ) loading indicate that this difference can be attributed to multilayered physisorption on CP-MgO, which with its flatter, extended planes, can apparently form more ordered multilayered structures and thus physically adsorb more SO 2 (or CO 2 ). In the case of SO 3, large amounts of surface sulfates were detected by FTIR. Overall, our results indicate that nanoparticles of MgO possess a unique surface chemistry and their high surface reactivity coupled with a high surface area allowed them to approach the goal of being stoichiometric chemical reagents.

Overview

Integrity signals

Registry

Crossref · 10.1021/cm950583p

Cites

45 of 45 references verified0 citation errors · 0 not checkable

Statistics

Recomputing p-values needs the paper’s full text.

Verification

Claims the paper makes

This paper’s full text isn’t openly available, so its claims and self-check weren’t run. The registry and citation checks still apply.

Citations

Cites

Research works printed but not linked: 3

  1. LaFemina J. P., 1994, Crit. Rev. Surf. Chem., 3, 297
  2. Utampanya S. Ph.D., 1990, Department of Chemistry
  3. (d) Boehm, H. P.; Knözinger, J. InCatalysis-Science and Technology; Anderson, J. R., Boudart, M., Eds.; Springer: Berlin, 1983; Vol. 4, p 39.

Cited by

See all 211

Metadata

Authors
Stark, J. V., Park, D. G., Lagadic, I., & Klabunde, K. J.
Affiliations
Kansas State University (US)
Venue
Chemistry of Materials
Published
1996-01-01
Volume
8
Issue
8
Pages
1904-1912
ISSN
  • 0897-4756 (ISSN-L)
  • 1520-5002
OpenAlex
W2048094074
Cited by
210
References
45
Citations by year
2026: 3 · 2025: 2 · 2024: 5 · 2023: 2 · 2022: 7 · 2021: 6 · 2020: 4 · 2019: 7 · 2018: 4 · 2017: 3 · 2016: 6 · 2015: 13 · 2014: 10 · 2013: 10 · 2012: 19
FWCI
3.04
Type
journal article
Language
en
Open access
closed
Locations
Chemistry of Materials (publishedVersion)
Topics
  • Physical Sciences › Materials Science › Materials Chemistry › Magnesium Oxide Properties and Applications
  • Physical Sciences › Chemical Engineering › Filtration and Separation › Carbon Dioxide Capture Technologies
  • Physical Sciences › Chemistry › Physical and Theoretical Chemistry › Adsorption, diffusion, and thermodynamic properties of materials
Keywords
magnesium oxide nanoparticles, nanoclusters, acid gas adsorption, sulfur dioxide, carbon dioxide, surface chemistry, autoclave synthesis, surface defects, chemisorption, pressure dependence, surface sulfate, surface reactivity, surface area

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.