The DOI matches its Crossref record.
Investigation of Chemical Looping Combustion by Solid Fuels. 2. Redox Reaction Kinetics and Product Characterization with Coal, Biomass, and Solid Waste as Solid Fuels and CuO as an Oxygen Carrier
Abstract
This paper is the second in a series of two on the investigation of the chemical looping combustion (CLC) of solid fuels. The first paper put forward the concept of the CLC of solid fuels using a circulating fluidized bed as a reactor and Cu−CuO as the oxygen carrier, which was based on an analysis of oxygen transfer capability, reaction enthalpy, and chemical equilibrium. In this second paper, we report the results of the evaluation of the reduction of CuO reduced by solid fuels such as coal and some other “opportunity” solid fuels. Tests on the reduction of CuO by the selected solid fuels were conducted using simultaneous differential scanning calorimetry and thermogravimetric analysis, which simulates a microreactor. An attached mass spectrometer (MS) was used for the characterization of evolved gaseous products. The X-ray diffractometer (XRD) and scanning electron microscope (SEM) were used for the characterization of the solid residues. Results strongly supported the feasibility of CuO reduction by selected solid fuels. CuO can be fully converted into Cu in a reduction process, either in a direct path by solid fuels, which was verified by MS analysis under a N 2 atmosphere, or in an indirect path by pyrolysis and gasification products of solid fuels in the reducer. No Cu 2 O exists in reducing atmospheres, which was characterized by an XRD analysis and mass balance calculations. No carbon deposit was found on the surface of the reduced Cu, which was characterized by SEM analysis. CuO reduction by solid fuels can start at temperatures as low as approximately 500 °C. Tests indicated that the solid fuels with higher reactivity (higher volatile matter) would be desirable for the development of the chemical looping combustion process of solid fuels, such as sub-bituminous Powder River Basin coal and solid waste and biomass.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Carbon capture and storage update
Boot-Handford, M. E., Abanades, J. C., Anthony, E. J., Blunt, M. J., Brandani, S., Mac Dowell, N., Fernández, J. R., Ferrari, M.-C., Gross, R., Hallett, J. P., et al. (2014) · Energy Environ. Sci. · doi:10.1039/c3ee42350f · Cited by 2,386
Progress in Chemical-Looping Combustion and Reforming technologies
Adanez, J., Abad, A., Garcia-Labiano, F., Gayan, P., & de Diego, L. F. (2012) · Progress in Energy and Combustion Science · doi:10.1016/j.pecs.2011.09.001 · Cited by 2,230
Chemical-looping combustion (CLC) for inherent CO2 separations—a review
Hossain, M. M., & de Lasa, H. I. (2008) · Chemical Engineering Science · doi:10.1016/j.ces.2008.05.028 · Cited by 961
Kinetics of redox reactions of ilmenite for chemical-looping combustion
Abad, A., Adánez, J., Cuadrat, A., García-Labiano, F., Gayán, P., & de Diego, L. F. (2011) · Chemical Engineering Science · doi:10.1016/j.ces.2010.11.010 · Cited by 332
Clean coal conversion processes – progress and challenges
Li, F., & Fan, L.-S. (2008) · Energy & Environmental Science · doi:10.1039/b809218b · Cited by 269
Metadata
- Authors
- Cao, Y., Casenas, B., & Pan, W.-P.
- Venue
- Energy & Fuels
- Publisher
- American Chemical Society (ACS)
- Published
- 2006-08-18
- Volume
- 20
- Issue
- 5
- Pages
- 1845-1854
- ISSN
- 0887-0624 (ISSN-L)
- 1520-5029
- OpenAlex
- W2051041140
- Cited by
- 205
- References
- 0
- FWCI
- 4.88
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.