The DOI matches its Crossref record.
Impact of Biodiesel on NOx Emissions in a Common Rail Direct Injection Diesel Engine
Abstract
The impact of biodiesel on NO x emissions was investigated in a 2.5 L common rail direct injection diesel engine under both low load and high load conditions with different fuel injection strategies. Three fuels were used in this study, an ultralow sulfur diesel fuel (BP15), a blend of 20 vol % biodiesel in BP15 (B20), and a blend of 40 vol % biodiesel in BP15 (B40). Fuel injection timings were held the same for the biodiesel blends and the baseline diesel fuel to eliminate the potential injection timing differences due to the different fuel heating values. According to the needle lift profiles obtained from the needle lift sensor, no measurable injection timing differences were observed between the biodiesel blends and the baseline diesel fuel. Biodiesel blends were found to generally produce slightly lower NO x emissions than the baseline diesel fuel at the low load condition. Under the high load condition, evidently higher NO x emissions for biodiesel blends were observed under both single and double injection conditions. Overall, biodiesel diesel blends and the baseline diesel fuel had very similar heat release rate profiles. Injection system parameters were adjusted to reduce the increased NO x emissions for B20. Retarding injection timing under single injection conditions was found to be the more effective approach to reduce the NO x emissions than using pilot injection with retarded main injection in terms of NO x and fuel consumption tradeoff. Under the low load condition, the pilot injection strategy led to substantially reduced NO x emissions. When the performance of the 40 vol % biodiesel blend under various exhaust gas recirculation (EGR) rate conditions was investigated, the biodiesel blend showed no further combustion deterioration compared to the baseline diesel fuel. A low NO x and fuel-efficient engine operating condition was achieved with the 40 vol % biodiesel blend.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Review of the effects of biodiesel on NOx emissions
Hoekman, S. K., & Robbins, C. (2012) · Fuel Processing Technology · doi:10.1016/j.fuproc.2011.12.036 · Cited by 708
Giakoumis, E. G. (2013) · Renewable Energy · doi:10.1016/j.renene.2012.07.040 · Cited by 362
Impact of fuel formulation on the nanostructure and reactivity of diesel soot
Yehliu, K., Vander Wal, R. L., Armas, O., & Boehman, A. L. (2012) · Combustion and Flame · doi:10.1016/j.combustflame.2012.07.004 · Cited by 269
Self-citationAn overview: Energy saving and pollution reduction by using green fuel blends in diesel engines
Mwangi, J. K., Lee, W.-J., Chang, Y.-C., Chen, C.-Y., & Wang, L.-C. (2015) · Applied Energy · doi:10.1016/j.apenergy.2015.08.084 · Cited by 253
Assessment of NOx emissions during transient diesel engine operation with biodiesel blends
Giakoumis, E. G., Rakopoulos, C. D., & Rakopoulos, D. C. (2014) · Journal of Energy Engineering · doi:10.1061/(asce)ey.1943-7897.0000136 · Cited by 58
Metadata
- Authors
- Zhang, Y., & Boehman, A. L.
- Venue
- Energy & Fuels
- Publisher
- American Chemical Society (ACS)
- Published
- 2007-05-26
- Volume
- 21
- Issue
- 4
- Pages
- 2003-2012
- ISSN
- 0887-0624 (ISSN-L)
- 1520-5029
- OpenAlex
- W2518864196
- Cited by
- 161
- References
- 0
- FWCI
- 7.77
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.