CoChat

Effect of the Fast Pyrolysis Temperature on the Primary and Secondary Products of Lignin

Zhou, Shuai, Garcia-Perez, Manuel, Pecha, Brennan, Kersten, Sascha R. A., McDonald, Armando G., Westerhof, Roel J. M. · 2013 · Energy & Fuels
Cited by 89

The DOI matches its Crossref record; 3 of the 3 references it cites were found in a registry or an index.

Abstract

This paper presents results on the primary pyrolysis products of organosolv lignin at temperatures between 360 and 700 °C. To study the primary products, a vacuum screen heater (heating rate of 8000 °C/s, deep vacuum of 0.7 mbar, and very fast cooling at the wall temperature of −100 °C) was used. The effect of the temperature on the primary and secondary lignin products was studied with a fluidized-bed pyrolysis reactor ( T reactor between 330 and 580 °C) with pine wood. The results obtained with the screen heater show that the primary products of lignin were oligomers. Between 450 and 700 °C, the yield of these oligomers was very high, between 80 and 90%. After formation, the oligomers left the particle by evaporation or thermal ejection. Monophenols and other light compounds were formed by secondary reactions inside the particle or in the vapor phase. In the fluidized-bed reactor, significant quantities of lignin oligomers were formed along with monophenols, water, and other light compounds. The changes on the yield and composition of the lignin-derived oligomers as a function of the pyrolysis temperature are reported. The lignin oligomers were isolated by cold-water precipitation and analyzed with thermogravimetry (TG), Fourier transform infrared (FTIR) spectroscopy, pyrolysis–gas chromatography/mass spectrometry (Py–GC/MS), electrospray ionization–mass spectrometry (ESI–MS), gel permeation chromatography (GPC), and proton nuclear magnetic resonance ( 1 H NMR). The yield of lignin-derived oligomers reached a maximum between 450 and 580 °C. The differential thermogravimetry (DTG) results show the existence of three major peaks, which where maximal between 450 and 480 °C, indicating that not only the yield but also the structure of the lignin oligomers changed at higher pyrolysis temperatures. Py–GC/MS and 1 H NMR results indicated that, as the temperature increased, the content of methoxylated phenols decreased and the content of alkylated phenols increased. FTIR spectroscopy revealed an increase in carbonyl groups produced by carbonylation reactions, from the hydroxyl groups or the cleavage of ether bonds. Both ESI–MS and GPC results show a negligible effect of the pyrolysis temperature on the molar weight distribution. This result differs with the increase in the molecular weight observed for organosolv lignin pyrolyzed in the screen heater and highlights the importance of secondary reactions on the outcome of fast pyrolysis reactors.

Overview

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1021/ef4001677

Cites

3 of 3 references verified0 citation errors · 0 not checkable

Statistics

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Show all 3 references

Cited by

Metadata

Authors
Zhou, S., Garcia-Perez, M., Pecha, B., Kersten, S. R. A., McDonald, A. G., & Westerhof, R. J. M.
Venue
Energy & Fuels
Published
2013-09-11
Volume
27
Issue
10
Pages
5867-5877
ISSN
  • 0887-0624 (ISSN-L)
  • 1520-5029
OpenAlex
W2161024649
Cited by
89
References
3
FWCI
5.14
Type
journal article
Language
en
Open access
closed

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.