Diesel Engine Combustion of Biomass Pyrolysis Oils
The DOI matches its Crossref record.
Abstract
To investigate their ignition delay and combustion behavior, experiments with two biomass pyrolysis oils and No. 2 diesel fuel were performed in a direct injection diesel engine. It was found that while the indicated thermal efficiency of both pyrolysis oils equaled that of the diesel fuel, they exhibited excessive ignition delays and required a moderate degree of combustion air preheating to ignite reliably. Despite the longer ignition delays associated with the pyrolysis oils, the cylinder pressure rise rates were significantly less than with No. 2 diesel fuel. Experimental ignition delay and heat release rates were interpreted using a phenomenological spray combustion model. Using a three parameter fit for vaporization, ignition, and combustion rate, the model showed that the longer ignition delays of the bio-oils result from slow chemistry relative to diesel fuel. The model also showed that the heat release profiles of the bio-oils are consistent with slow combustion chemistry and rapid mixing relative to diesel fuel. As a result, whereas diesel combustion is predominantly mixing limited, pyrolysis oil combustion is predominantly limited by chemistry through much of the process.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Pyrolysis of Wood/Biomass for Bio-oil: A Critical Review
Mohan, D., Pittman, C. U., & Steele, P. H. (2006) · Energy & Fuels · doi:10.1021/ef0502397 · Cited by 5,663
Biofuels Production through Biomass Pyrolysis—A Technological Review
Jahirul, M., Rasul, M., Chowdhury, A., & Ashwath, N. (2012) · Energies · doi:10.3390/en5124952 · Cited by 1,427
“Shihadeh and Hochgreb found that thermal efficiency of pyrolysis oils is identical to that of diesel fuel in combustion engine operations, but they exhibited excessive ignition delay [112].”
BackgroundPyrolysis of biomass to produce fuels and chemical feedstocks
Yaman, S. (2004) · Energy Conversion and Management · doi:10.1016/s0196-8904(03)00177-8 · Cited by 1,224
Characterization and prediction of biomass pyrolysis products
Neves, D., Thunman, H., Matos, A., Tarelho, L., & Gómez-Barea, A. (2011) · Progress in Energy and Combustion Science · doi:10.1016/j.pecs.2011.01.001 · Cited by 856
Overview of fuel properties of biomass fast pyrolysis oils
Lu, Q., Li, W.-Z., & Zhu, X.-F. (2009) · Energy Conversion and Management · doi:10.1016/j.enconman.2009.01.001 · Cited by 847
Power generation using fast pyrolysis liquids from biomass
Chiaramonti, D., Oasmaa, A., & Solantausta, Y. (2007) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2005.07.008 · Cited by 619
Review of fuel oil quality and combustion of fast pyrolysis bio-oils from lignocellulosic biomass
Lehto, J., Oasmaa, A., Solantausta, Y., Kytö, M., & Chiaramonti, D. (2014) · Applied Energy · doi:10.1016/j.apenergy.2013.11.040 · Cited by 469
Bergthorson, J. M., & Thomson, M. J. (2015) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2014.10.034 · Cited by 427
Dabros, T. M. H., Stummann, M. Z., Høj, M., Jensen, P. A., Grunwaldt, J.-D., Gabrielsen, J., Mortensen, P. M., & Jensen, A. D. (2018) · Progress in Energy and Combustion Science · doi:10.1016/j.pecs.2018.05.002 · Cited by 309
Pyrolysis liquids and gases as alternative fuels in internal combustion engines – A review
Hossain, A. K., & Davies, P. A. (2013) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2012.12.031 · Cited by 280
Chiaramonti, D., Bonini, M., Fratini, E., Tondi, G., Gartner, K., Bridgwater, A. V., Grimm, H. P., Soldaini, I., Webster, A., & Baglioni, P. (2003) · Biomass and Bioenergy · doi:10.1016/s0961-9534(02)00183-6 · Cited by 280
Kumar, R., & Strezov, V. (2021) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2020.110152 · Cited by 233
Chintala, V. (2018) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2018.03.066 · Cited by 121
Metadata
- Authors
- Shihadeh, A., & Hochgreb, S.
- Venue
- Energy & Fuels
- Publisher
- American Chemical Society (ACS)
- Published
- 2000-02-15
- Volume
- 14
- Issue
- 2
- Pages
- 260-274
- ISSN
- 0887-0624 (ISSN-L)
- 1520-5029
- OpenAlex
- W2101895121
- Cited by
- 146
- References
- 0
- FWCI
- 3.23
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.