The DOI matches its Crossref record; 26 of the 26 references it cites were found in a registry or an index.
Electricity Generation Using an Air-Cathode Single Chamber Microbial Fuel Cell in the Presence and Absence of a Proton Exchange Membrane
Abstract
Microbial fuel cells (MFCs) are typically designed as a two-chamber system with the bacteria in the anode chamber separated from the cathode chamber by a polymeric proton exchange membrane (PEM). Most MFCs use aqueous cathodes where water is bubbled with air to provide dissolved oxygen to electrode. To increase energy output and reduce the cost of MFCs, we examined power generation in an air-cathode MFC containing carbon electrodes in the presence and absence of a polymeric proton exchange membrane (PEM). Bacteria present in domestic wastewater were used as the biocatalyst, and glucose and wastewater were tested as substrates. Power density was found to be much greater than typically reported for aqueous-cathode MFCs, reaching a maximum of 262 +/- 10 mW/m2 (6.6 +/- 0.3 mW/L; liquid volume) using glucose. Removing the PEM increased the maximum power density to 494 +/- 21 mW/m2 (12.5 +/- 0.5 mW/L). Coulombic efficiency was 40-55% with the PEM and 9-12% with the PEM removed, indicating substantial oxygen diffusion into the anode chamber in the absence of the PEM. Power output increased with glucose concentration according to saturation-type kinetics, with a half saturation constant of 79 mg/L with the PEM-MFC and 103 mg/L in the MFC without a PEM (1000 omega resistor). Similar results on the effect of the PEM on power density were found using wastewater, where 28 +/- 3 mW/m2 (0.7 +/- 0.1 mW/L) (28% Coulombic efficiency) was produced with the PEM, and 146 +/- 8 mW/m2 (3.7 +/- 0.2 mW/L) (20% Coulombic efficiency) was produced when the PEM was removed. The increase in power output when a PEM was removed was attributed to a higher cathode potential as shown by an increase in the open circuit potential. An analysis based on available anode surface area and maximum bacterial growth rates suggests that mediatorless MFCs may have an upper order-of-magnitude limit in power density of 10(3) mW/m2. A cost-effective approach to achieving power densities in this range will likely require systems that do not contain a polymeric PEM in the MFC and systems based on direct oxygen transfer to a carbon cathode.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Environmental Biotechnology: Principles and Applications
Rittmann, B. E., & McCarty, P. L. (2000) · Cited by 3,066
Lovley, D. R., & Phillips, E. J. P. (1988) · Applied and Environmental Microbiology · doi:10.1128/aem.54.6.1472-1480.1988 · Cited by 2,395
Electricity Production by Geobacter sulfurreducens Attached to Electrodes
Bond, D. R., & Lovley, D. R. (2003) · Applied and Environmental Microbiology · doi:10.1128/aem.69.3.1548-1555.2003 · Cited by 2,198
Production of Electricity during Wastewater Treatment Using a Single Chamber Microbial Fuel Cell
Liu, H., Ramnarayanan, R., & Logan, B. E. (2004) · Environmental Science & Technology · doi:10.1021/es034923g · Cited by 1,616
Self-citationElectricity generation by direct oxidation of glucose in mediatorless microbial fuel cells
Chaudhuri, S. K., & Lovley, D. R. (2003) · Nature Biotechnology · doi:10.1038/nbt867 · Cited by 1,542
Electrode-Reducing Microorganisms That Harvest Energy from Marine Sediments
Bond, D. R., Holmes, D. E., Tender, L. M., & Lovley, D. R. (2002) · Science · doi:10.1126/science.1066771 · Cited by 1,437
Operational parameters affecting the performannce of a mediator-less microbial fuel cell
Gil, G.-C., Chang, I.-S., Kim, B. H., Kim, M., Jang, J.-K., Park, H. S., & Kim, H. J. (2003) · Biosensors and Bioelectronics · doi:10.1016/s0956-5663(02)00110-0 · Cited by 1,025
A role for excreted quinones in extracellular electron transfer
Newman, D. K., & Kolter, R. (2000) · Nature · doi:10.1038/35011098 · Cited by 884
A microbial fuel cell capable of converting glucose to electricity at high rate and efficiency
Rabaey, K., Lissens, G., Siciliano, S. D., & Verstraete, W. (2003) · Biotechnology Letters · doi:10.1023/a:1025484009367 · Cited by 771
Harnessing microbially generated power on the seafloor
Tender, L. M., Reimers, C. E., Stecher, H. A., Holmes, D. E., Bond, D. R., Lowy, D. A., Pilobello, K., Fertig, S. J., & Lovley, D. R. (2002) · Nature Biotechnology · doi:10.1038/nbt716 · Cited by 718
Cited by
Items 101–104 of 104
Recent progress and continuing challenges in bio-fuel cells. Part I: Enzymatic cells
Osman, M. H., Shah, A. A., & Walsh, F. C. (2011) · Biosensors and Bioelectronics · doi:10.1016/j.bios.2011.01.004 · Cited by 257
NADH gene manipulation for advancing bioelectricity in Clostridium ljungdahlii microbial fuel cells
Han, S., Gao, X.-Y., Ying, H.-J., & Zhou, C. C. (2016) · Green Chemistry · doi:10.1039/c5gc02696b · Cited by 64
Ahmed, S., Rozaik, E., & Abdelhalim, H. (2015) · Water, Air, & Soil Pollution · doi:10.1007/s11270-015-2567-3 · Cited by 28
Safwat, S. M., Rozaik, E., & Abdel‐Halim, H. (2019) · Water and Environment Journal · doi:10.1111/wej.12413 · Cited by 12
Metadata
- Authors
- Liu, H., & Logan, B. E.
- Venue
- Environmental Science & Technology
- Publisher
- American Chemical Society (ACS)
- Published
- 2004-06-12
- Volume
- 38
- Issue
- 14
- Pages
- 4040-4046
- ISSN
- 0013-936X (ISSN-L)
- 1520-5851
- OpenAlex
- W2021498701
- Cited by
- 1,982
- References
- 26
- FWCI
- 49.09
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.