The DOI matches its Crossref record; 10 of the 10 references it cites were found in a registry or an index.
Integrated Hydrogen and Power Production with CO2 Capture Using Chemical-Looping ReformingRedox Reactivity of Particles of CuO, Mn2O3, NiO, and Fe2O3 Using SiO2 as a Support
Abstract
A concept for combined hydrogen and power production from natural gas with CO 2 capture is presented. The process involves the use of a metal oxide in fluidized bed reactors; the metal oxide is reduced by a mixture of natural gas and steam in a fuel reactor and oxidized by air in the air reactor. The natural gas is partially oxidized in the fuel reactor, resulting in a mixture of CO 2, H 2, H 2 O, and CO from the exit. If no hydrocarbons are present in this stream, it can be sent to a water gas shift reactor to get an undiluted stream of CO 2 and H 2 . The product stream from the air reactor contains mostly N 2 and some unreacted oxygen. The oxidation reaction is exothermic with resulting heat production in the air reactor; this heat is used to maintain the oxygen carrier particles at the high temperature necessary for the endothermic reaction in the fuel reactor. The hot gases from the air reactor could be used for power production. Metal oxides of Ni, Cu, Mn, and Fe were prepared by impregnation on a SiO 2 support and tested in a laboratory fluidized bed reactor using alternating gas flows of CH 4 /H 2 O and O 2 . Among the investigated metal oxides, NiO and CuO showed the highest reduction reactivity in comparison with Mn 2 O 3 and Fe 2 O 3 . However, only NiO/SiO 2 showed high selectivity toward H 2 during the later stages of reduction, while the other metal oxides had large amounts of unreacted CH 4 at the exit of the reactor. The reaction rates decreased as a function of the cycle for Ni, Mn, and Fe at high temperatures. This is likely due to the formation of irreversible metal silicates, which do not react at a sufficient rate. Of the investigated carriers, NiO seems to be the most feasible oxygen carrier to be used in the process, although temperatures exceeding 800 °C should be avoided.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Lyngfelt, A., Leckner, B., & Mattisson, T. (2001) · Chemical Engineering Science · doi:10.1016/s0009-2509(01)00007-0 · Cited by 1,032
Self-citationSelection of Oxygen Carriers for Chemical-Looping Combustion
Adánez, J., de Diego, L. F., García-Labiano, F., Gayán, P., Abad, A., & Palacios, J. M. (2004) · Energy & Fuels · doi:10.1021/ef0301452 · Cited by 754
Reversibility of Combustion Processes
RICHTER, H. J., & KNOCHE, K. F. (1983) · ACS Symposium Series · doi:10.1021/bk-1983-0235.ch003 · Cited by 461
Mattisson, T., Lyngfelt, A., & Cho, P. (2001) · Fuel · doi:10.1016/s0016-2361(01)00051-5 · Cited by 400
Self-citationHydrogen from methane in a single-step process
Balasubramanian, B., Lopez Ortiz, A., Kaytakoglu, S., & Harrison, D. P. (1999) · Chemical Engineering Science · doi:10.1016/s0009-2509(98)00425-4 · Cited by 380
Mattisson, T., Järdnäs, A., & Lyngfelt, A. (2003) · Energy & Fuels · doi:10.1021/ef020151i · Cited by 331
Self-citationA Novel Chemical-Looping Combustor without NOx Formation
Ishida, M., & Jin, H. (1996) · Industrial & Engineering Chemistry Research · doi:10.1021/ie950680s · Cited by 319
A Fundamental Study of a New Kind of Medium Material for Chemical-Looping Combustion
Ishida, M., Jin, H., & Okamoto, T. (1996) · Energy & Fuels · doi:10.1021/ef950173n · Cited by 214
Ishida, M., Jin, H., & Okamoto, T. (1998) · Energy & Fuels · doi:10.1021/ef970041p · Cited by 173
4th World hydrogen energy conference
(1981) · International Journal of Hydrogen Energy · doi:10.1016/0360-3199(81)90056-2 · Cited by 165
Cited by
An overview of current status of carbon dioxide capture and storage technologies
Leung, D. Y. C., Caramanna, G., & Maroto-Valer, M. M. (2014) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2014.07.093 · Cited by 3,198
Progress in Chemical-Looping Combustion and Reforming technologies
Adanez, J., Abad, A., Garcia-Labiano, F., Gayan, P., & de Diego, L. F. (2012) · Progress in Energy and Combustion Science · doi:10.1016/j.pecs.2011.09.001 · Cited by 2,230
Chemical-looping combustion (CLC) for inherent CO2 separations—a review
Hossain, M. M., & de Lasa, H. I. (2008) · Chemical Engineering Science · doi:10.1016/j.ces.2008.05.028 · Cited by 961
Wang, L., Chen, W., Zhang, D., Du, Y., Amal, R., Qiao, S., Wu, J., & Yin, Z. (2019) · Chemical Society Reviews · doi:10.1039/c9cs00163h · Cited by 905
Review of hydrogen production using chemical-looping technology
Luo, M., Yi, Y., Wang, S., Wang, Z., Du, M., Pan, J., & Wang, Q. (2018) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2017.07.007 · Cited by 528
Metadata
- Authors
- Zafar, Q., Mattisson, T., & Gevert, B.
- Venue
- Industrial & Engineering Chemistry Research
- Publisher
- American Chemical Society (ACS)
- Published
- 2005-04-19
- Volume
- 44
- Issue
- 10
- Pages
- 3485-3496
- ISSN
- 0888-5885 (ISSN-L)
- 1520-5045
- OpenAlex
- W2075542643
- Cited by
- 292
- References
- 10
- FWCI
- 8.19
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.