The DOI matches its Crossref record; 20 of the 20 references it cites were found in a registry or an index.
Kinetics of the Low-Temperature Pyrolysis of Polyethene, Polypropene, and Polystyrene Modeling, Experimental Determination, and Comparison with Literature Models and Data
Open accessAbstract
The pyrolysis kinetics of low-density polyethylene, high-density polyethylene, polypropylene, and polystyrene has been studied at temperatures below 450 °C. In addition, a literature review on the low-temperature pyrolysis of these polymers has been conducted and has revealed that the scatter in the reported kinetic data is significant, which is most probably due to the use of simple first-order kinetic models to interpret the experimental data. This model type is only applicable in a small conversion range, but was used by many authors over a much wider conversion range. In this investigation the pyrolysis kinetics of the forementioned polymers and a mixture of polymers has been studied at temperatures below 450 °C by performing isothermal thermogravimetric analysis (TGA) experiments. The TGA experimental data was used to determine the kinetic parameters on the basis of a simple first-order model for high conversions (70−90%) and a model developed in the present study, termed the random chain dissociation (RCD) model, for the entire conversion range. The influence of important parameters, such as molecular weight, extent of branching and β-scission on the pyrolysis kinetics was studied with the RCD model. This model was also used to calculate the primary product spectrum of the pyrolysis process. The effect of the extent of branching and the initial molecular weight on the pyrolysis process was also studied experimentally. The effect of the extent of branching was found to be quite significant, but the effect of the initial molecular weight was minor. These results were found to agree quite well with the predictions obtained from the RCD model. Finally, the behavior of mixtures of the aforementioned polymers was studied and it was found that the pyrolysis kinetics of the polymers in the mixture remains unaltered in comparison with the pyrolysis kinetics of the pure polymers.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
The kinetics of the thermal degradation of polystyrene and polyethylene
Anderson, D. A., & Freeman, E. S. (1961) · Journal of Polymer Science · doi:10.1002/pol.1961.1205415920 · Cited by 346
Theory of Depolymerization of Long Chain Molecules
Montroll, E. W., & Simha, R. (1940) · The Journal of Chemical Physics · doi:10.1063/1.1750807 · Cited by 272
Product Composition and Kinetics of Lignite Pyrolysis
Suuberg, E. M., Peters, W. A., & Howard, J. B. (1978) · Industrial & Engineering Chemistry Process Design and Development · doi:10.1021/i260065a008 · Cited by 266
Kinetics of Chain Depolymerization
Simha, R., & Wall, L. A. (1952) · The Journal of Physical Chemistry · doi:10.1021/j150498a012 · Cited by 216
Rates of thermal degradation of polystyrene and polyethylene in a vacuum
Madorsky, S. L. (1952) · Journal of Polymer Science · doi:10.1002/pol.1952.120090203 · Cited by 181
On the thermal treatment of plastic mixtures of MSW: Pyrolysis kinetics
Wu, C.-H., Chang, C.-Y., Hor, J.-L., Shih, S.-M., Chen, L.-W., & Chang, F.-W. (1993) · Waste Management · doi:10.1016/0956-053x(93)90046-y · Cited by 166
Thermal degradation of polystyrene and polyethylene. Part III
Jellinek, H. H. G. (1949) · Journal of Polymer Science · doi:10.1002/pol.1949.120040102 · Cited by 134
The Depolymerization of Polymethylene and Polyethylene
Wall, L. A., Madorsky, S. L., Brown, D. W., Straus, S., & Simha, R. (1954) · Journal of the American Chemical Society · doi:10.1021/ja01642a017 · Cited by 128
Depolymerization as a chain reaction
Simha, R., Wall, L. A., & Blatz, P. J. (1950) · Journal of Polymer Science · doi:10.1002/pol.1950.120050509 · Cited by 127
Rates and activation energies of thermal degradation of styrene and acrylate polymers in a vacuum
Madorsky, S. L. (1953) · Journal of Polymer Science · doi:10.1002/pol.1953.120110511 · Cited by 118
619. The thermal degradation of ethylene polymers
Oakes, W. G., & Richards, R. B. (1949) · Journal of the Chemical Society (Resumed) · doi:10.1039/jr9490002929 · Cited by 92
Thermal decomposition of polystyrene
Malhotra, S. (1975) · Polymer · doi:10.1016/0032-3861(75)90133-0 · Cited by 83
Kinetic model of the pyrolysis of polyethylene in a fluidized bed reactor
Conesa, J. A., Marcilla, A. F., & Font, R. (1994) · Journal of Analytical and Applied Pyrolysis · doi:10.1016/0165-2370(94)00806-x · Cited by 55
Darivakis, G. S., Howard, J. B., & Peters, W. (1990) · Combustion Science and Technology · doi:10.1080/00102209008951692 · Cited by 54
Some aspects of depolymerization kinetics
Simha, R., & Wall, L. A. (1951) · Journal of Polymer Science · doi:10.1002/pol.1951.120060107 · Cited by 52
Reaction Kinetic Model For Optimal Pyrolysis Of Plastic Waste Mixtures
Koo, J., & Kim, S.-W. (1993) · Waste Management & Research The Journal for a Sustainable Circular Economy · doi:10.1006/wmre.1993.1054 · Cited by 40
Seeger, M., & Cantow, H. ‐. (1975) · Die Makromolekulare Chemie · doi:10.1002/macp.1975.021760515 · Cited by 33
Rangarajan, R., Matsuura, T., Goodhue, E. C., et al. (1978) · Industrial & Engineering Chemistry Process Design and Development · doi:10.1021/i260065a009 · Cited by 27
Chemical and probabilistic modelling of complex reactions: A lignin depolymerization example
McDermott, J. B., & Klein, M. T. (1986) · Chemical Engineering Science · doi:10.1016/0009-2509(86)87192-5 · Cited by 22
Sawaguchi, T., Suzuki, K., Kuroki, T., & Ikemura, T. (1981) · Journal of Applied Polymer Science · doi:10.1002/app.1981.070260418 · Cited by 16
Cited by
Chemical and biological catalysis for plastics recycling and upcycling
Ellis, L. D., Rorrer, N. A., Sullivan, K. P., Otto, M., McGeehan, J. E., Román-Leshkov, Y., Wierckx, N., & Beckham, G. T. (2021) · Nature Catalysis · doi:10.1038/s41929-021-00648-4 · Cited by 1,201
A review on thermal and catalytic pyrolysis of plastic solid waste (PSW)
Al-Salem, S. M., Antelava, A., Constantinou, A., Manos, G., & Dutta, A. (2017) · Journal of Environmental Management · doi:10.1016/j.jenvman.2017.03.084 · Cited by 1,200
Aboulkas, A., El harfi, K., & El Bouadili, A. (2010) · Energy Conversion and Management · doi:10.1016/j.enconman.2009.12.017 · Cited by 726
Dogu, O., Pelucchi, M., Van de Vijver, R., Van Steenberge, P. H. M., D'hooge, D. R., Cuoci, A., Mehl, M., Frassoldati, A., Faravelli, T., & Van Geem, K. M. (2021) · Progress in Energy and Combustion Science · doi:10.1016/j.pecs.2020.100901 · Cited by 698
Expanding plastics recycling technologies: chemical aspects, technology status and challenges
Li, H., Aguirre-Villegas, H. A., Allen, R. D., Bai, X., Benson, C. H., Beckham, G. T., Bradshaw, S. L., Brown, J. L., Brown, R. C., Cecon, V. S., et al. (2022) · Green Chemistry · doi:10.1039/d2gc02588d · Cited by 616
Metadata
- Authors
- Westerhout, R. W. J., Waanders, J., Kuipers, J. A. M., & van Swaaij, W. P. M.
- Venue
- Industrial & Engineering Chemistry Research
- Publisher
- American Chemical Society (ACS)
- Published
- 1997-06-01
- Volume
- 36
- Issue
- 6
- Pages
- 1955-1964
- ISSN
- 0888-5885 (ISSN-L)
- 1520-5045
- OpenAlex
- W2160506523
- Cited by
- 322
- References
- 20
- FWCI
- 2.94
- Type
- journal article
- Language
- en
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.