The DOI matches its Crossref record.
Investigation of the Catalytic Pyrolysis of High-Density Polyethylene over a HZSM-5 Catalyst in a Laboratory Fluidized-Bed Reactor
Abstract
High-density polyethylene (HDPE) was pyrolyzed over HZSM-5 catalyst using a specially developed laboratory fluidized-bed reactor operating isothermally at ambient pressure. The influence of reaction conditions including temperature, ratios of HDPE to catalyst feed, and flow rates of fluidizing gas was examined. The sodium form of siliceous ZSM-5, silicalite, containing very few or no catalytically active sites, gave very low conversions of polymer to volatile hydrocarbons compared with HZSM-5 (Si/Al = 17.5) under the same reaction conditions. Experiments carried out with HZSM-5 gave good yields of volatile hydrocarbons with differing selectivities in the final products dependent on reaction conditions. Catalytic pyrolysis of HDPE performed in the fluidized-bed reactor was shown to produce valuable hydrocarbons in the range of C 3 −C 5 carbon number with a high olefinic content. The production of olefins with potential value as a chemical feedstock is potentially attractive and may offer greater profitability than production of saturated hydrocarbons and aromatics.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
A review on pyrolysis of plastic wastes
Anuar Sharuddin, S. D., Abnisa, F., Wan Daud, W. M. A., & Aroua, M. K. (2016) · Energy Conversion and Management · doi:10.1016/j.enconman.2016.02.037 · Cited by 2,126
Panda, A. K., Singh, R. K., & Mishra, D. K. (2010) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2009.07.005 · Cited by 956
Kunwar, B., Cheng, H. N., Chandrashekaran, S. R., & Sharma, B. K. (2016) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2015.10.015 · Cited by 639
A review on tertiary recycling of high-density polyethylene to fuel
Kumar, S., Panda, A. K., & Singh, R. K. (2011) · Resources, Conservation and Recycling · doi:10.1016/j.resconrec.2011.05.005 · Cited by 493
Pyrolysis Study of Polypropylene and Polyethylene Into Premium Oil Products
Ahmad, I., Khan, M. I., Khan, H., Ishaq, M., Tariq, R., Gul, K., & Ahmad, W. (2015) · International Journal of Green Energy · doi:10.1080/15435075.2014.880146 · Cited by 463
Serrano, D. P., Aguado, J., & Escola, J. M. (2012) · ACS Catalysis · doi:10.1021/cs3003403 · Cited by 457
Catalytic pyrolysis of polyethylene
Bagri, R., & Williams, P. T. (2002) · Journal of Analytical and Applied Pyrolysis · doi:10.1016/s0165-2370(01)00139-5 · Cited by 362
Ratnasari, D. K., Nahil, M. A., & Williams, P. T. (2017) · Journal of Analytical and Applied Pyrolysis · doi:10.1016/j.jaap.2016.12.027 · Cited by 355
Feedstock recycling of polymers by pyrolysis in a fluidised bed
Kaminsky, W., Predel, M., & Sadiki, A. (2004) · Polymer Degradation and Stability · doi:10.1016/j.polymdegradstab.2003.05.002 · Cited by 354
Marcilla, A., Beltrán, M. I., & Navarro, R. (2009) · Applied Catalysis B: Environmental · doi:10.1016/j.apcatb.2008.07.026 · Cited by 333
Miskolczi, N., Angyal, A., Bartha, L., & Valkai, I. (2009) · Fuel Processing Technology · doi:10.1016/j.fuproc.2009.04.019 · Cited by 315
Fuels from Waste Plastics by Thermal and Catalytic Processes: A Review
Aguado, J., Serrano, D. P., & Escola, J. M. (2008) · Industrial & Engineering Chemistry Research · doi:10.1021/ie800393w · Cited by 311
Recovery of hydrocarbon liquid from waste high density polyethylene by thermal pyrolysis
Kumar, S., & Singh, R. K. (2011) · Brazilian Journal of Chemical Engineering · doi:10.1590/s0104-66322011000400011 · Cited by 297
Polyethylene Hydrogenolysis at Mild Conditions over Ruthenium on Tungstated Zirconia
Wang, C., Xie, T., Kots, P. A., Vance, B. C., Yu, K., Kumar, P., Fu, J., Liu, S., Tsilomelekis, G., Stach, E. A., et al. (2021) · JACS Au · doi:10.1021/jacsau.1c00200 · Cited by 293
Zhang, X., Lei, H., Yadavalli, G., Zhu, L., Wei, Y., & Liu, Y. (2015) · Fuel · doi:10.1016/j.fuel.2014.12.013 · Cited by 285
A review on gasification and pyrolysis of waste plastics
Shah, H. H., Amin, M., Iqbal, A., Nadeem, I., Kalin, M., Soomar, A. M., & Galal, A. M. (2023) · Frontiers in Chemistry · doi:10.3389/fchem.2022.960894 · Cited by 269
Kumar, S., Prakash, R., Murugan, S., & Singh, R. K. (2013) · Energy Conversion and Management · doi:10.1016/j.enconman.2013.05.028 · Cited by 269
Effect of catalyst contact mode and gas atmosphere during catalytic pyrolysis of waste plastics
Xue, Y., Johnston, P., & Bai, X. (2017) · Energy Conversion and Management · doi:10.1016/j.enconman.2017.03.071 · Cited by 262
Fan, L., Chen, P., Zhang, Y., Liu, S., Liu, Y., Wang, Y., Dai, L., & Ruan, R. (2017) · Bioresource Technology · doi:10.1016/j.biortech.2016.11.072 · Cited by 218
Metadata
- Authors
- Sharratt, P. N., Lin, Y.-H., Garforth, A. A., & Dwyer, J.
- Venue
- Industrial & Engineering Chemistry Research
- Publisher
- American Chemical Society (ACS)
- Published
- 1997-12-01
- Volume
- 36
- Issue
- 12
- Pages
- 5118-5124
- ISSN
- 0888-5885 (ISSN-L)
- 1520-5045
- OpenAlex
- W2038239284
- Cited by
- 166
- References
- 0
- FWCI
- 1.85
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.