The DOI matches its Crossref record; 23 of the 23 references it cites were found in a registry or an index.
Degradation Patterns in Water and Oxygen of an Inverted Polymer Solar Cell
Abstract
The spatial distribution of reaction products in multilayer polymer solar cells induced by water and oxygen atmospheres was mapped and used to elucidate the degradation patterns and failure mechanisms in an inverted polymer solar cell. The active material comprised a bulk heterojunction formed by poly(3-hexylthiophene) (P3HT) and [6,6]-phenyl-C61-butyric acid methyl ester (PCBM) sandwiched between a layer of zinc oxide and a layer of poly(3,4-ethylenedioxythiophene) poly(styrenesulfonate) (PEDOT:PSS) that acted as, respectively, electron and hole transporting layers between the active material and the two electrodes indium-tin-oxide (ITO) and printed silver. X-ray photoelectron spectroscopy (XPS) and time-of-flight secondary ion mass spectrometry (TOF-SIMS) in conjunction with isotopic labeling using H(2)(18)O and (18)O(2) enabled detailed information on where and to what extent uptake took place. A comparison was made between the use of a humid (oxygen-free) atmosphere and a dry oxygen atmosphere during testing of devices that were kept in the dark and devices that were subjected to illumination under simulated sunlight. It was found that the reactions taking place at the interface between the active layer and the PEDOT:PSS were the major cause of device failure in the case of these inverted devices, which are compatible with full roll-to-roll (R2R) coating and industrial manufacture. The PEDOT:PSS was found to phase separate, with the PEDOT-rich phase being responsible for most of the interface degradation in oxygen atmospheres. In water atmospheres, little chemically induced degradation was observed, whereas a large partially reversible dependence of the open circuit voltage on the relative humidity was observed. In addition, temporal aspects are discussed in regard to degradation mechanisms. Finally, analytical aspects in regard to storing devices are discussed.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Polymer–Fullerene Composite Solar Cells
Thompson, B. C., & Fréchet, J. M. J. (2008) · Angewandte Chemie International Edition · doi:10.1002/anie.200702506 · Cited by 4,150
Bulk heterojunction solar cells with internal quantum efficiency approaching 100%
Park, S. H., Roy, A., Beaupré, S., Cho, S., Coates, N., Moon, J. S., Moses, D., Leclerc, M., Lee, K., & Heeger, A. J. (2009) · Nature Photonics · doi:10.1038/nphoton.2009.69 · Cited by 4,073
Fabrication and processing of polymer solar cells: A review of printing and coating techniques
Krebs, F. C. (2009) · Solar Energy Materials and Solar Cells · doi:10.1016/j.solmat.2008.10.004 · Cited by 3,260
Self-citationPolymer solar cells with enhanced open-circuit voltage and efficiency
Chen, H.-Y., Hou, J., Zhang, S., Liang, Y., Yang, G., Yang, Y., Yu, L., Wu, Y., & Li, G. (2009) · Nature Photonics · doi:10.1038/nphoton.2009.192 · Cited by 3,087
Stability/degradation of polymer solar cells
Jørgensen, M., Norrman, K., & Krebs, F. C. (2008) · Solar Energy Materials and Solar Cells · doi:10.1016/j.solmat.2008.01.005 · Cited by 2,335
Self-citationChen, L., Hong, Z., Li, G., & Yang, Y. (2009) · Advanced Materials · doi:10.1002/adma.200802854 · Cited by 1,267
Kippelen, B., & Brédas, J.-L. (2009) · Energy & Environmental Science · doi:10.1039/b812502n · Cited by 1,267
Krebs, F. C., Gevorgyan, S. A., & Alstrup, J. (2009) · Journal of Materials Chemistry · doi:10.1039/b823001c · Cited by 1,229
Self-citationOrganic tandem solar cells: A review
Ameri, T., Dennler, G., Lungenschmied, C., & Brabec, C. J. (2009) · Energy & Environmental Science · doi:10.1039/b817952b · Cited by 763
Xu, Z., Chen, L., Yang, G., Huang, C., Hou, J., Wu, Y., Li, G., Hsu, C., & Yang, Y. (2009) · Advanced Functional Materials · doi:10.1002/adfm.200801286 · Cited by 681
Peet, J., Heeger, A. J., & Bazan, G. C. (2009) · Accounts of Chemical Research · doi:10.1021/ar900065j · Cited by 617
Nanoparticle–polymer photovoltaic cells
Saunders, B. R., & Turner, M. L. (2008) · Advances in Colloid and Interface Science · doi:10.1016/j.cis.2007.09.001 · Cited by 459
Flexible organic P3HT:PCBM bulk-heterojunction modules with more than 1 year outdoor lifetime
Hauch, J. A., Schilinsky, P., Choulis, S. A., Childers, R., Biele, M., & Brabec, C. J. (2008) · Solar Energy Materials and Solar Cells · doi:10.1016/j.solmat.2008.01.004 · Cited by 373
Günes, S., & Sariciftci, N. S. (2008) · Inorganica Chimica Acta · doi:10.1016/j.ica.2007.06.042 · Cited by 308
Air stable polymer photovoltaics based on a process free from vacuum steps and fullerenes
Krebs, F. C. (2008) · Solar Energy Materials and Solar Cells · doi:10.1016/j.solmat.2008.01.013 · Cited by 303
Self-citationWater-Induced Degradation of Polymer Solar Cells Studied by H218O Labeling
Norrman, K., Gevorgyan, S. A., & Krebs, F. C. (2009) · ACS Applied Materials & Interfaces · doi:10.1021/am800039w · Cited by 281
Self-citationLongterm stability of efficient inverted P3HT:PCBM solar cells
Zimmermann, B., Würfel, U., & Niggemann, M. (2009) · Solar Energy Materials and Solar Cells · doi:10.1016/j.solmat.2008.12.022 · Cited by 208
van Bavel, S., Sourty, E., de With, G., Frolic, K., & Loos, J. (2009) · Macromolecules · doi:10.1021/ma900817t · Cited by 195
Zimmermann, B., Glatthaar, M., Niggemann, M., Riede, M., Hinsch, A., & Gombert, A. (2006) · Solar Energy Materials and Solar Cells · doi:10.1016/j.solmat.2006.10.005 · Cited by 130
Helgesen, M., Gevorgyan, S. A., & Krebs, F. C. (2008) · Macromolecules · doi:10.1021/ma801932a · Cited by 114
Self-citationUsing Light-Induced Thermocleavage in a Roll-to-Roll Process for Polymer Solar Cells
Krebs, F. C., & Norrman, K. (2010) · ACS Applied Materials & Interfaces · doi:10.1021/am900858x · Cited by 101
Self-citationA setup for studying stability and degradation of polymer solar cells
Gevorgyan, S. A., Jørgensen, M., & Krebs, F. C. (2008) · Solar Energy Materials and Solar Cells · doi:10.1016/j.solmat.2008.02.008 · Cited by 86
Self-citationReeja‐Jayan, B., & Manthiram, A. (2010) · Solar Energy Materials and Solar Cells · doi:10.1016/j.solmat.2010.01.021 · Cited by 41
Cited by
Stability of Polymer Solar Cells
Jørgensen, M., Norrman, K., Gevorgyan, S. A., Tromholt, T., Andreasen, B., & Krebs, F. C. (2012) · Advanced Materials · doi:10.1002/adma.201104187 · Cited by 1,366
Self-citationYip, H.-L., & Jen, A. K.-Y. (2012) · Energy & Environmental Science · doi:10.1039/c2ee02806a · Cited by 1,117
Stability of organic solar cells: challenges and strategies
Cheng, P., & Zhan, X. (2016) · Chemical Society Reviews · doi:10.1039/c5cs00593k · Cited by 1,046
Electronic Properties of Transparent Conductive Films of PEDOT:PSS on Stretchable Substrates
Lipomi, D. J., Lee, J. A., Vosgueritchian, M., Tee, B. C.-K., Bolander, J. A., & Bao, Z. (2012) · Chemistry of Materials · doi:10.1021/cm203216m · Cited by 580
CuSCN-Based Inverted Planar Perovskite Solar Cell with an Average PCE of 15.6%
Ye, S., Sun, W., Li, Y., Yan, W., Peng, H., Bian, Z., Liu, Z., & Huang, C. (2015) · Nano Letters · doi:10.1021/acs.nanolett.5b00116 · Cited by 564
Metadata
- Authors
- Norrman, K., Madsen, M. V., Gevorgyan, S. A., & Krebs, F. C.
- Venue
- Journal of the American Chemical Society
- Publisher
- American Chemical Society (ACS)
- Published
- 2010-11-05
- Volume
- 132
- Issue
- 47
- Pages
- 16883-16892
- ISSN
- 0002-7863 (ISSN-L)
- 1520-5126
- OpenAlex
- W1981728494
- Cited by
- 588
- References
- 23
- FWCI
- 41.61
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.