The DOI matches its Crossref record; 32 of the 32 references it cites were found in a registry or an index.
The Influence of Poly(3-hexylthiophene) Regioregularity on Fullerene-Composite Solar Cell Performance
Abstract
A comparison of three samples of poly(3-hexylthiophene) having regioregularities of 86, 90, and 96% is used to elucidate the effect of regioregularity on polymer-fullerene-composite solar cell performance. It is observed that polymer samples with lower regioregularity are capable of generating fullerene composites that exhibit superior thermal stability. The enhanced thermal stability of the composites is attributed to a lower driving force for polymer crystallization in the less regioregular polymer samples, which is supported with two-dimensional grazing incidence X-ray scattering and differential scanning calorimetry measurements. Furthermore, it is demonstrated that all three polymer samples are capable of generating solar cells with equivalent peak efficiencies of approximately 4% in blends with [6,6]-phenyl-C61-butyric acid methyl ester. While it may be non-intuitive that polymers with lower regioregularity can exhibit higher efficiencies, it is observed that the charge-carrier mobility of the three polymers is on the same order of magnitude (10(-4) cm2 V(-1) s(-1)) when measured from the space-charge-limited current, suggesting that highly regioregular and crystalline polythiophenes are not required in order to effectively transport charges in polymer solar cells. Overall, these results suggest a design principle for semicrystalline conjugated polymers in fullerene-composite solar cells in which crystallization-driven phase separation can be dramatically suppressed via the introduction of a controlled amount of disorder into the polymer backbone.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Conjugated Polymer-Based Organic Solar Cells
Günes, S., Neugebauer, H., & Sariciftci, N. S. (2007) · Chemical Reviews · doi:10.1021/cr050149z · Cited by 6,279
Li, G., Shrotriya, V., Huang, J., Yao, Y., Moriarty, T., Emery, K., & Yang, Y. (2005) · Nature Materials · doi:10.1038/nmat1500 · Cited by 5,535
Design Rules for Donors in Bulk‐Heterojunction Solar Cells—Towards 10 % Energy‐Conversion Efficiency
Scharber, M. C., Mühlbacher, D., Koppe, M., Denk, P., Waldauf, C., Heeger, A. J., & Brabec, C. J. (2006) · Advanced Materials · doi:10.1002/adma.200501717 · Cited by 5,205
Two-dimensional charge transport in self-organized, high-mobility conjugated polymers
Sirringhaus, H., Brown, P. J., Friend, R. H., Nielsen, M. M., Bechgaard, K., Langeveld-Voss, B. M. W., Spiering, A. J. H., Janssen, R. A. J., Meijer, E. W., Herwig, P., et al. (1999) · Nature · doi:10.1038/44359 · Cited by 4,624
Ma, W., Yang, C., Gong, X., Lee, K., & Heeger, A. J. (2005) · Advanced Functional Materials · doi:10.1002/adfm.200500211 · Cited by 4,565
Polymer–Fullerene Composite Solar Cells
Thompson, B. C., & Fréchet, J. M. J. (2008) · Angewandte Chemie International Edition · doi:10.1002/anie.200702506 · Cited by 4,150
Self-citationEfficiency enhancement in low-bandgap polymer solar cells by processing with alkane dithiols
Peet, J., Kim, J. Y., Coates, N. E., Ma, W. L., Moses, D., Heeger, A. J., & Bazan, G. C. (2007) · Nature Materials · doi:10.1038/nmat1928 · Cited by 3,202
Kim, Y., Cook, S., Tuladhar, S. M., Choulis, S. A., Nelson, J., Durrant, J. R., Bradley, D. D. C., Giles, M., McCulloch, I., Ha, C.-S., et al. (2006) · Nature Materials · doi:10.1038/nmat1574 · Cited by 2,312
Kim, J. Y., Kim, S. H., Lee, H. ‐., Lee, K., Ma, W., Gong, X., & Heeger, A. J. (2006) · Advanced Materials · doi:10.1002/adma.200501825 · Cited by 1,656
Nanoscale Morphology of High-Performance Polymer Solar Cells
Yang, X., Loos, J., Veenstra, S. C., Verhees, W. J. H., Wienk, M. M., Kroon, J. M., Michels, M. A. J., & Janssen, R. A. J. (2005) · Nano Letters · doi:10.1021/nl048120i · Cited by 1,543
Cited by
Beaujuge, P. M., & Fréchet, J. M. J. (2011) · Journal of the American Chemical Society · doi:10.1021/ja2073643 · Cited by 1,427
Self-citationP3HT:PCBM, Best Seller in Polymer Photovoltaic Research
Dang, M. T., Hirsch, L., & Wantz, G. (2011) · Advanced Materials · doi:10.1002/adma.201100792 · Cited by 1,261
Stability of organic solar cells: challenges and strategies
Cheng, P., & Zhan, X. (2016) · Chemical Society Reviews · doi:10.1039/c5cs00593k · Cited by 1,046
Imide- and Amide-Functionalized Polymer Semiconductors
Guo, X., Facchetti, A., & Marks, T. J. (2014) · Chemical Reviews · doi:10.1021/cr500225d · Cited by 1,035
Huo, L., Zhang, S., Guo, X., Xu, F., Li, Y., & Hou, J. (2011) · Angewandte Chemie International Edition · doi:10.1002/anie.201103313 · Cited by 985
Piliego, C., Holcombe, T. W., Douglas, J. D., Woo, C. H., Beaujuge, P. M., & Fréchet, J. M. J. (2010) · Journal of the American Chemical Society · doi:10.1021/ja103275u · Cited by 907
Self-citationAdvanced materials and processes for polymer solar cell devices
Helgesen, M., Søndergaard, R., & Krebs, F. C. (2010) · J. Mater. Chem. · doi:10.1039/b913168j · Cited by 767
Morphology Control in Organic Solar Cells
Zhao, F., Wang, C., & Zhan, X. (2018) · Advanced Energy Materials · doi:10.1002/aenm.201703147 · Cited by 630
Dang, M. T., Hirsch, L., Wantz, G., & Wuest, J. D. (2013) · Chemical Reviews · doi:10.1021/cr300005u · Cited by 587
Light Harvesting for Organic Photovoltaics
Hedley, G. J., Ruseckas, A., & Samuel, I. D. W. (2017) · Chemical Reviews · doi:10.1021/acs.chemrev.6b00215 · Cited by 580
Incorporation of Furan into Low Band-Gap Polymers for Efficient Solar Cells
Woo, C. H., Beaujuge, P. M., Holcombe, T. W., Lee, O. P., & Fréchet, J. M. J. (2010) · Journal of the American Chemical Society · doi:10.1021/ja108115y · Cited by 458
Self-citationHsieh, C.-H., Cheng, Y.-J., Li, P.-J., Chen, C.-H., Dubosc, M., Liang, R.-M., & Hsu, C.-S. (2010) · Journal of the American Chemical Society · doi:10.1021/ja100236b · Cited by 440
Guo, J., Ohkita, H., Benten, H., & Ito, S. (2009) · Journal of the American Chemical Society · doi:10.1021/ja906621a · Cited by 419
A Planar Copolymer for High Efficiency Polymer Solar Cells
Qin, R., Li, W., Li, C., Du, C., Veit, C., Schleiermacher, H.-F., Andersson, M., Bo, Z., Liu, Z., Inganäs, O., et al. (2009) · Journal of the American Chemical Society · doi:10.1021/ja9057986 · Cited by 412
Morphology characterization in organic and hybrid solar cells
Chen, W., Nikiforov, M. P., & Darling, S. B. (2012) · Energy & Environmental Science · doi:10.1039/c2ee22056c · Cited by 400
Molecular Miscibility of Polymer−Fullerene Blends
Collins, B. A., Gann, E., Guignard, L., He, X., McNeill, C. R., & Ade, H. (2010) · The Journal of Physical Chemistry Letters · doi:10.1021/jz101276h · Cited by 386
Chochos, C. L., & Choulis, S. A. (2011) · Progress in Polymer Science · doi:10.1016/j.progpolymsci.2011.04.003 · Cited by 340
The Bulk Heterojunction in Organic Photovoltaic, Photodetector, and Photocatalytic Applications
Wadsworth, A., Hamid, Z., Kosco, J., Gasparini, N., & McCulloch, I. (2020) · Advanced Materials · doi:10.1002/adma.202001763 · Cited by 332
Conjugated polymers for high-efficiency organic photovoltaics
Zhan, X., & Zhu, D. (2010) · Polymer Chemistry · doi:10.1039/b9py00325h · Cited by 317
Polymer Crystallization of Partially Miscible Polythiophene/Fullerene Mixtures Controls Morphology
Kozub, D. R., Vakhshouri, K., Orme, L. M., Wang, C., Hexemer, A., & Gomez, E. D. (2011) · Macromolecules · doi:10.1021/ma200855r · Cited by 272
Improved Thermal Stability of Polymer Solar Cells by Incorporating Porphyrins
Wang, S., Qu, Y., Li, S., Ye, F., Chen, Z., & Yang, X. (2015) · Advanced Functional Materials · doi:10.1002/adfm.201403018 · Cited by 48
Angiolini, L., Cocchi, V., Lanzi, M., Salatelli, E., Tonelli, D., & Vlamidis, Y. (2014) · Materials Chemistry and Physics · doi:10.1016/j.matchemphys.2014.03.054 · Cited by 19
Metadata
- Authors
- Woo, C. H., Thompson, B. C., Kim, B. J., Toney, M. F., & Fréchet, J. M. J.
- Venue
- Journal of the American Chemical Society
- Publisher
- American Chemical Society (ACS)
- Published
- 2008-11-08
- Volume
- 130
- Issue
- 48
- Pages
- 16324-16329
- ISSN
- 0002-7863 (ISSN-L)
- 1520-5126
- OpenAlex
- W2000574958
- Cited by
- 410
- References
- 32
- FWCI
- 34.07
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.