The DOI matches its Crossref record; 20 of the 20 references it cites were found in a registry or an index.
Understanding Effect of Wall Structure on the Hydrothermal Stability of Mesostructured Silica SBA-15
Abstract
Mesostructured silica SBA-15 materials with different structural parameters, such as pore size, pore volume, and wall thickness, etc., were prepared by varying the postsynthesis hydrothermal treatment temperature and adding inorganic salts. The hydrothermal stabilities of these materials in steam (100% water vapor) were systematically investigated using a variety of techniques including powder X-ray diffraction, transmission electron microscopy, nitrogen sorption, and (29)Si solid-state NMR. The effect of the pore size, microporosity or mesoporosity, and wall thickness on the stability was discussed. The results show that all of the SBA-15 materials have a good hydrothermal stability under steam of 600 degrees C for at least 24 h. N(2) sorption measurements show that the Brumauer-Emmett-Teller surface area of SBA-15 materials is decreased by about 62% after treatment under steam at 600 degrees C for 24 h. The materials with thicker walls and more micropores show relatively better hydrothermal stability in steam of 600 degrees C. Interestingly, we found that the microporosity of the mesostructured silica SBA-15 is a very important factor for the hydrothermal stability. To the materials with more micropores, the recombination of Si-O-Si bonds during the high-temperature steam treatment may not cause direct destruction to the wall structure. As a result, SBA-15 materials with more micropores show better stability in pure steam of 600 degrees C. Nevertheless, these materials are easily destroyed in steam of 800 degrees C for 6 h. Two methods to effectively improve the hydrothermal stability are introduced here: one is a high-temperature treatment, and another is a carbon-propping thermal treatment. Thermal treatment at 900 degrees C can enhance the polymerization degree of Si-O-Si bonds and effectively improve the hydrothermal stability of these SBA-15 materials in 800 degrees C steam for 12 h. But, this approach will cause very serious shrinkage of the mesopores, resulting in smaller pore diameter and low surface area. A carbon-propping thermal treating method was employed to enhance the polymerization of Si-O-Si bonds and minimize the serious shrinkage of mesopores at the same time. It was demonstrated to be an effective method that can greatly improve the hydrothermal stability of SBA-15 materials in 800 degrees C steam for 12 h. Furthermore, the SBA-15 materials obtained by using the carbon-propping method possess larger pores and higher surface area after the steam treatment at 800 degrees C compared to the materials from the direct thermal treatment method after the steam treatment.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Ordered mesoporous molecular sieves synthesized by a liquid-crystal template mechanism
Kresge, C. T., Leonowicz, M. E., Roth, W. J., Vartuli, J. C., & Beck, J. S. (1992) · Nature · doi:10.1038/359710a0 · Cited by 16,275
Triblock Copolymer Syntheses of Mesoporous Silica with Periodic 50 to 300 Angstrom Pores
Zhao, D., Feng, J., Huo, Q., Melosh, N., Fredrickson, G. H., Chmelka, B. F., & Stucky, G. D. (1998) · Science · doi:10.1126/science.279.5350.548 · Cited by 11,753
Self-citationA new family of mesoporous molecular sieves prepared with liquid crystal templates
Beck, J. S., Vartuli, J. C., Roth, W. J., Leonowicz, M. E., Kresge, C. T., Schmitt, K. D., Chu, C. T. W., Olson, D. H., Sheppard, E. W., McCullen, S. B., et al. (1992) · Journal of the American Chemical Society · doi:10.1021/ja00053a020 · Cited by 10,967
Zhao, D., Huo, Q., Feng, J., Chmelka, B. F., & Stucky, G. D. (1998) · Journal of the American Chemical Society · doi:10.1021/ja974025i · Cited by 6,697
Self-citationSynthesis of New, Nanoporous Carbon with Hexagonally Ordered Mesostructure
Jun, S., Joo, S. H., Ryoo, R., Kruk, M., Jaroniec, M., Liu, Z., Ohsuna, T., & Terasaki, O. (2000) · Journal of the American Chemical Society · doi:10.1021/ja002261e · Cited by 2,424
Titanium-containing mesoporous molecular sieves for catalytic oxidation of aromatic compounds
Tanev, P. T., Chibwe, M., & Pinnavaia, T. J. (1994) · Nature · doi:10.1038/368321a0 · Cited by 1,774
Templating of Mesoporous Molecular Sieves by Nonionic Polyethylene Oxide Surfactants
Bagshaw, S. A., Prouzet, E., & Pinnavaia, T. J. (1995) · Science · doi:10.1126/science.269.5228.1242 · Cited by 1,556
Characterization of the porous structure of sba-15
Kruk, M., Jaroniec, M., Ko, C. H., & Ryoo, R. (2000) · Chemistry of Materials · doi:10.1021/cm000164e · Cited by 1,409
Corma, A., Navarro, M. T., & Pariente, J. P. (1994) · Journal of the Chemical Society, Chemical Communications · doi:10.1039/c39940000147 · Cited by 761
Ryoo, R., Ko, C. H., Kruk, M., Antochshuk, V., & Jaroniec, M. (2000) · The Journal of Physical Chemistry B · doi:10.1021/jp002597a · Cited by 657
Galarneau, A., Cambon, H., Di Renzo, F., Ryoo, R., Choi, M., & Fajula, F. (2003) · New Journal of Chemistry · doi:10.1039/b207378c · Cited by 559
Disordered Molecular Sieve with Branched Mesoporous Channel Network
Ryoo, R., Kim, J. M., Ko, C. H., & Shin, C. H. (1996) · The Journal of Physical Chemistry · doi:10.1021/jp9620835 · Cited by 461
Yu, C., Fan, J., Tian, B., Zhao, D., & Stucky, G. D. (2002) · Advanced Materials · doi:10.1002/1521-4095(20021203)14:23<1742::aid-adma1742>3.0.co;2-3 · Cited by 358
Self-citationIncorporation of Titanium into Mesoporous Silica Molecular Sieve SBA-15
Luan, Z., Maes, E. M., van der Heide, P. A. W., Zhao, D., Czernuszewicz, R. S., & Kevan, L. (1999) · Chemistry of Materials · doi:10.1021/cm9905141 · Cited by 337
Self-citationLiu, X., Tian, B., Yu, C., Gao, F., Xie, S., Tu, B., Che, R., Peng, L.-M., & Zhao, D. (2002) · Angewandte Chemie International Edition · doi:10.1002/1521-3773(20021018)41:20<3876::aid-anie3876>3.0.co;2-r · Cited by 281
Self-citationJoo, S. H., Ryoo, R., Kruk, M., & Jaroniec, M. (2002) · The Journal of Physical Chemistry B · doi:10.1021/jp013583n · Cited by 220
Liu, Y., & Pinnavaia, T. J. (2002) · Chemistry of Materials · doi:10.1021/cm0109544 · Cited by 190
Understanding of the Effect of Al Substitution on the Hydrothermal Stability of MCM-41
Shen, S., & Kawi, S. (1999) · The Journal of Physical Chemistry B · doi:10.1021/jp991831y · Cited by 152
Newalkar, B. L., & Komarneni, S. (2001) · Chemistry of Materials · doi:10.1021/cm0103038 · Cited by 136
Zeolite-Coated Mesostructured Cellular Silica Foams
On, D. T., & Kaliaguine, S. (2002) · Journal of the American Chemical Society · doi:10.1021/ja028656a · Cited by 130
Cited by
On the controllable soft-templating approach to mesoporous silicates
Wan, Y., & Zhao (2007) · Chemical Reviews · doi:10.1021/cr068020s · Cited by 2,371
Adsorption of heavy metals on functionalized-mesoporous silica: A review
Da'na, E. (2017) · Microporous and Mesoporous Materials · doi:10.1016/j.micromeso.2017.03.050 · Cited by 476
Application of nanoparticles in biofuels: An overview
Sekoai, P. T., Ouma, C. N. M., du Preez, S. P., Modisha, P., Engelbrecht, N., Bessarabov, D. G., & Ghimire, A. (2019) · Fuel · doi:10.1016/j.fuel.2018.10.030 · Cited by 384
Su, F., Zeng, J., Bao, X., Yu, Y., Lee, J. Y., & Zhao, X. S. (2005) · Chemistry of Materials · doi:10.1021/cm0502222 · Cited by 372
Designed synthesis of mesoporous solids via nonionic-surfactant-templating approach
Wan, Y., Shi, Y., & Zhao, D. (2007) · Chem. Commun. · doi:10.1039/b610570j · Cited by 326
Self-citation
Metadata
- Authors
- Zhang, F., Yan, Y., Yang, H., Meng, Y., Yu, C., Tu, B., & Zhao, D.
- Venue
- The Journal of Physical Chemistry B
- Publisher
- American Chemical Society (ACS)
- Published
- 2005-04-02
- Volume
- 109
- Issue
- 18
- Pages
- 8723-8732
- ISSN
- 1520-5207 (ISSN-L)
- 1520-6106
- OpenAlex
- W2013518565
- Cited by
- 316
- References
- 20
- FWCI
- 8.67
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.