The DOI matches its Crossref record; 30 of the 30 references it cites were found in a registry or an index.
Synthesis of High-Temperature Stable Anatase TiO2 Photocatalyst
Open accessAbstract
In the absence of a dopant or precursor modification, anatase to rutile transformation in synthetic TiO 2 usually occurs at a temperature of 600−700 °C. Conventionally, metal oxide dopants (e . g., Al 2 O 3 and SiO 2 ) are used to tune the anatase to rutile transformation. A simple methodology is reported here to extend the anatase rutile transformation by employing various concentrations of urea. XRD and Raman spectroscopy were used to characterize various phases formed during thermal treatment. A significantly higher anatase phase (97%) has been obtained at 800 °C with use of a 1:1 Ti(OPr) 4:urea composition and 11% anatase composition is retained even after calcining the powder at 900 °C. By comparison a sample that has been prepared without urea showed that rutile phases started to form at a temperature as low as 600 °C. The effect of smaller amounts of urea such as 1:0.25 and 1:0.5 Ti(OPr) 4:urea has also been studied and compared. The investigation concluded that the stoichiometric modification by urea 1:1 Ti(OPr) 4:urea composition is most effective in extending the anatase to rutile phase transformation by 200 °C compared to the unmodified sample. In addition, BET analysis carried out on samples calcined at 500 °C showed that the addition of urea up to 1:1 (Ti(OPr) 4:urea) increased the total pore volume (from 0.108 to 0.224 cm 3 /g) and average pore diameter (11 to 30 nm) compared to the standard sample. Samples prepared with 1:1 Ti(OPr) 4:urea composition calcined at 900 °C show significantly higher photocatalytic activity compared to the standard sample prepared under similar conditions. Kinetic analysis shows a marked increase in the photocatalytic degradation of rhodamine 6G on going from the standard sample (0.027 min -1, decoloration in 120 min) to the urea-modified sample (0.073 min -1, decoloration in 50 min).
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Environmental applications of semiconductor photocatalysis
Hoffmann, M. R., Martin, S. T., Choi, W., & Bahnemann, D. W. (1995) · Chemical Reviews · doi:10.1021/cr00033a004 · Cited by 18,495
Grätzel, M. (2001) · Nature · doi:10.1038/35104607 · Cited by 12,687
Titanium dioxide photocatalysis
Fujishima, A., Rao, T. N., & Tryk, D. A. (2000) · Journal of Photochemistry and Photobiology C: Photochemistry Reviews · doi:10.1016/s1389-5567(00)00002-2 · Cited by 7,916
Light-Induced Redox Reactions in Nanocrystalline Systems
Hagfeldt, A., & Graetzel, M. (1995) · Chemical Reviews · doi:10.1021/cr00033a003 · Cited by 5,357
Handbook of Chemistry and Physics
(1937) · Journal of AOAC INTERNATIONAL · doi:10.1093/jaoac/20.1.142a · Cited by 4,741
Photoinduced reactivity of titanium dioxide
CARP, O. (2004) · Progress in Solid State Chemistry · doi:10.1016/j.progsolidstchem.2004.08.001 · Cited by 4,566
Nitrogen-Concentration Dependence on Photocatalytic Activity of TiO2-xNx Powders
Irie, H., Watanabe, Y., & Hashimoto, K. (2003) · The Journal of Physical Chemistry B · doi:10.1021/jp030133h · Cited by 2,005
Quantitative Analysis of Anatase-Rutile Mixtures with an X-Ray Diffractometer
Spurr, R. A., & Myers, H. (1957) · Analytical Chemistry · doi:10.1021/ac60125a006 · Cited by 1,891
Parkin, I. P., & Palgrave, R. G. (2005) · Journal of Materials Chemistry · doi:10.1039/b412803f · Cited by 925
Visible Light Activity and Photoelectrochemical Properties of Nitrogen-Doped TiO2
Sakthivel, S., Janczarek, M., & Kisch, H. (2004) · The Journal of Physical Chemistry B · doi:10.1021/jp046857q · Cited by 729
Ag/AgBr/TiO2 Visible Light Photocatalyst for Destruction of Azodyes and Bacteria
Hu, C., Lan, Y., Qu, J., Hu, X., & Wang, A. (2006) · The Journal of Physical Chemistry B · doi:10.1021/jp0564400 · Cited by 578
Karakitsou, K. E., & Verykios, X. E. (1993) · The Journal of Physical Chemistry · doi:10.1021/j100108a014 · Cited by 519
Chen, X., Lou, Y. ‐., Samia, A. C. S., Burda, C., & Gole, J. L. (2005) · Advanced Functional Materials · doi:10.1002/adfm.200400184 · Cited by 421
Bakardjieva, S., Šubrt, J., Štengl, V., Dianez, M. J., & Sayagues, M. J. (2005) · Applied Catalysis B: Environmental · doi:10.1016/j.apcatb.2004.06.019 · Cited by 386
A web-based overview of semiconductor photochemistry-based current commercial applications
Mills, A., & Lee, S.-K. (2002) · Journal of Photochemistry and Photobiology A: Chemistry · doi:10.1016/s1010-6030(02)00243-5 · Cited by 366
Abe, R., Sayama, K., Domen, K., & Arakawa, H. (2001) · Chemical Physics Letters · doi:10.1016/s0009-2614(01)00790-4 · Cited by 361
Solar and photocatalytic disinfection of protozoan, fungal and bacterial microbes in drinking water
Lonnen, J., Kilvington, S., Kehoe, S. C., Al-Touati, F., & McGuigan, K. G. (2005) · Water Research · doi:10.1016/j.watres.2004.11.023 · Cited by 329
Room temperature synthesis of crystalline metal oxides
Gopal, M., Moberly Chan, W. J., & De Jonghe, L. C. (1997) · Journal of Materials Science · doi:10.1023/a:1018671212890 · Cited by 306
Ranjit, K. T., Willner, I., Bossmann, S. H., & Braun, A. M. (2001) · Environmental Science & Technology · doi:10.1021/es001613e · Cited by 294
YUAN, J., CHEN, M., SHI, J., & SHANGGUAN, W. (2006) · International Journal of Hydrogen Energy · doi:10.1016/j.ijhydene.2005.11.016 · Cited by 241
The anatase-rutile transition. Part 1.—Kinetics of the transformation of pure anatase
Czanderna, A. W., Rao, C. N. R., & Honig, J. M. (1958) · Transactions of the Faraday Society · doi:10.1039/tf9585401069 · Cited by 226
Yates, H. M., Nolan, M. G., Sheel, D. W., & Pemble, M. E. (2006) · Journal of Photochemistry and Photobiology A: Chemistry · doi:10.1016/j.jphotochem.2005.08.018 · Cited by 211
Preparation, Characterization, and Photoactivity of Polycrystalline Nanostructured TiO2 Catalysts
Addamo, M., Augugliaro, V., Di Paola, A., García-López, E., Loddo, V., Marcì, G., Molinari, R., Palmisano, L., & Schiavello, M. (2004) · The Journal of Physical Chemistry B · doi:10.1021/jp0312924 · Cited by 176
Mills, A. A., & Wang, J. (2006) · Journal of Photochemistry and Photobiology A Chemistry · doi:10.1016/j.jphotochem.2006.02.010 · Cited by 170
Anatase to rutile transformation in sol-gel titania by modification of precursor
Suresh, C. H., Biju, V. M., Mukundan, P., & Warrier, K. G. K. (1998) · Polyhedron · doi:10.1016/s0277-5387(98)00077-1 · Cited by 113
Yin, S., Aita, Y., Komatsu, M., & Sato, T. (2005) · Journal of the European Ceramic Society · doi:10.1016/j.jeurceramsoc.2005.05.012 · Cited by 83
Solar disinfection of contaminated water: a comparison of three small-scale reactors
McLoughlin, O. A., Kehoe, S. C., McGuigan, K. G., et al. (2004) · Solar Energy · doi:10.1016/j.solener.2004.07.004 · Cited by 73
Bokhimi, X., Morales, A. M., Novaro, O., López, T., Chimal, O., Asomoza, M., & Romero-Gómez, M. (1997) · Chemistry of Materials · doi:10.1021/cm970279r · Cited by 73
Selective synthesis of N-doped mesoporous TiO2 phases having enhanced photocatalytic activity
Gandhe, A. R., Naik, S. P., & Fernandes, J. B. (2005) · Microporous and Mesoporous Materials · doi:10.1016/j.micromeso.2005.07.017 · Cited by 54
Pillai, S. C., Boland, S. W., & Haile, S. M. (2004) · Journal of the American Ceramic Society · doi:10.1111/j.1151-2916.2004.tb07744.x · Cited by 9
Self-citation
Cited by
Semiconductor-based Photocatalytic Hydrogen Generation
Chen, X., Shen, S., Guo, L., & Mao, S. S. (2010) · Chemical Reviews · doi:10.1021/cr1001645 · Cited by 7,876
Visible-light activation of TiO2 photocatalysts: Advances in theory and experiments
Etacheri, V., Di Valentin, C., Schneider, J., Bahnemann, D., & Pillai, S. C. (2015) · Journal of Photochemistry and Photobiology C: Photochemistry Reviews · doi:10.1016/j.jphotochemrev.2015.08.003 · Cited by 1,475
Self-citationA Highly Efficient Ag-ZnO Photocatalyst: Synthesis, Properties, and Mechanism
Georgekutty, R., Seery, M. K., & Pillai, S. C. (2008) · The Journal of Physical Chemistry C · doi:10.1021/jp802729a · Cited by 845
Self-citationRecent advances in photocatalysis for environmental applications
Byrne, C., Subramanian, G., & Pillai, S. C. (2018) · Journal of Environmental Chemical Engineering · doi:10.1016/j.jece.2017.07.080 · Cited by 820
Self-citationSilver doped titanium dioxide nanomaterials for enhanced visible light photocatalysis
Seery, M. K., George, R., Floris, P., & Pillai, S. C. (2007) · Journal of Photochemistry and Photobiology A: Chemistry · doi:10.1016/j.jphotochem.2007.02.010 · Cited by 616
Self-citation
Metadata
- Authors
- Pillai, S. C., Periyat, P., George, R., McCormack, D. E., Seery, M. K., Hayden, H., Colreavy, J., Corr, D., & Hinder, S. J.
- Venue
- The Journal of Physical Chemistry C
- Publisher
- American Chemical Society (ACS)
- Published
- 2007-01-10
- Volume
- 111
- Issue
- 4
- Pages
- 1605-1611
- ISSN
- 1932-7447 (ISSN-L)
- 1932-7455
- OpenAlex
- W2055420617
- Cited by
- 292
- References
- 30
- FWCI
- 10.57
- Type
- journal article
- Language
- en
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.