The DOI matches its Crossref record; 9 of the 9 references it cites were found in a registry or an index.
Capillary Forces between Two Spheres with a Fixed Volume Liquid Bridge: Theory and Experiment
Abstract
Capillary forces are commonly encountered in nature because of the spontaneous condensation of liquid from surrounding vapor, leading to the formation of a liquid bridge. In most cases, the advent of capillary forces by condensation leads to undesirable events such as an increase in the strength of granules, which leads to flow problems and/or caking of powder samples. The prediction and control of the magnitude of capillary forces is necessary for eliminating or minimizing these undesirable events. The capillary force as a function of the separation distance, for a liquid bridge with a fixed volume in a sphere/plate geometry, was calculated using different expressions reported previously. These relationships were developed earlier, either on the basis of the total energy of two solid surfaces interacting through the liquid and the ambient vapor or by direct calculation of the force as a result of the differential gas pressure across the liquid bridge. It is shown that the results obtained using these methodologies (total energy or differential pressure) agree, confirming that a total-energy-based approach is applicable, despite the thermodynamic nonequilibrium conditions of a fixed volume bridge rupture process. On the basis of the formulas for the capillary force between a sphere and a plane surface, equations for the calculation of the capillary force between two spheres are derived in this study. Experimental measurements using an atomic force microscope (AFM) validate the formulas developed. The most common approach for transforming interaction force or energy from that of sphere/plate geometry to that of sphere/sphere geometry is the Derjaguin approximation. However, a comparison of the theoretical formulas derived in this study for the interaction of two spheres with those for sphere/plate geometry shows that the Derjaguin approximation is only valid at zero separation distance. This study attempts to explain the inapplicability of the Derjaguin approximation at larger separation distances. In particular, the area of a liquid bridge changes with the separation distance, H, and thereby does not permit the application of the "integral method," as used in the Derjaguin approximation.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Physical chemistry of surfaces
(1998) · Choice Reviews Online · doi:10.5860/choice.35-4499 · Cited by 11,648
Intermolecular and Surface Forces
(2011) · Elsevier eBooks · doi:10.1016/c2011-0-05119-0 · Cited by 8,968
Cleveland, J. P., Manne, S., Bocek, D., & Hansma, P. K. (1993) · Review of Scientific Instruments · doi:10.1063/1.1144209 · Cited by 1,642
Measurement of forces in liquids using a force microscope
Ducker, W. A., Senden, T. J., & Pashley, R. M. (1992) · Langmuir · doi:10.1021/la00043a024 · Cited by 1,080
Experimental studies on the applicability of the Kelvin equation to highly curved concave menisci
Fisher, L. R., & Israelachvili, J. N. (1981) · Journal of Colloid and Interface Science · doi:10.1016/0021-9797(81)90212-5 · Cited by 345
Particle−Surface Capillary Forces
de Lazzer, A., Dreyer, M., & Rath, H. J. (1999) · Langmuir · doi:10.1021/la981095+ · Cited by 152
Biggs, S., Cain, R. G., Dagastine, R. R., & Page, N. W. (2002) · Journal of Adhesion Science and Technology · doi:10.1163/156856102760136445 · Cited by 59
Measurement of oil-mediated particle adhesion to a silica substrate by atomic force microscopy
Rabinovich, Y. I., Esayanur, M. S., Johanson, K. D., Adler, J. J., & Moudgil, B. M. (2002) · Journal of Adhesion Science and Technology · doi:10.1163/156856102760136454 · Cited by 39
Self-citationUngar, G. (1934) · Colloid & Polymer Science · doi:10.1007/bf01433226 · Cited by 38
Cited by
Highly conductive and elastic nanomembrane for skin electronics
Jung, D., Lim, C., Shim, H. J., Kim, Y., Park, C., Jung, J., Han, S. I., Sunwoo, S.-H., Cho, K. W., Cha, G. D., et al. (2021) · Science · doi:10.1126/science.abh4357 · Cited by 403
Capillary-Force-Induced Cold Welding in Silver-Nanowire-Based Flexible Transparent Electrodes
Liu, Y., Zhang, J., Gao, H., Wang, Y., Liu, Q., Huang, S., Guo, C. F., & Ren, Z. (2017) · Nano Letters · doi:10.1021/acs.nanolett.6b04613 · Cited by 284
Confinement Capillarity of Thin Coating for Boosting Solar‐Driven Water Evaporation
Wang, Z., Wu, X., He, F., Peng, S., & Li, Y. (2021) · Advanced Functional Materials · doi:10.1002/adfm.202011114 · Cited by 277
Li, X., Li, M., Xu, J., You, J., Yang, Z., & Li, C. (2019) · Nature Communications · doi:10.1038/s41467-019-11466-5 · Cited by 267
The Integument of Water-walking Arthropods: Form and Function
Bush, J. W. M., Hu, D. L., & Prakash, M. (2007) · Advances in Insect Physiology · doi:10.1016/s0065-2806(07)34003-4 · Cited by 258
Metadata
- Authors
- Rabinovich, Y. I., Esayanur, M. S., & Moudgil, B. M.
- Venue
- Langmuir
- Publisher
- American Chemical Society (ACS)
- Published
- 2005-10-05
- Volume
- 21
- Issue
- 24
- Pages
- 10992-10997
- ISSN
- 0743-7463 (ISSN-L)
- 1520-5827
- OpenAlex
- W1989337945
- Cited by
- 463
- References
- 9
- FWCI
- 11.85
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.