The DOI matches its Crossref record; 3 of the 3 references it cites were found in a registry or an index.
Effect of High Salt Concentrations on the Stabilization of Bubbles by Silica Particles
Abstract
The stabilization of air bubbles by hydrophobically modified silica particles has been investigated in detail. The silica particles used had a nominal primary particle size of 20 nm and were made hydrophobic by treatment with dichlorodimethylsilane to yield particles with varying percent grafting of alkyl chains ("% SiOR"). Contact-angle (theta) measurements of pure water droplets on flats made from compressed samples of the particles showed a steep increase in theta above ca. 20% SiOR. Other measurements also showed a significant increase in theta when the salt concentration was raised to 1-3 mol dm(-3). Bubbles were formed in a sonicated dispersion of particles by suddenly lowering the pressure. Maximum stability was obtained with 33% SiOR particles and 2-3 mol dm(-3) NaCl. Under these conditions, theta was around 40 degrees. Above a threshold size of around 70 microm, bubbles were extremely stable to disproportionation and coalescence and bubble stability increased significantly with an increase in the NaCl concentration from 0.5 to 3 mol dm(-3). Furthermore, rheological measurements showed that at NaCl concentrations in this range weak particle gels were formed with a finite yield stress. The strength of these gels increased with an increasing NaCl concentration between 0.5 and 3 mol dm(-3) and with an increasing time of aging the dispersions, implicating this as part of the mechanism leading to an increased bubble stability in these systems. Dispersions in the absence of NaCl showed little or no foamability at all. Use of CaCl2 and Al(NO)3 at similar ionic strengths showed that equivalent stability could not be obtained with these salts. Atomic force microscopy (AFM) measurements of the adhesion between a pure (0% SiOR) silica sphere and flat showed a significant increase in the adhesion between 0.5 and 3 mol dm(-3) NaCl, even though in this concentration range no significant change in the electrostatic repulsion might be expected. It is concluded that the increased particle-particle adhesion, effective hydrophobicity, and bubble-stabilization properties of the particles at high NaCl concentrations are probably due to the collapse of protruding polysilicic acid chains on the surface of the silica.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Israelachvili, J. N., & Adams, G. E. (1978) · Journal of the Chemical Society, Faraday Transactions 1: Physical Chemistry in Condensed Phases · doi:10.1039/f19787400975 · Cited by 1,812
Electrolyte Species Dependent Hydration Forces between Silica Surfaces
Chapel, J.-P. (1994) · Langmuir · doi:10.1021/la00023a053 · Cited by 195
Adhesion between Silica Particle and Mica Surfaces in Water and Electrolyte Solutions
Vakarelski, I. U., Ishimura, K., & Higashitani, K. (2000) · Journal of Colloid and Interface Science · doi:10.1006/jcis.2000.6884 · Cited by 109
Cited by
The role of particles in stabilising foams and emulsions
Hunter, T. N., Pugh, R. J., Franks, G. V., & Jameson, G. J. (2008) · Advances in Colloid and Interface Science · doi:10.1016/j.cis.2007.07.007 · Cited by 1,063
Rio, E., Drenckhan, W., Salonen, A., & Langevin, D. (2014) · Advances in Colloid and Interface Science · doi:10.1016/j.cis.2013.10.023 · Cited by 290
Magnetic Pickering Emulsions Stabilized by Fe3O4 Nanoparticles
Zhou, J., Qiao, X., Binks, B. P., Sun, K., Bai, M., Li, Y., & Liu, Y. (2011) · Langmuir · doi:10.1021/la1036844 · Cited by 278
Metadata
- Authors
- Kostakis, T., Ettelaie, R., & Murray, B. S.
- Venue
- Langmuir
- Publisher
- American Chemical Society (ACS)
- Published
- 2006-01-01
- Volume
- 22
- Issue
- 3
- Pages
- 1273-1280
- ISSN
- 0743-7463 (ISSN-L)
- 1520-5827
- OpenAlex
- W1972535039
- Cited by
- 158
- References
- 3
- FWCI
- 6.08
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.