The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.
Microdroplet Growth Mechanism during Water Condensation on Superhydrophobic Surfaces
Abstract
By promoting dropwise condensation of water, nanostructured superhydrophobic coatings have the potential to dramatically increase the heat transfer rate during this phase change process. As a consequence, these coatings may be a facile method of enhancing the efficiency of power generation and water desalination systems. However, the microdroplet growth mechanism on surfaces which evince superhydrophobic characteristics during condensation is not well understood. In this work, the sub-10 μm dynamics of droplet formation on nanostructured superhydrophobic surfaces are studied experimentally and theoretically. A quantitative model for droplet growth in the constant base (CB) area mode is developed. The model is validated using optimized environmental scanning electron microscopy (ESEM) imaging of microdroplet growth on a superhydrophobic surface consisting of immobilized alumina nanoparticles modified with a hydrophobic promoter. The optimized ESEM imaging procedure increases the image acquisition rate by a factor of 10-50 as compared to previous research. With the improved imaging temporal resolution, it is demonstrated that nucleating nanodroplets coalesce to create a wetted flat spot with a diameter of a few micrometers from which the microdroplet emerges in purely CB mode. After the droplet reaches a contact angle of 130-150°, its base diameter increases in a discrete steplike fashion. The droplet height does not change appreciably during this steplike base diameter increase, leading to a small decrease of the contact angle. Subsequently, the drop grows in CB mode until it again reaches the maximum contact angle and increases its base diameter in a steplike fashion. This microscopic stick-and-slip motion can occur up to four times prior to the droplet coalescence with neighboring drops. Lastly, the constant contact angle (CCA) and the CB growth models are used to show that modeling formation of a droplet with a 150° contact angle in the CCA mode rather than in the CB mode severely underpredicts both the drop formation time and the average heat transfer rate through the drop.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Wettability of porous surfaces
Cassie, A. B. D., & Baxter, S. (1944) · Transactions of the Faraday Society · doi:10.1039/tf9444000546 · Cited by 13,807
Cited by
Jumping-Droplet-Enhanced Condensation on Scalable Superhydrophobic Nanostructured Surfaces
Miljkovic, N., Enright, R., Nam, Y., Lopez, K., Dou, N., Sack, J., & Wang, E. N. (2013) · Nano Letters · doi:10.1021/nl303835d · Cited by 1,143
Delayed Frost Growth on Jumping-Drop Superhydrophobic Surfaces
Boreyko, J. B., & Collier, C. P. (2013) · ACS Nano · doi:10.1021/nn3055048 · Cited by 568
Recent advances in the potential applications of bioinspired superhydrophobic materials
Darmanin, T., & Guittard, F. (2014) · J. Mater. Chem. A · doi:10.1039/c4ta02071e · Cited by 555
Recurrent Filmwise and Dropwise Condensation on a Beetle Mimetic Surface
Hou, Y., Yu, M., Chen, X., Wang, Z., & Yao, S. (2015) · ACS Nano · doi:10.1021/nn505716b · Cited by 527
Condensation heat transfer on superhydrophobic surfaces
Miljkovic, N., & Wang, E. N. (2013) · MRS Bulletin · doi:10.1557/mrs.2013.103 · Cited by 410
Antifogging abilities of model nanotextures
Mouterde, T., Lehoucq, G., Xavier, S., Checco, A., Black, C. T., Rahman, A., Midavaine, T., Clanet, C., & Quéré, D. (2017) · Nature Materials · doi:10.1038/nmat4868 · Cited by 398
Mechanism of Frost Formation on Lubricant-Impregnated Surfaces
Rykaczewski, K., Anand, S., Subramanyam, S. B., & Varanasi, K. K. (2013) · Langmuir · doi:10.1021/la400801s · Cited by 376
Self-citationSurface engineering for phase change heat transfer: A review
Attinger, D., Frankiewicz, C., Betz, A. R., Schutzius, T. M., Ganguly, R., Das, A., Kim, C.-J., & Megaridis, C. M. (2014) · MRS Energy & Sustainability · doi:10.1557/mre.2014.9 · Cited by 376
Environmental Applications of Interfacial Materials with Special Wettability
Wang, Z., Elimelech, M., & Lin, S. (2016) · Environmental Science & Technology · doi:10.1021/acs.est.5b04351 · Cited by 352
Bioinspired Engineering of Thermal Materials
Tao, P., Shang, W., Song, C., Shen, Q., Zhang, F., Luo, Z., Yi, N., Zhang, D., & Deng, T. (2015) · Advanced Materials · doi:10.1002/adma.201401449 · Cited by 311
Modeling and Optimization of Superhydrophobic Condensation
Miljkovic, N., Enright, R., & Wang, E. N. (2013) · Journal of Heat Transfer · doi:10.1115/1.4024597 · Cited by 289
Liquid-Vapor Phase-Change Heat Transfer on Functionalized Nanowired Surfaces and Beyond
Wen, R., Ma, X., Lee, Y.-C., & Yang, R. (2018) · Joule · doi:10.1016/j.joule.2018.08.014 · Cited by 280
Dropwise Condensation on Micro- and Nanostructured Surfaces
Enright, R., Miljkovic, N., Alvarado, J. L., Kim, K., & Rose, J. W. (2014) · Nanoscale and Microscale Thermophysical Engineering · doi:10.1080/15567265.2013.862889 · Cited by 278
Durán, I. R., & Laroche, G. (2019) · Progress in Materials Science · doi:10.1016/j.pmatsci.2018.09.001 · Cited by 273
Electrostatic charging of jumping droplets
Miljkovic, N., Preston, D. J., Enright, R., & Wang, E. N. (2013) · Nature Communications · doi:10.1038/ncomms3517 · Cited by 261
Droplet Jumping: Effects of Droplet Size, Surface Structure, Pinning, and Liquid Properties
Yan, X., Zhang, L., Sett, S., Feng, L., Zhao, C., Huang, Z., Vahabi, H., Kota, A. K., Chen, F., & Miljkovic, N. (2019) · ACS Nano · doi:10.1021/acsnano.8b06677 · Cited by 193
Metadata
- Authors
- Rykaczewski, K.
- Venue
- Langmuir
- Publisher
- American Chemical Society (ACS)
- Published
- 2012-05-10
- Volume
- 28
- Issue
- 20
- Pages
- 7720-7729
- ISSN
- 0743-7463 (ISSN-L)
- 1520-5827
- OpenAlex
- W2317585501
- Cited by
- 196
- References
- 1
- FWCI
- 7.64
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.