Effect of Chain Entanglements on Plastic Deformation Behavior of Linear Polyethylene
The DOI matches its Crossref record; 27 of the 28 references it cites were found in a registry or an index.
Abstract
Samples of semicrystalline polyethylene in which the chain topology within the amorphous component was altered by using two-stage processing, including crystallization in a chain-extended fashion at high pressure in the first step, were produced, and their deformation behavior in the plane-strain compression was studied. The deformation and recovery experiments evidenced that the state of the molecular network governed by entanglements density is one of the key parameters controlling the response of the material on imposed strain, especially in the range of moderate and high strains. It influences markedly the shape of the true stress−true strain curve, changing the strain hardening modulus and the onset of strong strain hardening. The strain hardening modulus decreases while onset of strong strain hardening increases with a decrease of the entanglement density within amorphous component. Depending on the density of entanglements, PE samples demonstrated various amount of rubberlike recoverable deformation and permanent plastic flow. In the case of reduced concentration of entanglements the permanent flow was easier than in materials with higher entanglement density and could set in quite early, at relatively low strains, becoming a favorable deformation mechanism. As a result, the strong strain hardening was postponed to higher strains as compared to samples of equilibrium entanglement density. When the topology of amorphous component was modified to increase the network density, that network became stiffer with reduced ability of strain-induced disentangling of chains. Consequently, there was relatively less permanent flow and strain hardening begun earlier than in the reference material of unaltered chain topology.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“Moreover, the contributions of rubber-like recoverable deformation and permanent plastic flow depend directly on the actual network density, which is possibly reduced at high strain due to resolving of entanglements [19].”
From Erosion of the molecular network in the amorphous layers of polyethylene upon high-strain deformation (2016) · cites this paper as [19]
In the citing paper
“Our previous studies supported the Strobl's view on the deformation sequence and confirmed a direct correlation between concentration of entanglements and the deformation behavior, especially at high strains, in the strain hardening range, [3,10,15,19,20].”
From Erosion of the molecular network in the amorphous layers of polyethylene upon high-strain deformation (2016) · cites this paper as [19]
Citations
Cites
A three-dimensional constitutive model for the large stretch behavior of rubber elastic materials
Arruda, E. M., & Boyce, M. C. (1993) · Journal of the Mechanics and Physics of Solids · doi:10.1016/0022-5096(93)90013-6 · Cited by 3,239
Principles of polymer chemistry
Oster, G. (1954) · Journal of Chemical Education · doi:10.1021/ed031p669.2 · Cited by 2,503
An improved permanganic etchant for polyolefines
Olley, R. H., & Bassett, D. C. (1982) · Polymer · doi:10.1016/0032-3861(82)90110-0 · Cited by 609
Deformation mechanisms in crystalline polymers
Bowden, P. B., & Young, R. J. (1974) · Journal of Materials Science · doi:10.1007/bf00540553 · Cited by 551
Hiss, R., Hobeika, S., Lynn, C., & Strobl, G. (1999) · Macromolecules · doi:10.1021/ma981776b · Cited by 540
A study of equilibrium melting of polyethylene
Wunderlich, B., & Czornyj, G. (1977) · Macromolecules · doi:10.1021/ma60059a006 · Cited by 518
A Pad� approximant to the inverse Langevin function
Cohen, A. (1991) · Rheologica Acta · doi:10.1007/bf00366640 · Cited by 476
The physics of polymers: concepts for understanding their structures and behavior
(1997) · Choice Reviews Online · doi:10.5860/choice.34-2811 · Cited by 434
Strain hardening of thermoplastics
Haward, R. N. (1993) · Macromolecules · doi:10.1021/ma00074a006 · Cited by 326
A high-pressure phase of polyethylene and chain-extended growth
Bassett, D. C., Block, S., & Piermarini, G. J. (1974) · Journal of Applied Physics · doi:10.1063/1.1663028 · Cited by 302
Research works printed but not linked: 27
- Hoff E. A. W., 1952, J. Appl. Chem., 2, 448
- Haward R. N., 1967, Proc. R. Soc. London A, 302, 472
- Haward R. N. J., 1994, Part B: Polym. Phys
- Arridge R. G. C., 1977, J. Polym. Sci., Polym. Phys. Ed., 15, 401
- Bastiaansen C. W. M., 1990, J. Polymer, 31, 1439
- Lemstra P. J., 2000, Structure Formation in Polymeric Fibres
- Fu Q., 2003, Polymer, 44, 1933
- Fu Q., 2003, Polymer, 44, 1947
- Men Y., 2001, J. Macromol. Sci., Phys. B, 40, 796
- Al-Hussein M., 2002, Macromolecules, 35, 8520
- Schrauwen B. A. G., 2004, Macromolecules, 37, 6078
- Maxwell A. S., 1996, Polymer, 37, 3301
- Prime R. B., 1969, Part A2: Polym. Phys
- Geil P. H., 1964, Part A: Gen. Pap
- Rees D. V., 1971, Part A2: Polym. Phys
- Gruner C. L., 1969, Part A2: Polym. Phys
- Yasuniwa M., 1997, Part B: Polym. Phys
- Basset D. C., 1981, Proc. R. Soc. London A, 377, 29
- Pearson D. S., 1994, Macromolecules, 27, 719
- Boyd R. H., 1985, Polymer, 26, 1133
- Lin L., 1994, J. Mater. Sci., 29, 323
- Oleinik E. F., 2003, J. Polym. Sci., Ser. C, 45, 117
- Young R., 1988, J. Mater. Forum, 11, 216
- Brooks N. W. J., 2000, Polymer, 41, 1480
- Sirotkin R. O., 2001, Polymer, 42, 3797
- Kazmierczak T., 12th Int. Conference ‘Deformation Yield and Fracture of Polymers; IOM Communication: Cambridge
- van Dommelen J. A. W., 2003, J. Mech. Phys. Solids, 51, 541
Cited by
Control of Polymer Properties by Entanglement: A Review
Kong, D., Yang, M., Zhang, X., Du, Z., Fu, Q., Gao, X., & Gong, J. (2021) · Macromolecular Materials and Engineering · doi:10.1002/mame.202100536 · Cited by 242
Strain hardening of polymer glasses: Effect of entanglement density, temperature, and rate
Hoy, R. S., & Robbins, M. O. (2006) · Journal of Polymer Science Part B: Polymer Physics · doi:10.1002/polb.21012 · Cited by 219
Fatigue analysis of FDM materials
Lee, J., & Huang, A. (2013) · Rapid Prototyping Journal · doi:10.1108/13552541311323290 · Cited by 161
Humbert, S., Lame, O., & Vigier, G. (2009) · Polymer · doi:10.1016/j.polymer.2009.05.017 · Cited by 174
Krishnaswamy, R. K., Yang, Q., Fernandez-Ballester, L., & Kornfield, J. A. (2008) · Macromolecules · doi:10.1021/ma070454h · Cited by 169
Metadata
- Authors
- Bartczak, Z.
- Affiliations
- Centrum Badań Molekularnych i Makromolekularnych Polskiej Akademii Nauk (PL)
- Corresponding author
- Bartczak, Z.
- ORCID
- Bartczak, Z.
- Venue
- Macromolecules
- Publisher
- American Chemical Society (ACS)
- Published
- 2005-08-13
- Volume
- 38
- Issue
- 18
- Pages
- 7702-7713
- ISSN
- 0024-9297 (ISSN-L)
- 1520-5835
- OpenAlex
- W1966408714
- Cited by
- 116
- References
- 28
- Citations by year
- 2026: 6 · 2025: 7 · 2024: 8 · 2023: 3 · 2022: 4 · 2021: 8 · 2020: 5 · 2019: 9 · 2018: 8 · 2017: 6 · 2016: 7 · 2015: 5 · 2014: 3 · 2013: 3 · 2012: 5
- FWCI
- 4.03
- Type
- journal article
- Language
- en
- Open access
- closed
- Locations
- Macromolecules (publishedVersion)
- Topics
- Physical Sciences › Materials Science › Polymers and Plastics › Polymer crystallization and properties
- Physical Sciences › Chemical Engineering › Fluid Flow and Transfer Processes › Rheology and Fluid Dynamics Studies
- Physical Sciences › Materials Science › Metals and Alloys › Microstructure and mechanical properties
- Keywords
- chain entanglement, linear polyethylene, semicrystalline polymers, plastic deformation, plane strain compression, strain hardening, entanglement density, chain extension, two-stage process, reversible deformation, disentanglement
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.