Student or educator? Sign up with your school email and get 6 months of Pro free.
Cited by 252

The DOI matches its Crossref record; 43 of the 43 references it cites were found in a registry or an index.

Athena MIMOS II Mössbauer spectrometer investigation

Open access
Klingelhöfer, G., Morris, R. V., Bernhardt, B., Rodionov, D., de Souza, P. A., Squyres, S. W., Foh, J., Kankeleit, E., Bonnes, U., Gellert, R., Schröder, C., Linkin, S., Evlanov, E., Zubkov, B., Prilutski, O. · 2003 · Journal of Geophysical Research: Planets

Abstract

Mössbauer spectroscopy is a powerful tool for quantitative mineralogical analysis of Fe‐bearing materials. The miniature Mössbauer spectrometer MIMOS II is a component of the Athena science payload launched to Mars in 2003 on both Mars Exploration Rover missions. The instrument has two major components: (1) a rover‐based electronics board that contains power supplies, a dedicated central processing unit, memory, and associated support electronics and (2) a sensor head that is mounted at the end of the instrument deployment device (IDD) for placement of the instrument in physical contact with soil and rock. The velocity transducer operates at a nominal frequency of ∼25 Hz and is equipped with two 57 Co/Rh Mössbauer sources. The reference source (∼5 mCi landed intensity), reference target (α‐Fe 2 O 3 plus α‐Fe 0), and PIN‐diode detector are configured in transmission geometry and are internal to the instrument and used for its calibration. The analysis Mössbauer source (∼150 mCi landed intensity) irradiates Martian surface materials with a beam diameter of ∼1.4 cm. The backscatter radiation is measured by four PIN‐diode detectors. Physical contact with surface materials is sensed with a switch‐activated contact plate. The contact plate and reference target are instrumented with temperature sensors. Assuming ∼18% Fe for Martian surface materials, experiment time is 6–12 hours during the night for quality spectra (i.e., good counting statistics); 1–2 hours is sufficient to identify and quantify the most abundant Fe‐bearing phases. Data stored internal to the instrument for selectable return to Earth include Mössbauer and pulse‐height analysis spectra (512 and 256 channels, respectively) for each of the five detectors in up to 13 temperature intervals (65 Mössbauer spectra), engineering data for the velocity transducer, and temperature measurements. The total data volume is ∼150 kB. The mass and power consumption are ∼500 g (∼400 g for the sensor head) and ∼2 W, respectively. The scientific measurement objectives of the Mössbauer investigation are to obtain for rock, soil, and dust (1) the mineralogical identification of iron‐bearing phases (e.g., oxides, silicates, sulfides, sulfates, and carbonates), (2) the quantitative measurement of the distribution of iron among these iron‐bearing phases (e.g., the relative proportions of iron in olivine, pyroxenes, ilmenite, and magnetite in a basalt), (3) the quantitative measurement of the distribution of iron among its oxidation states (e.g., Fe 2+, Fe 3+, and Fe 6+), and (4) the characterization of the size distribution of magnetic particles. Special geologic targets of the Mössbauer investigation are dust collected by the Athena magnets and interior rock and soil surfaces exposed by the Athena Rock Abrasion Tool and by trenching with rover wheels.

Overview

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1029/2003je002138

Cites

43 of 43 references verified0 citation errors · 0 not checkable

Statistics

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Show all 43 references

Cited by

See all 252

Metadata

Authors
Klingelhöfer, G., Morris, R. V., Bernhardt, B., Rodionov, D., de Souza, P. A., Squyres, S. W., Foh, J., Kankeleit, E., Bonnes, U., Gellert, R., Schröder, C., Linkin, S., Evlanov, E., Zubkov, B., & Prilutski, O.
Venue
Journal of Geophysical Research: Planets
Published
2003-12
Volume
108
Issue
E12
ISSN
0148-0227 (ISSN-L)
OpenAlex
W2103811807
Cited by
252
References
43
FWCI
10.44
Type
journal article
Language
en
Open access
bronze

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

How to cite

Cite CoChat for the checks on this page, and the paper for its own findings.

This page
CoChat. (2026). Citation check: Athena MIMOS II Mössbauer spectrometer investigation. https://app.cochat.ai/papers/10.1029/2003je002138
The paper
Klingelhöfer, G., Morris, R. V., Bernhardt, B., Rodionov, D., de Souza, P. A., Squyres, S. W., Foh, J., Kankeleit, E., Bonnes, U., Gellert, R., Schröder, C., Linkin, S., Evlanov, E., Zubkov, B., & Prilutski, O. (2003). Athena MIMOS II Mössbauer spectrometer investigation. Journal of Geophysical Research: Planets. https://doi.org/10.1029/2003je002138

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.