The DOI matches its Crossref record; 4 of the 4 references it cites were found in a registry or an index.
Fault zone restrengthening and frictional healing: The role of pressure solution
Abstract
Laboratory and field observations note the significant role of strength recovery (healing) on faults during interseismic periods and implicate pressure solution as a plausible mechanism. Plausible rates for pressure solution to activate, and the magnitudes of ultimate strength gain, are examined through slide‐hold‐slide experiments using simulated quartz gouge. Experiments are conducted on fine‐grained (110 μm) granular silica gouge, saturated with deionized water, confined under constant normal stress of 5 MPa and at modest temperatures of 20 and 65°C, and sheared at a maximum rate of 20 μm/s. Data at 20°C show a log linear relation between strength gain and the duration of holding periods, whereas the higher temperature observations indicate higher healing rates than the log linear dependencies; these are apparent for hold times greater than ∼1000 s. This behavior is attributed to the growth and welding of grain contact areas, mediated by pressure solution. The physical dependencies of this behavior are investigated through a mechanistic model incorporating the serial processes of grain contact dissolution, grain boundary diffusion, and precipitation at the rim of contacts. We use the model to predict strength gain for arbitrary conditions of mean stress, fluid pressure, and temperature. The strength gain predicted under the experimental conditions (σeff = 5 MPa and T = 65°C) underestimates experimental measurements for hold periods of less than ∼1000 s where other frictional mechanisms contribute to strength gain. Beyond this threshold, laboratory observations resemble the trend in the prediction by our mechanistic model, implicating that pressure solution is likely the dominant mechanism for strength gain. The model is applied to the long‐term prediction of healing behavior in quartzite fault zones. Predictions show that both rates and magnitudes of gain in contact area increase with an increase in applied stresses and temperatures and that fault healing aided by pressure solution should reach completion within recurrence interval durations ranging from <1 to ∼10 4 years, depending on applied stresses, temperatures, and reaction rates.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Pressure solution and the force of crystallization: a phenomenological theory
Weyl, P. K. (1959) · Journal of Geophysical Research · doi:10.1029/jz064i011p02001 · Cited by 593
Kinetics of quartz dissolution in electrolyte solutions using a hydrothermal mixed flow reactor
Dove, P. M., & Crerar, D. A. (1990) · Geochimica et Cosmochimica Acta · doi:10.1016/0016-7037(90)90431-j · Cited by 463
Hydration forces between mica surfaces in electrolyte solutions
Pashley, R. M. (1982) · Advances in Colloid and Interface Science · doi:10.1016/0001-8686(82)85006-9 · Cited by 309 · cited 2×
“At all depths an initial grain diameter, d, is set to 110 mm, and a constant water film thickness, w, of 4.0 nm is assumed, although this thickness may be a function of applied stress [ Pashley, 1982; Horn et al., 1989].”
BackgroundInfluentialMurphy, W. M., & Helgeson, H. C. (1989) · American Journal of Science · doi:10.2475/ajs.289.1.17 · Cited by 95
Cited by
Faulkner, D. R., Jackson, C. A. L., Lunn, R. J., Schlische, R. W., Shipton, Z. K., Wibberley, C. A. J., & Withjack, M. O. (2010) · Journal of Structural Geology · doi:10.1016/j.jsg.2010.06.009 · Cited by 1,513
The Role of Pressure Solution Creep in the Ductility of the Earth’s Upper Crust
Gratier, J.-P., Dysthe, D. K., & Renard, F. (2013) · Advances in Geophysics · doi:10.1016/b978-0-12-380940-7.00002-0 · Cited by 298
Metadata
- Authors
- Yasuhara, H., Marone, C., & Elsworth, D.
- Venue
- Journal of Geophysical Research: Solid Earth
- Publisher
- American Geophysical Union (AGU)
- Published
- 2005-06
- Volume
- 110
- Issue
- B6
- ISSN
- 0148-0227 (ISSN-L)
- OpenAlex
- W2127880838
- Cited by
- 177
- References
- 4
- FWCI
- 4.75
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.