Student or educator? Sign up with your school email and get 6 months of Pro free.
Cited by 168

The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.

Ductile creep, compaction, and rate and state dependent friction within major fault zones

Sleep, Norman H.·1995·Journal of Geophysical Research: Solid Earth

Abstract

The shear traction on major strike‐slip faults during earthquakes is much lower than that expected on a frictionally sliding surface in equilibrium with hydrostatic pressure. The low shear traction is explained if the fluid pressure at the time of the earthquake is much greater than hydrostatic pressure. Ductile creep within mostly sealed fault zones compacts the matrix and thus increases fluid pressure between earthquakes. Frictional dilatancy during earthquakes decreases fluid pressure below hydrostatic, and over the earthquake cycle, the fault zone is in long‐term equilibrium with the country rock. This ductile mechanism is formally unified with rate and state theory for time‐dependent friction when the difference between a critical porosity where the rock loses all strength and the actual porosity of cracks is used as a state variable. This choice is justified by percolation theory of mostly broken lattices. Time‐dependent behavior associated with changes in normal traction in the laboratory is explained by the formalism. Instability (earthquakes) sometimes occurs in the numerical experiments. However, fairly small amounts of frictional dilatancy during initial frictional creep decrease fluid pressure and preclude unstable sliding. Two coupled mechanisms for producing dilatancy on faults once an instability is well underway are evident. (1) Expansion of pore fluids associated with frictional heating increases fluid pressure offsetting the effects of increased pore volume during earthquakes. There is some tendency for pore volume increase to balance fluid expansion so that fluid pressure stays relatively constant. (2) Production of isolated voids that do not immediately decrease fluid pressure throughout the fault zone during earthquakes can occur to the extent that the fault zone is not significantly strengthened. Although the extent of both processes is constrained by energy considerations, the variation of fluid pressure during earthquakes is not yet well enough understood to predict stress drop from observable material properties.

Overview

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1029/94jb03340

Cites

1 of 1 references verified0 citation errors · 0 not checkable

Statistics

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Cited by

See all 168

Metadata

Authors
Sleep, N. H.
Venue
Journal of Geophysical Research: Solid Earth
Published
1995-07-10
Volume
100
Issue
B7
Pages
13065-13080
ISSN
0148-0227 (ISSN-L)
OpenAlex
W2140594016
Cited by
168
References
1
FWCI
8.31
Type
journal article
Language
en
Open access
closed

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.