CoChat

Shock recovery experiments on dolomite and thermodynamical calculations of impact induced decarbonation

Martinez, Isabelle, Deutsch, Alexander, Schärer, Urs, Ildefonse, Philippe, Guyot, François, Agrinier, Pierre · 1995 · Journal of Geophysical Research: Solid Earth
Cited by 57

The DOI matches its Crossref record; 3 of the 3 references it cites were found in a registry or an index.

Abstract

We have studied experimentally shocked dolomites and calcites by scanning electron microscopy (SEM), analytical transmission electron microscopy (ATEM), X ray diffractometry (XRD) using Rietveld refinements, and mass spectrometry analysis of the abundance ratios of the stable isotopes of carbon and oxygen. The shock‐recovery experiments have been perfomed by the multiple reverberation technique on natural dolomite rocks at 60 GPa, using steel devices and high‐explosive driver‐flyer plates as plane shock wave generators. Modified assemblies with grooves and holes were built in order to facilitate the escape of CO 2, in case the conditions of breakdown of the carbonates into oxides and CO 2 would be reached during the shock or postshock history of the samples. In contrast with the results from previous studies, almost no evidence for outgassing, expressed, for example, by the identification of CaO or MgO, could be observed. Consequently, no isotope fractionation occured in the shocked samples. This result is consistent with the calculations of peak‐shock and postshock temperatures, as well as with the examination of outgassing conditions of carbonates, calculated in this study up to 80 GPa. We have shown that in a direct shock, outgassing in air of nonporous dolomites and calcites should occur in impacts at 55–65 GPa and 35–45 GPa, respectively. The effect of porosity, which strongly lowers these values, has been estimated. The experimental setup for shock‐recovery experiments is shown to be an important parameter: reverberated shocks lead to lower peak‐shock and postshock temperatures than direct shocks at the same pressure; differences among experimental setups might explain part of the discrepancies between previous studies. In this study, the only surviving shock‐induced phenomenon is pulverization leading to grain sizes smaller than in the starting material. The decrease in grain size has been quantified via a structure refinement by Rietveld analysis of X ray powder patterns, which also allows the estimation of the lattice strains. A future pressure scale of shock effects in carbonates could probably be based on such parameters.

Overview

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1029/95jb01151

Cites

3 of 3 references verified0 citation errors · 0 not checkable

Statistics

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Cited by

See all 57

Metadata

Authors
Martinez, I., Deutsch, A., Schärer, U., Ildefonse, P., Guyot, F., & Agrinier, P.
Venue
Journal of Geophysical Research: Solid Earth
Published
1995-08-10
Volume
100
Issue
B8
Pages
15465-15476
ISSN
0148-0227 (ISSN-L)
OpenAlex
W1973999510
Cited by
57
References
3
FWCI
2.53
Type
journal article
Language
en
Open access
closed

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.