The DOI matches its Crossref record; 2 of the 2 references it cites were found in a registry or an index.
In situ observations of particles in jet aircraft exhausts and contrails for different sulfur‐containing fuels
Abstract
The impact of sulfur oxides on particle formation and contrails is investigated in the exhaust plumes of a twin‐engine jet aircraft. Different fuels were used with sulfur mass fractions of 170 and 5500 ppm in the fuel, one lower than average, the other above the specification limit of standard Jet‐Al fuel. During various phases of the same flight, the two engines burnt either high‐ or low‐sulfur fuel or different fuels in the two engines. Besides visual, photographic, and video observations from close distance, in situ measurements were made within the plumes at plume ages of 20 to 30 s, at altitudes between 9 and 9.5 km, and temperatures between −49 and −55°C, when the visible contrail was about 2 km long. The data include particle number densities for particles larger than 7 nm, 18 nm, 120 nm, and 1 μm in diameter, together with wind, temperature and humidity measurements. The observations show visible and measurable differences between contrails caused by the different sulfur levels. At ambient temperatures 5 K below the threshold temperature for contrail onset, the plume became visible about 10 m after the engine exit for high sulfur content, but 15 m after the engine exit for low sulfur content. The higher sulfur emission caused a larger optical thickness of the contrail shortly after onset, with slightly brown‐colored contrail when the Sun was behind the observer, and more contrast when viewed against the Sun. The high‐sulfur contrail grew more quickly but also evaporated earlier than the low‐sulfur contrail. At plume ages of about 20 s, each engine plume was diluted to an effective diameter of 20 m. The plumes contained many subvisible particles. Peak number densities were 30,000 cm−3 for particles of diameter above 7 nm and 15,000 cm−3 above 18 nm. The latter is a little larger than the estimated number of soot particles emitted. The high‐sulfur plume shows more particles than the low‐sulfur plume. The differences are about 25% for particles above 7 nm and about 50% above 18 nm. The results indicate that part of the fuel sulfur is converted to sulfuric acid which nucleates with water vapor heterogeneously on soot or nucleates acid droplets homogeneously which then coagulate partly with soot. During descent through the level of contrail onset, the high‐sulfur contrail remained visible at slightly lower altitude (25 to 50 m) or higher temperature (0.2 to 0.4 K). At least for average to high sulfur contents, aircraft generate an invisible aerosol trail which enhances the background level of condensation nuclei, in particular in regions with dense air traffic at northern latitudes and near the tropopause.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Über Bedingungen zur Bildung von Kondensstreifen aus Flugzeugabgasen
Schumann, U. (1996) · Meteorologische Zeitschrift · doi:10.1127/metz/5/1996/4 · Cited by 476
Self-citationCalibration of the TSI 3760 Condensation Nucleus Counter for Nonstandard Operating Conditions
Noone, K. J., & Hansson, H.-C. (1990) · Aerosol Science and Technology · doi:10.1080/02786829008959462 · Cited by 30
Cited by
Masiol, M., & Harrison, R. M. (2014) · Atmospheric Environment · doi:10.1016/j.atmosenv.2014.05.070 · Cited by 515
Biofuel blending reduces particle emissions from aircraft engines at cruise conditions
Moore, R. H., Thornhill, K. L., Weinzierl, B., Sauer, D., D’Ascoli, E., Kim, J., Lichtenstern, M., Scheibe, M., Beaton, B., Beyersdorf, A. J., et al. (2017) · Nature · doi:10.1038/nature21420 · Cited by 414
Predicting global aerosol size distributions in general circulation models
Adams, P. J., & Seinfeld, J. H. (2002) · Journal of Geophysical Research: Atmospheres · doi:10.1029/2001jd001010 · Cited by 362
European scientific assessment of the atmospheric effects of aircraft emissions
Brasseur, G. P., Cox, R. A., Hauglustaine, D., Isaksen, I., Lelieveld, J., Lister, D. H., Sausen, R., Schumann, U., Wahner, A., & Wiesen, P. (1998) · Atmospheric Environment · doi:10.1016/s1352-2310(97)00486-x · Cited by 260
Self-citationA contrail cirrus prediction model
Schumann, U. (2012) · Geoscientific Model Development · doi:10.5194/gmd-5-543-2012 · Cited by 229
Self-citation
Metadata
- Authors
- Schumann, U., Ström, J., Busen, R., Baumann, R., Gierens, K., Krautstrunk, M., Schröder, F. P., & Stingl, J.
- Venue
- Journal of Geophysical Research: Atmospheres
- Publisher
- American Geophysical Union (AGU)
- Published
- 1996-03
- Volume
- 101
- Issue
- D3
- Pages
- 6853-6869
- ISSN
- 0148-0227 (ISSN-L)
- OpenAlex
- W2095803691
- Cited by
- 183
- References
- 2
- FWCI
- 39.99
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.