Student or educator? Sign up with your school email and get 6 months of Pro free.
Cited by 457

The DOI matches its Crossref record; 20 of the 20 references it cites were found in a registry or an index.

Injection‐induced earthquakes and crustal stress at 9 km depth at the KTB deep drilling site, Germany

Zoback, Mark D., Harjes, Hans‐Peter·1997·Journal of Geophysical Research: Solid Earth

Abstract

A fluid injection‐induced seismicity experiment was conducted in the German Continental Deep Drilling Program (KTB) main borehole at 9.1 km depth (in situ temperature of 260°C) to extend knowledge about stress magnitudes and brittle faulting to depths and temperatures approaching the brittle‐ductile transition. Almost 400 microearthquakes were induced at an average depth of 8.8 km by injection of KBr/KCl brine into a ∼70 m open hole section near the bottom of the borehole. Although most focal plane mechanisms were poorly constrained due to the very small size of the induced earthquakes, several different clusters of microearthquakes with distinct mechanisms were defined. Most of the microearthquakes for which focal plane mechanisms were determined were strike‐slip events with a NNW trending P axis, essentially parallel to the direction of maximum horizontal compression observed in the borehole. The largest induced earthquake, M 1.2, occurred 18 hours after injection was started. This event was a strike‐slip/reverse faulting event which also had a NNW trending P axis. Utilization of a precise relative location technique indicates that many of microearthquakes occurred relatively far (50–100 m) from the well bore. Modeling of the pore pressure disturbance caused by injection suggests that many of the earthquakes were induced by extremely small pore pressure perturbations (<1 MPa) less than 1% greater than the ambient, approximately hydrostatic pore pressure at depth. Thus it is apparent that there are critically stressed, permeable fault zones in the crust, even at great depth and temperature. A frictional analysis of the focal plane mechanisms of the induced microearthquakes indicates that fault slip is consistent with the stress magnitudes and orientations determined in situ at depths to 7.7 km in the borehole and relatively high coefficients of friction (∼0.6–0.7) reported by Brudy et al. [this issue]. This and the observation that very small pore pressure perturbations were able to trigger seismicity appear to confirm the hypothesis that “Byerlee's law” (i.e., that differential stresses in situ are limited by the frictional strength of well‐oriented, preexisting faults) is valid to great crustal depth and that the crust is in brittle failure equilibrium at depths and temperatures approaching the brittle‐ductile transition, even in this relatively stable intraplate area.

Overview

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1029/96jb02814

Cites

20 of 20 references verified0 citation errors · 0 not checkable

Statistics

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Cited by

See all 457

Metadata

Authors
Zoback, M. D., & Harjes, H.
Venue
Journal of Geophysical Research: Solid Earth
Published
1997-08-10
Volume
102
Issue
B8
Pages
18477-18491
ISSN
0148-0227 (ISSN-L)
OpenAlex
W1986286057
Cited by
457
References
20
FWCI
12.06
Type
journal article
Language
en
Open access
closed

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.