The DOI matches its Crossref record; 27 of the 27 references it cites were found in a registry or an index.
The transition from brittle faulting to cataclastic flow in porous sandstones: Mechanical deformation
Open accessAbstract
Triaxial compression experiments were conducted to investigate the inelastic and failure behavior of six sandstones with porosities ranging from 15% to 35%. A broad range of effective pressures was used so that the transition in failure mode from brittle faulting to cataclastic flow could be observed. In the brittle faulting regime, shear‐induced dilation initiates in the prepeak stage at a stress level C' which increases with effective mean stress. Under elevated effective pressures, a sample fails by cataclastic flow. Strain hardening and shear‐enhanced compaction initiates at a stress level C* which decreases with increasing effective mean stress. The critical stresses C' and C* were marked by surges in acoustic emission. In the stress space, C* maps out an approximately elliptical yield envelope, in accordance with the critical state and cap models. Using plasticity theory, the flow rule associated with this yield envelope was used to predict porosity changes which are comparable to experimental data. In the brittle faulting regime the associated flow rule predicts dilatancy to increase with decreasing effective pressure in qualitative agreement with the experimental observations. The data were also compared with prediction of a nonassociative model on the onset of shear localization. Experimental data suggest that a quantitative measure of brittleness is provided by the grain crushing pressure (which decreases with increasing porosity and grain size). Geologic data on tectonic faulting in siliciclastic formations (of different porosity and grain size) are consistent with the laboratory observations.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
The Elastic Behaviour of a Crystalline Aggregate
Hill, R. (1952) · Proceedings of the Physical Society. Section A · doi:10.1088/0370-1298/65/5/307 · Cited by 11,503
Johnson, K. L. (1985) · Cambridge University Press eBooks · doi:10.1017/cbo9781139171731 · Cited by 7,796
Soil mechanics and plastic analysis or limit design
Drucker, D. C., & Prager, W. (1952) · Quarterly of Applied Mathematics · doi:10.1090/qam/48291 · Cited by 4,160
Ondracek, G. (1972) · Journal of Nuclear Materials · doi:10.1016/0022-3115(72)90033-5 · Cited by 2,641
Conditions for the localization of deformation in pressure-sensitive dilatant materials
Rudnicki, J. W., & Rice, J. R. (1975) · Journal of the Mechanics and Physics of Solids · doi:10.1016/0022-5096(75)90001-0 · Cited by 2,572
Foundations of solid mechanics
Fung, Y. C. (1965) · Medical Entomology and Zoology · Cited by 2,002
Foundations of solid mechanics
Pohle, F. V. (1966) · Journal of the Franklin Institute · doi:10.1016/0016-0032(66)90243-2 · Cited by 1,950
Experimental Rock Deformation — The Brittle Field
(2005) · Springer eBooks · doi:10.1007/b137431 · Cited by 1,660
The effect of cracks on the compressibility of rock
Walsh, J. B. (1965) · Journal of Geophysical Research · doi:10.1029/jz070i002p00381 · Cited by 1,425
The Stress Field Created by a Circular Sliding Contact
Hamilton, G. M., & Goodman, L. E. (1966) · Journal of Applied Mechanics · doi:10.1115/1.3625051 · Cited by 760
Cited by
Zoback, M. D. (2007) · Cambridge University Press eBooks · doi:10.1017/cbo9780511586477 · Cited by 1,541
Time-dependent cracking and brittle creep in crustal rocks: A review
Brantut, N., Heap, M. J., Meredith, P. G., & Baud, P. (2013) · Journal of Structural Geology · doi:10.1016/j.jsg.2013.03.007 · Cited by 706
The brittle-ductile transition in porous rock: A review
Wong, T.-F., & Baud, P. (2012) · Journal of Structural Geology · doi:10.1016/j.jsg.2012.07.010 · Cited by 657
Self-citationFailure mode and weakening effect of water on sandstone
Baud, P., Zhu, W., & Wong, T. (2000) · Journal of Geophysical Research: Solid Earth · doi:10.1029/2000jb900087 · Cited by 480
Self-citationMicromechanical modeling of cracking and failure in brittle rocks
Hazzard, J. F., Young, R. P., & Maxwell, S. C. (2000) · Journal of Geophysical Research: Solid Earth · doi:10.1029/2000jb900085 · Cited by 285
Morgan, J. K., & Boettcher, M. S. (1999) · Journal of Geophysical Research: Solid Earth · doi:10.1029/1998jb900056 · Cited by 269
Permeability of illite‐bearing shale: 1. Anisotropy and effects of clay content and loading
Kwon, O., Kronenberg, A. K., Gangi, A. F., Johnson, B., & Herbert, B. E. (2004) · Journal of Geophysical Research: Solid Earth · doi:10.1029/2004jb003052 · Cited by 253
Rimmelé, G., Barlet-Gouédard, V., & Renard, F. (2010) · Oil & Gas Science and Technology – Revue de l’Institut Français du Pétrole · doi:10.2516/ogst/2009071 · Cited by 89
Metadata
- Authors
- Wong, T., David, C., & Zhu, W.
- Venue
- Journal of Geophysical Research: Solid Earth
- Publisher
- American Geophysical Union (AGU)
- Published
- 1997-02-10
- Volume
- 102
- Issue
- B2
- Pages
- 3009-3025
- ISSN
- 0148-0227 (ISSN-L)
- OpenAlex
- W2026203425
- Cited by
- 897
- References
- 27
- FWCI
- 19.29
- Type
- journal article
- Language
- en
- Open access
- bronze
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.