Student or educator? Sign up with your school email and get 6 months of Pro free.
Cited by 303

The DOI matches its Crossref record; 21 of the 21 references it cites were found in a registry or an index.

Integrated satellite interferometry: Tropospheric noise, GPS estimates and implications for interferometric synthetic aperture radar products

Open access
Williams, Simon, Bock, Yehuda, Fang, Peng·1998·Journal of Geophysical Research: Solid Earth

Abstract

Interferometric synthetic aperture radar (INSAR), like other astronomic and space geodetic techniques, is limited by the spatially and temporally variable delay of electromagnetic waves propagating through the neutral atmosphere. Statistical analysis of these variations, from a wide variety of instruments, reveals a power law dependence on frequency that is characteristic of elementary (Kolmogorov) turbulence. A statistical model for a major component of the delay fluctuations, the “wet” component, has previously been developed by Treuhaft and Lanyi[1987] for very long baseline interferometry. A continuous Global Positioning System (GPS) network is now in place in southern California that allows estimation of, along with geodetic parameters, the total delay due to the atmosphere above each site on a subhourly basis. These measurements are shown to conform to the Treuhaft and Lanyi (TL) statistical model both temporally and spatially. The TL statistical model is applied to the problem of INSAR and used to produce the covariance between two points separated in time and/or space. The error, due to the atmospheric variations, for SAR products such as topography and surface deformation is calculated via propagation of errors. There are two methods commonly cited to reduce the effect of atmospheric distortion in products from SAR interferometry, stacking and calibration. Stacking involves averaging independent interferograms to reduce the noise. Calibration involves removing part (or all) of the delay using data from an independent source such as total zenith delay estimates from continuous GPS networks. Despite the relatively poor spatial density of surface measurements, calibration can be used to reduce noise if the measurements are sufficiently accurate. Reduction in tropospheric noise increases with increasing number of measurement points and increasing accuracy up to a maximum of √N, where N is the number of points. Stacking and calibration are shown to be complementary and can be used simultaneously to reduce the noise to below that achievable by either method alone.

Overview

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1029/98jb02794

Cites

21 of 21 references verified0 citation errors · 0 not checkable

Statistics

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Show all 21 references

Cited by

See all 303

Metadata

Authors
Williams, S., Bock, Y., & Fang, P.
Venue
Journal of Geophysical Research: Solid Earth
Published
1998-11-10
Volume
103
Issue
B11
Pages
27051-27067
ISSN
0148-0227 (ISSN-L)
OpenAlex
W1999610203
Cited by
303
References
21
FWCI
8.55
Type
journal article
Language
en
Open access
bronze

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

How to cite

Cite CoChat for the checks on this page, and the paper for its own findings.

This page
CoChat. (2026). Citation check: Integrated satellite interferometry: Tropospheric noise, GPS estimates and implications for interferometric synthetic aperture radar products. https://app.cochat.ai/papers/10.1029/98jb02794
The paper
Williams, S., Bock, Y., & Fang, P. (1998). Integrated satellite interferometry: Tropospheric noise, GPS estimates and implications for interferometric synthetic aperture radar products. Journal of Geophysical Research: Solid Earth. https://doi.org/10.1029/98jb02794

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.