Experimental deformation of dry westerly granite
The DOI matches its Crossref record; 9 of the 9 references it cites were found in a registry or an index.
Abstract
The deformation behavior of quartz and feldspar has been studied in Westerly granite deformed dry at a constant strain rate of 10−6/s, confining pressures of 1.5–15 kbar, and temperatures of 25°–1000°C. Samples deformed at lower temperatures and pressures show throughgoing faults; those deformed at intermediate conditions show a combination of grain-scale faults and plastic deformation; and those deformed at higher temperatures and pressures show plastic deformation with no faults of any scale. On a grain scale the deformation is inhomogeneous at all conditions because of the polyphase nature of the material. Detailed petrographic and transmission electron microscope (TEM) observations have been made of the deformed specimens. The fault gouge consists of very fine grained material which verges on being amorphous, but no evidence of melt was seen. In the regions away from fault zones, there is a transition from dominantly microcracking to dominantly dislocation glide and climb; this transition is primarily a function of temperature. Dislocation motion is thermally activated and is probably almost unaffected by pressure over the range investigated. Thus at low temperature the strain rate that can be produced by dislocation motion is limited, and the difference between this and the imposed strain rate must occur by microcracking. The way in which the microcracking accomplishes the deformation depends on pressure. At low pressures (<5 kbar) the microcracks link up to form a throughgoing fault after very low strain; at higher pressures (7.5–15 kbar) they produce only grain-scale faults, ‘deformation bands,’ and undulatory extinction, and no throughgoing faults are formed after 15–20% shortening. At the laboratory strain rate of 10−6/s the transition from dominantly microcracking to dominantly dislocation motion occurs at approximately 300°–400°C for quartz and 550°–650°C for feldspar. When one allows for the slower natural strain rates and the presence of water, this grain-scale brittle-ductile transition may correspond to the limiting depth of earthquakes on strike slip faults.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Generation of Pseudotachylyte by Ancient Seismic Faulting
Sibson, R. H. (1975) · Geophysical Journal International · doi:10.1111/j.1365-246x.1975.tb06195.x · Cited by 780
High Temperature Flow of Dunite and Peridotite
Carter, N. L., & AvéLallemant, H. G. (1970) · Geological Society of America Bulletin · doi:10.1130/0016-7606(1970)81[2181:htfoda]2.0.co;2 · Cited by 651
Brittle-ductile transition in rocks
Byerlee, J. D. (1968) · Journal of Geophysical Research · doi:10.1029/jb073i014p04741 · Cited by 585
On the rheology of the upper mantle
Stocker, R. L., & Ashby, M. F. (1973) · Reviews of Geophysics · doi:10.1029/rg011i002p00391 · Cited by 524
Low-stress high-temperature creep in olivine single crystals
Kohlstedt, D. L., & Goetze, C. (1974) · Journal of Geophysical Research Atmospheres · doi:10.1029/jb079i014p02045 · Cited by 409
HEARD, H. C. (1960) · Geological Society of America Memoirs · doi:10.1130/mem79-p193 · Cited by 321
Chapter 13: Observations on Fracture and a Hypothesis of Earthquakes
GRIGGS, D., & HANDIN, J. (1960) · Geological Society of America Memoirs · doi:10.1130/mem79-p347 · Cited by 304
Friction in faulted rock at high temperature and pressure
Stesky, R. M., Brace, W. F., Riley, D. K., & Robin, P.-Y. F. (1974) · Tectonophysics · doi:10.1016/0040-1951(74)90119-x · Cited by 292
Tighe, N. J. (1976) · Springer eBooks · doi:10.1007/978-3-642-66196-9_8 · Cited by 19
Cited by
The mechanics of earthquakes and faulting
(1990) · Choice Reviews Online · doi:10.5860/choice.28-1579 · Cited by 3,569
Limits on lithospheric stress imposed by laboratory experiments
Brace, W. F., & Kohlstedt, D. L. (1980) · Journal of Geophysical Research: Solid Earth · doi:10.1029/jb085ib11p06248 · Cited by 1,814
Strength of the lithosphere: Constraints imposed by laboratory experiments
Kohlstedt, D. L., Evans, B., & Mackwell, S. J. (1995) · Journal of Geophysical Research: Solid Earth · doi:10.1029/95jb01460 · Cited by 1,603
Berthé, D., Choukroune, P., & Jegouzo, P. (1979) · Journal of Structural Geology · doi:10.1016/0191-8141(79)90019-1 · Cited by 1,218
Continental delamination and the Colorado Plateau
Bird, P. (1979) · Journal of Geophysical Research: Solid Earth · doi:10.1029/jb084ib13p07561 · Cited by 1,039
Microcracks in rocks: A review
Kranz, R. L. (1983) · Tectonophysics · doi:10.1016/0040-1951(83)90198-1 · Cited by 918
The Mechanics of Earthquakes and Faulting
Scholz, C. H. (2019) · Cambridge University Press eBooks · doi:10.1017/9781316681473 · Cited by 910
Stress and temperature in the bending lithosphere as constrained by experimental rock mechanics
Goetze, C., & Evans, B. (1979) · Geophysical Journal International · doi:10.1111/j.1365-246x.1979.tb02567.x · Cited by 891
Sibson, R. H. (1982) · Bulletin of the Seismological Society of America · doi:10.1785/bssa0720010151 · Cited by 811
Brittle failure in compression: splitting faulting and brittle-ductile transition
Horii, H., & Nemat-Nasser, S. (1986) · Philosophical Transactions of the Royal Society of London. Series A, Mathematical and Physical Sciences · doi:10.1098/rsta.1986.0101 · Cited by 787
Flow properties of continental lithosphere
Carter, N. L., & Tsenn, M. C. (1987) · Tectonophysics · doi:10.1016/0040-1951(87)90333-7 · Cited by 757
Permeability of crystalline and argillaceous rocks
Brace, W. F. (1980) · International Journal of Rock Mechanics and Mining Sciences & Geomechanics Abstracts · doi:10.1016/0148-9062(80)90807-4 · Cited by 671
The brittle-plastic transition and the depth of seismic faulting
Scholz, C. H. (1988) · Geologische Rundschau · doi:10.1007/bf01848693 · Cited by 588
Continental fault structure and the shallow earthquake source
Sibson, R. H. (1983) · Journal of the Geological Society · doi:10.1144/gsjgs.140.5.0741 · Cited by 531
High-temperature mechanical, physical and Thermal properties of granitic rocks— A review
Heuze, F. E. (1983) · International Journal of Rock Mechanics and Mining Sciences & Geomechanics Abstracts · doi:10.1016/0148-9062(83)91609-1 · Cited by 463
Roughness at the base of the seismogenic zone: Contributing factors
Sibson, R. H. (1984) · Journal of Geophysical Research: Solid Earth · doi:10.1029/jb089ib07p05791 · Cited by 381
Evans, B., & Goetze, C. (1979) · Journal of Geophysical Research: Solid Earth · doi:10.1029/jb084ib10p05505 · Cited by 357
Micromechanics of the brittle to plastic transition in Carrara marble
Fredrich, J. T., Evans, B., & Wong, T. (1989) · Journal of Geophysical Research: Solid Earth · doi:10.1029/jb094ib04p04129 · Cited by 313
The brittle‐plastic transition in experimentally deformed quartz aggregates
Hirth, G., & Tullis, J. (1994) · Journal of Geophysical Research: Solid Earth · doi:10.1029/93jb02873 · Cited by 281
Self-citationMicrostructures in feldspars from a major crustal thrust zone: The Grenville Front, Ontario, Canada
Pryer, L. L. (1993) · Journal of Structural Geology · doi:10.1016/0191-8141(93)90076-m · Cited by 278
Production and loss of high‐density batholithic root, southern Sierra Nevada, California
Saleeby, J., Ducea, M., & Clemens‐Knott, D. (2003) · Tectonics · doi:10.1029/2002tc001374 · Cited by 277
Tectonic stresses in the lithosphere: Constraints provided by the experimental deformation of rocks
Kirby, S. H. (1980) · Journal of Geophysical Research: Solid Earth · doi:10.1029/jb085ib11p06353 · Cited by 260
The brittle-ductile transition in rocks: Recent experimental and theoretical progress
Evans, B., Fredrich, J. T., & Wong, T.-F. (1990) · Geophysical Monograph Series · doi:10.1029/gm056p0001 · Cited by 259
Multimechanism friction constitutive model for ultrafine quartz gouge at hypocentral conditions
Chester, F. M., & Higgs, N. G. (1992) · Journal of Geophysical Research: Solid Earth · doi:10.1029/91jb02349 · Cited by 254
Metadata
- Authors
- Tullis, J., & Yund, R. A.
- Venue
- Journal of Geophysical Research
- Publisher
- American Geophysical Union (AGU)
- Published
- 1977-12-10
- Volume
- 82
- Issue
- 36
- Pages
- 5705-5718
- ISSN
- 0148-0227 (ISSN-L)
- OpenAlex
- W2118893476
- Cited by
- 419
- References
- 9
- FWCI
- 20.01
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.