Student or educator? Sign up with your school email and get 6 months of Pro free.
Cited by 266

The DOI matches its Crossref record; 9 of the 9 references it cites were found in a registry or an index.

Permeability of fault gouge under confining pressure and shear stress

Morrow, C. A., Shi, L. Q., Byerlee, J. D.·1984·Journal of Geophysical Research: Solid Earth

Abstract

The permeability of both clay‐rich and non‐clay gouges, as well as several pure clays, was studied as a function of confining pressures from 5 to 200 MPa and shear strain to 10. Permeability ranged over four orders of magnitude, from around 10−22 to 10−18 m 2 (1 darcy = 0.987 × 10−12 m 2). The lowest values were characteristic of the montmorillonite‐rich and finer grained non‐clay gouges. Illite, kaolinite, and chlorite had intermediate permeabilities, while the highest values were typical of the serpentine and coarser grained non‐clay gouges. Grain size was an important factor in determining permeability, particularly for the clay‐rich samples. The coarse grained gouges were the most permeable and decreased in permeability after shearing. Conversely, the fine grained gouges had characteristically lower permeabilities that did not vary significantly after various amounts of shearing. The permeabilities of the non‐clay samples were not significantly different than those of the clays. Therefore, comminuted rock flours can be equally as effective in reducing the flow of water as the characteristically low permeability clay gouges. The strengths of the samples were quite variable. The non‐clay gouges were consistently the strongest, with yield points (beginning of nonelastic behavior) around 850 MPa, while montmorillonite had an anomalously low strength in relation to all the other gouges at 250 MPa. Strength of the saturated samples under drained (low pore pressure) conditions did not correlate with high or low permeability. However, the low permeabilities of these gouges could be a factor in the measured low shear stresses along fault regions if excess pore pressures were created as a result of shearing or compaction, and this pressure was unable to dissipate through a thick section of the material.

Overview

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1029/jb089ib05p03193

Cites

9 of 9 references verified0 citation errors · 0 not checkable

Statistics

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Show all 9 references

Cited by

See all 266

Metadata

Authors
Morrow, C. A., Shi, L. Q., & Byerlee, J. D.
Venue
Journal of Geophysical Research: Solid Earth
Published
1984-05-10
Volume
89
Issue
B5
Pages
3193-3200
ISSN
0148-0227 (ISSN-L)
OpenAlex
W1966173525
Cited by
266
References
9
FWCI
1.82
Type
journal article
Language
en
Open access
closed

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

How to cite

Cite CoChat for the checks on this page, and the paper for its own findings.

This page
CoChat. (2026). Citation check: Permeability of fault gouge under confining pressure and shear stress. https://app.cochat.ai/papers/10.1029/jb089ib05p03193
The paper
Morrow, C. A., Shi, L. Q., & Byerlee, J. D. (1984). Permeability of fault gouge under confining pressure and shear stress. Journal of Geophysical Research: Solid Earth. https://doi.org/10.1029/jb089ib05p03193

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.