The DOI matches its Crossref record; 15 of the 15 references it cites were found in a registry or an index.
Strength, porosity, and permeability development during hydrostatic and shear loading of synthetic quartz‐clay fault gouge
Open accessAbstract
The strength and permeability of fault zones must be quantified in order to accurately predict crustal strength and subsurface fluid migration. To this end, we performed experiments on mixtures of fine‐grained quartz and kaolinite incremented at 10 wt% intervals between the two end‐member components (analogues for natural fault gouge) in order to establish their strength and fluid flow properties during hydrostatic and shear loading. Hydrostatically compacted samples exhibited permeability reduction on increasing effective pressures from 5 MPa to 50 MPa, with the rate of reduction displaying strong dependency on the synthetic fault gouge composition. The permeability decreases continuously with increasing kaolinite content. Porosity exhibits a distinct minimum that evolves with increasing effective pressure according to the relative compaction of the quartz and kaolinite end‐members. Porosity evolution with increasing clay content is predicted satisfactorily by a simple ideal packing model. At the highest effective pressure (50 MPa), permeability reduced log‐linearly over 4 orders of magnitude with increasing clay content. Mechanically, sheared gouge samples showed a continuous reduction in frictional strength with increasing clay fraction. Permeability decreased further on shear loading after initial hydrostatic compaction to 50 MPa. This was most evident for the pure quartz end‐member, with two orders of magnitude additional reduction, whereas the clay‐rich samples were reduced only tenfold, mostly before a shear strain of 5. Variation of permeability with both clay content and shear deformation may be adequately described by previously published empirical predictors for fault zone permeability. Clay content has the largest effect on permeability, and shear deformation affects permeability of quartz‐rich gouges more than clay‐rich gouges.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
The Electrical Resistivity Log as an Aid in Determining Some Reservoir Characteristics
Archie, G. E. (1942) · Transactions of the AIME · doi:10.2118/942054-g · Cited by 7,761
Byerlee, J. (1978) · pure and applied geophysics · doi:10.1007/bf00876528 · Cited by 4,029
Mechanical Packing of Spherical Particles
McGEARY, R. K. (1961) · Journal of the American Ceramic Society · doi:10.1111/j.1151-2916.1961.tb13716.x · Cited by 1,044
Mechanisms Controlling the Permeability of Clays
Mesri, G., & Olson, R. E. (1971) · Clays and Clay Minerals · doi:10.1346/ccmn.1971.0190303 · Cited by 534
Revil, A., & Cathles, L. M. (1999) · Water Resources Research · doi:10.1029/98wr02700 · Cited by 470
Comparative microstructures of natural and experimentally produced clay-bearing fault gouges
Rutter, E. H., Maddock, R. H., Hall, S. H., & White, S. H. (1986) · pure and applied geophysics · doi:10.1007/bf00875717 · Cited by 426
Self-citationFriction, overpressure and fault normal compression
Byerlee, J. (1990) · Geophysical Research Letters · doi:10.1029/gl017i012p02109 · Cited by 396
Fault transmissibility multipliers for flow simulation models
Manzocchi, T., Walsh, J. J., Nell, P., & Yielding, G. (1999) · Petroleum Geoscience · doi:10.1144/petgeo.5.1.53 · Cited by 336
Moore, D. E., & Lockner, D. A. (2004) · Journal of Geophysical Research: Solid Earth · doi:10.1029/2003jb002582 · Cited by 330
Bos, B., & Spiers, C. J. (2002) · Journal of Geophysical Research: Solid Earth · doi:10.1029/2001jb000301 · Cited by 306
Cited by
Faulkner, D. R., Jackson, C. A. L., Lunn, R. J., Schlische, R. W., Shipton, Z. K., Wibberley, C. A. J., & Withjack, M. O. (2010) · Journal of Structural Geology · doi:10.1016/j.jsg.2010.06.009 · Cited by 1,513
Self-citationBarnes, R. T., Gallagher, M. E., Masiello, C. A., Liu, Z., & Dugan, B. (2014) · PLoS ONE · doi:10.1371/journal.pone.0108340 · Cited by 287
Frictional properties of shale reservoir rocks
Kohli, A. H., & Zoback, M. D. (2013) · Journal of Geophysical Research: Solid Earth · doi:10.1002/jgrb.50346 · Cited by 270
The Nanoscale Basis of CO2 Trapping for Geologic Storage
Bourg, I. C., Beckingham, L. E., & DePaolo, D. J. (2015) · Environmental Science & Technology · doi:10.1021/acs.est.5b03003 · Cited by 163
Metadata
- Authors
- Crawford, B. R., Faulkner, D. R., & Rutter, E. H.
- Venue
- Journal of Geophysical Research: Solid Earth
- Publisher
- American Geophysical Union (AGU)
- Published
- 2008-03
- Volume
- 113
- Issue
- B3
- ISSN
- 0148-0227 (ISSN-L)
- OpenAlex
- W2053745559
- Cited by
- 271
- References
- 15
- FWCI
- 8.18
- Type
- journal article
- Language
- en
- Open access
- bronze
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Strength, porosity, and permeability development during hydrostatic and shear loading of synthetic quartz‐clay fault gouge. https://app.cochat.ai/papers/10.1029/2006jb004634
- The paper
- Crawford, B. R., Faulkner, D. R., & Rutter, E. H. (2008). Strength, porosity, and permeability development during hydrostatic and shear loading of synthetic quartz‐clay fault gouge. Journal of Geophysical Research: Solid Earth. https://doi.org/10.1029/2006jb004634
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.