The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.
Sulfide and sulfate saturation in hydrous silicate melts
Abstract
Hydrothermal experiments have been conducted on a sulfur saturated dacitic melt over a range of pressure, temperature, oxygen fugacity, and melt FeO content in order to examine the effects of these variables on sulfur solubility in fractionated melts. Experiments done under both reducing (GCH, QFM buffers) and oxidizing (MNO, HM buffers) conditions indicate the solubility of sulfur increases with increasing total pressure ( = fluid pressure) over the pressure range 100 to 300 MPa. GCH buffered experiments (1025°C) with 18 to 30 wt % FeO show sulfur solubilities at sulfide saturation ranging from 0.1 to 0.5 wt % S; increasing pressure from 100 to 200 MPa increases sulfur solubility by 500 to 1000 ppm, with the greatest increase observed in more FeO‐rich melts. GCH buffered melts with <5 wt % FeO show no measurable change in sulfur solubility (300±150 ppm S) between 100 and 200 MPa at 1025°C. QFM buffered experiments (1025°C) with 10.0 to 12.5 wt % FeO show sulfur solubility increasing from 600 to 1000 ppm between 100 and 200 MPa. QFM experiments with lower FeO contents (2 to 8 wt %) showed no measurable (±200 ppm S) effect of temperature (912°C to 1025°C) or pressure (100 to 220 MPa) on sulfur solubility. Experiments done under oxidizing conditions of the HM and MNO buffers (1025°C) show sulfur solubilities in melts with 3 to 5 wt % FeO ranging from ∼1400 ppm at 100 MPa to ∼3000 ppm at 300 MPa. More importantly however, the change to more oxidizing conditions is accompanied by a change from sulfide (an FeS‐rich melt) to sulfate (crystalline CaS04) saturated conditions. Stabilization of anhydrite as a magmatic phase (1025°C, 100 to 300 MPa) is also accompanied by a significant increase in sulfur solubility relative to saturation values for more reduced melts with similar FeO contents. The results of this study show that upper crustal oxidation‐reduction and crystal fractionation processes may exert considerable influence on the amount of sulfur contained in magmas erupted at the surface. These results are of basic importance in understanding volatile transport and volcanic degasing processes on planets such as the Earth, Mars, and Venus.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Chemical composition of Martian fines
Clark, B. C., Baird, A. K., Weldon, R. J., Tsusaki, D. M., Schnabel, L., & Candelaria, M. P. (1982) · Journal of Geophysical Research: Solid Earth · doi:10.1029/jb087ib12p10059 · Cited by 409
Cited by
Tectono-Magmatic Precursors for Porphyry Cu-(Mo-Au) Deposit Formation
Richards, J. P. (2003) · Economic Geology · doi:10.2113/98.8.1515 · Cited by 1,063
Mavrogenes, J. A., & O’Neill, H. S. C. (1999) · Geochimica et Cosmochimica Acta · doi:10.1016/s0016-7037(98)00289-0 · Cited by 681
Jugo, P. J., Wilke, M., & Botcharnikov, R. E. (2010) · Geochimica et Cosmochimica Acta · doi:10.1016/j.gca.2010.07.022 · Cited by 555
The oxidation state, and sulfur and Cu contents of arc magmas: implications for metallogeny
Richards, J. P. (2015) · Lithos · doi:10.1016/j.lithos.2014.12.011 · Cited by 529
Chemical Composition of Volcanic Gases
Giggenbach, W. F. (1996) · Monitoring and Mitigation of Volcano Hazards · doi:10.1007/978-3-642-80087-0_7 · Cited by 463
Metadata
- Authors
- Carroll, M. R., & Rutherford, M. J.
- Venue
- Journal of Geophysical Research: Solid Earth
- Publisher
- American Geophysical Union (AGU)
- Published
- 1985-02-15
- Volume
- 90
- Issue
- S02
- ISSN
- 0148-0227 (ISSN-L)
- OpenAlex
- W2003809497
- Cited by
- 305
- References
- 1
- FWCI
- 3.59
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Sulfide and sulfate saturation in hydrous silicate melts. https://app.cochat.ai/papers/10.1029/jb090is02p0c601
- The paper
- Carroll, M. R., & Rutherford, M. J. (1985). Sulfide and sulfate saturation in hydrous silicate melts. Journal of Geophysical Research: Solid Earth. https://doi.org/10.1029/jb090is02p0c601
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.