The DOI matches its Crossref record; 28 of the 28 references it cites were found in a registry or an index.
Micromechanics of the brittle to plastic transition in Carrara marble
Abstract
Samples of Carrara marble were deformed at room temperature to varying strains at confining pressures spanning the range in mechanical behavior from brittle to plastic. Volumetric strain was measured during the experiments, and the stress‐induced microstructure was characterized quantitatively using optical and transmission electron microscopy. The range of confining pressure over which transitional (or semibrittle) deformation occurs is 30–300 MPa. The macroscopic initial yield stress is constant for confining pressures greater than 85 MPa, whereas the differential stress at the onset of dilatancy increases with pressure up to 300 MPa. The dilatancy coefficient decreases rapidly with increasing pressure up to 100 MPa, and then asymptotically approaches zero for pressures up to 300 MPa. The work hardening coefficient increases with pressure up to 450 MPa; the pressure sensitivity is greatest for pressures up to 100 MPa. Active deformation mechanisms include microcracking, twinning, and dislocation glide. Transmission electron microscopy observations indicate that dislocation glide occurs, at least on a local scale, in samples deformed in the semibrittle field at pressures as low as 50 MPa and applied differential stress well below the critical resolved shear stress for glide on the easiest slip system. Cracks and voids frequently nucleate at sites of stress concentration at twin boundaries, at twin terminations, and at the intersection of twin lamallae. Geometries suggestive of crack tip shielding by dislocations are also observed. Stereological measurements indicate that at constant strain in the semibrittle field, the stress‐induced crack density and anisotropy decrease with increasing pressure. Crack density and anisotropy in samples deformed to strains of 3–5% in the semibrittle field at pressures up to 120 MPa are comparable to those in the prefailure brittle sample, although an analysis of the energetics of deformation suggests that the ratio of brittle energy dissipation to total energy dissipation is at least 60% lower. We also detect a qualitative difference in the characteristic length of the cracks in the brittle and semibrittle fields. The mean dislocation density at constant differential stress increases significantly for samples deformed at pressures of 230 MPa and greater. Our results suggest that although semibrittle flow occurs over a wide range of pressure, the most marked changes in strain partitioning, and hence the style of deformation occur over a small range in pressure.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Ondracek, G. (1972) · Journal of Nuclear Materials · doi:10.1016/0022-3115(72)90033-5 · Cited by 2,641
Conditions for the localization of deformation in pressure-sensitive dilatant materials
Rudnicki, J. W., & Rice, J. R. (1975) · Journal of the Mechanics and Physics of Solids · doi:10.1016/0022-5096(75)90001-0 · Cited by 2,572
Probability and Statistics for Engineering and the Sciences.
Devore, J. L. (1991) · Biometrics · doi:10.2307/2532427 · Cited by 2,503
Elastic moduli of a cracked solid
Budiansky, B., & O'connell, R. J. (1976) · International Journal of Solids and Structures · doi:10.1016/0020-7683(76)90044-5 · Cited by 2,015
Limits on lithospheric stress imposed by laboratory experiments
Brace, W. F., & Kohlstedt, D. L. (1980) · Journal of Geophysical Research: Solid Earth · doi:10.1029/jb085ib11p06248 · Cited by 1,814
Subcritical crack growth in geological materials
Atkinson, B. K. (1984) · Journal of Geophysical Research: Solid Earth · doi:10.1029/jb089ib06p04077 · Cited by 1,413
The failure of brittle solids containing small cracks under compressive stress states
Ashby, M. F., & Hallam (Née Cooksley), S. D. (1986) · Acta Metallurgica · doi:10.1016/0001-6160(86)90086-6 · Cited by 998
Microcracks in rocks: A review
Kranz, R. L. (1983) · Tectonophysics · doi:10.1016/0040-1951(83)90198-1 · Cited by 918
Sibson, R. H. (1982) · Bulletin of the Seismological Society of America · doi:10.1785/bssa0720010151 · Cited by 811
Flow properties of continental lithosphere
Carter, N. L., & Tsenn, M. C. (1987) · Tectonophysics · doi:10.1016/0040-1951(87)90333-7 · Cited by 757
Cited by
Strength of the lithosphere: Constraints imposed by laboratory experiments
Kohlstedt, D. L., Evans, B., & Mackwell, S. J. (1995) · Journal of Geophysical Research: Solid Earth · doi:10.1029/95jb01460 · Cited by 1,603
Self-citationWong, T., David, C., & Zhu, W. (1997) · Journal of Geophysical Research: Solid Earth · doi:10.1029/96jb03281 · Cited by 897
Self-citationThe brittle-ductile transition in porous rock: A review
Wong, T.-F., & Baud, P. (2012) · Journal of Structural Geology · doi:10.1016/j.jsg.2012.07.010 · Cited by 657
Self-citationEvaluation of mechanical rock properties using a Schmidt Hammer
Katz, O., Reches, Z., & Roegiers, J.-C. (2000) · International Journal of Rock Mechanics and Mining Sciences · doi:10.1016/s1365-1609(00)00004-6 · Cited by 448
The brittle‐plastic transition in experimentally deformed quartz aggregates
Hirth, G., & Tullis, J. (1994) · Journal of Geophysical Research: Solid Earth · doi:10.1029/93jb02873 · Cited by 281
The brittle-ductile transition in rocks: Recent experimental and theoretical progress
Evans, B., Fredrich, J. T., & Wong, T.-F. (1990) · Geophysical Monograph Series · doi:10.1029/gm056p0001 · Cited by 259
Self-citationQuantification of microcrack characteristics and implications for stiffness and strength of granite
Griffiths, L., Heap, M. J., Baud, P., & Schmittbuhl, J. (2017) · International Journal of Rock Mechanics and Mining Sciences · doi:10.1016/j.ijrmms.2017.10.013 · Cited by 256
Metadata
- Authors
- Fredrich, J. T., Evans, B., & Wong, T.
- Venue
- Journal of Geophysical Research: Solid Earth
- Publisher
- American Geophysical Union (AGU)
- Published
- 1989-04-10
- Volume
- 94
- Issue
- B4
- Pages
- 4129-4145
- ISSN
- 0148-0227 (ISSN-L)
- OpenAlex
- W2021622140
- Cited by
- 313
- References
- 28
- FWCI
- 14.19
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.