Prodigious submarine landslides on the Hawaiian Ridge

Abstract

The extensive area covered by major submarine mass wasting deposits on or near the Hawaiian Ridge has been delimited by systematic mapping of the Hawaiian exclusive economic zone using the side‐looking sonar system GLORIA. These surveys show that slumps and debris avalanche deposits are exposed over about 100,000 km 2 of the ridge and adjacent seafloor from Kauai to Hawaii, covering an area more than 5 times the land area of the islands. Some of the individual debris avalanches are more than 200 km long and about 5000 km 3 in volume, ranking them among the largest on Earth. The slope failures that produce these deposits begin early in the history of individual volcanoes when they are small submarine seamounts, culminate near the end of subaerial shield building, and apparently continue long after dormancy. Consequently, landslide debris is an important element in the internal structure of the volcanoes. The dynamic behavior of the volcanoes can be modulated by slope failure, and the structural features of the landslides are related to elements of the volcanoes including rift zones and fault systems. The landslides are of two general types, slumps and debris avalanches. The slumps are slow moving, wide (up to 110 km), and thick (about 10 km) with transverse blocky ridges and steep toes. The debris avalanches are fast moving, long (up to 230 km) compared to width, and thinner (0.05–2 km); they commonly have a well‐defined amphitheater at their head and hummocky terrain in the lower part. Oceanic disturbance caused by rapid emplacement of debris avalanches may have produced high‐level wave deposits (such as the 365‐m elevation Hulopoe Gravel on Lanai) that are found on several islands. Most present‐day submarine canyons were originally carved subaerially in the upper parts of debris avalanches. Subaerial canyon cutting was apparently promoted by the recently steepened and stripped slopes of the landslide amphitheaters.