Student or educator? Sign up with your school email and get 6 months of Pro free.
Cited by 265

The DOI matches its Crossref record; 24 of the 24 references it cites were found in a registry or an index.

Mass discrimination correction in multiple-collector plasma source mass spectrometry: an example using Cu and Zn isotopes

Archer, Corey, Vance, Derek·2004·Journal of Analytical Atomic Spectrometry

Abstract

Multiple-collector magnetic sector ICP-MS affords the possibility of applying instrumental mass discrimination corrections using a reference isotope ratio of an element (dopant) other than the analyte. Much attention has focused on the use of this approach for lead isotope analysis using a thallium dopant and the technique has also been applied to copper–zinc isotope analysis. The most successful applications of the doping approach have established empirical mass bias relationships between dopant and analyte isotope ratios but this often has to be done for single analytical sessions. Insufficient intra-session variation in mass discrimination often leads to poor constraints on these relationships. Moreover, with the Tl–Pb system there is some doubt over whether samples and standards exhibit the same relationship. Here we show that for the Cu–Zn system, two improvements on previous approaches lead to precise and accurate isotope ratios for unknowns. Firstly, addition of Sr to mixed Cu–Zn standard solutions generates extreme variation in mass bias so that empirical mass bias relationships between analyte and dopant are much better constrained. Secondly, we show that inadequate chemistry, specifically the inefficient removal of matrix Fe and Ti, seriously compromises the Cu–Zn isotope analysis of samples but that with clean chemistry, samples with complex matrices demonstrably yield similar mass discrimination relationships between Cu and Zn isotopes to standards. We also document previously unreported aspects of Cu–Zn isotope analysis: (1) that Cu–Zn mass bias relationships depend critically on the Cu/Zn ratio of the solution; (2) that for an introduction system with a desolvating membrane, the behaviour of standards is highly variable, perhaps due to variations in the oxidation state of Cu in the solution, and that this can be overcome by the passage of standards through the ion exchange procedure used to purify samples. Finally, we document chemical separation and mass spectrometric techniques that permit the isotopic analysis of order of magnitude smaller samples than previously achieved and report values for BCR-1 basalt standard of δ66Zn = 0.20 ± 0.09‰ (n = 12) and δ65Cu = 0.07 ± 0.08‰ (n = 6) at the 95% confidence level.

Overview

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1039/b315853e

Cites

24 of 24 references verified0 citation errors · 0 not checkable

Statistics

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Cited by

See all 265

Metadata

Authors
Archer, C., & Vance, D.
Venue
Journal of Analytical Atomic Spectrometry
Published
2004
Volume
19
Issue
5
Pages
656
ISSN
  • 0267-9477 (ISSN-L)
  • 1364-5544
OpenAlex
W2007256017
Cited by
265
References
24
FWCI
11.05
Type
journal article
Language
en
Open access
closed

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.