The DOI matches its Crossref record; 29 of the 29 references it cites were found in a registry or an index.
High capacity anode materials for Li-ion batteries based on spinel metal oxides AMn2O4 (A = Co, Ni, and Zn)
Open accessAbstract
Manganites of transition and/or post-transition metals, AMn2O4 (where A was Co, Ni or Zn), were synthesized by a simple and easily scalable co-precipitation route and were evaluated as anode materials for Li-ion batteries. The obtained powders were characterized by SEM, TEM, and XRD techniques. Battery cycling showed that ZnMn2O4 exhibited the best performance (discharge capacity, cycling, and rate capability) compared to the two other manganites and their corresponding simple oxides. Further studies on the effect of different sintering temperatures (from 400 to 1000 °C) on particle size were performed, and it is found that the size of the particles had a significant effect on the performance of the batteries. The optimum particle size for ZnMn2O4 is found to be 75–150 nm. In addition, the use of water-soluble and environmentally friendly binders, such as lithium and sodium salts of carboxymethlycellulose, greatly improved the performance of the batteries compared to the conventional binder, PVDF. Finally, ZnMn2O4 powder sintered at 800 °C (<150 nm) and the use of the in-house synthesized lithium salt of carboxymethlycellulose (LiCMC) binder gave the best battery performance: a capacity of 690 mA h g−1 (3450 mA h mL−1) at C/10, along with good rate capability and excellent capacity retention (88%).
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Nano-sized transition-metal oxides as negative-electrode materials for lithium-ion batteries
Poizot, P., Laruelle, S., Grugeon, S., Dupont, L., & Tarascon, J.-M. (2000) · Nature · doi:10.1038/35035045 · Cited by 8,041
Nonaqueous Liquid Electrolytes for Lithium-Based Rechargeable Batteries
Xu, K. (2004) · Chemical Reviews · doi:10.1021/cr030203g · Cited by 7,437
High-performance lithium battery anodes using silicon nanowires
Chan, C. K., Peng, H., Liu, G., McIlwrath, K., Zhang, X. F., Huggins, R. A., & Cui, Y. (2008) · Nature Nanotechnology · doi:10.1038/nnano.2007.411 · Cited by 6,683
Line profiles of neutron powder-diffraction peaks for structure refinement
Rietveld, H. M. (1967) · Acta Crystallographica · doi:10.1107/s0365110x67000234 · Cited by 3,660
Nano- and bulk-silicon-based insertion anodes for lithium-ion secondary cells
Kasavajjula, U., Wang, C., & Appleby, A. J. (2007) · Journal of Power Sources · doi:10.1016/j.jpowsour.2006.09.084 · Cited by 2,491
A fundamental parameters approach to X-ray line-profile fitting
Cheary, R. W., & Coelho, A. (1992) · Journal of Applied Crystallography · doi:10.1107/s0021889891010804 · Cited by 1,660
Carbon Coated Fe3O4 Nanospindles as a Superior Anode Material for Lithium‐Ion Batteries
Zhang, W., Wu, X., Hu, J., Guo, Y., & Wan, L. (2008) · Advanced Functional Materials · doi:10.1002/adfm.200801386 · Cited by 1,209
In Situ XRD and Electrochemical Study of the Reaction of Lithium with Amorphous Silicon
Hatchard, T. D., & Dahn, J. R. (2004) · Journal of The Electrochemical Society · doi:10.1149/1.1739217 · Cited by 1,113
Derrien, G., Hassoun, J., Panero, S., & Scrosati, B. (2007) · Advanced Materials · doi:10.1002/adma.200700748 · Cited by 868
Fabrication of NiO Nanowall Electrodes for High Performance Lithium Ion Battery
Varghese, B., Reddy, M. V., Yanwu, Z., Lit, C. S., Hoong, T. C., Subba Rao, G. V., Chowdari, B. V. R., Wee, A. T. S., Lim, C. T., & Sow, C.-H. (2008) · Chemistry of Materials · doi:10.1021/cm703512k · Cited by 643
Nanophase ZnCo2O4 as a High Performance Anode Material for Li‐Ion Batteries
Sharma, Y., Sharma, N., Subba Rao, G. V., & Chowdari, B. V. R. (2007) · Advanced Functional Materials · doi:10.1002/adfm.200600997 · Cited by 606
Li-Storage via Heterogeneous Reaction in Selected Binary Metal Fluorides and Oxides
Li, H., Balaya, P., & Maier, J. (2004) · Journal of The Electrochemical Society · doi:10.1149/1.1801451 · Cited by 590
Buqa, H., Holzapfel, M., Krumeich, F., Veit, C., & Novák, P. (2006) · Journal of Power Sources · doi:10.1016/j.jpowsour.2006.03.073 · Cited by 513
Hochgatterer, N. S., Schweiger, M. R., Koller, S., Raimann, P. R., Wöhrle, T., Wurm, C., & Winter, M. (2008) · Electrochemical and Solid-State Letters · doi:10.1149/1.2888173 · Cited by 449
Thermal Stability Studies of Li‐Ion Cells and Components
Maleki, H., Deng, G., Anani, A., & Howard, J. (1999) · Journal of The Electrochemical Society · doi:10.1149/1.1392458 · Cited by 437
Pasquier, A. D., Disma, F., Bowmer, T., Gozdz, A. S., Amatucci, G., & Tarascon, J. ‐. (1998) · Journal of The Electrochemical Society · doi:10.1149/1.1838287 · Cited by 436
Hassoun, J., Derrien, G., Panero, S., & Scrosati, B. (2008) · Advanced Materials · doi:10.1002/adma.200702928 · Cited by 409
Electrochemical Alloying of Lithium in Organic Electrolytes
Dey, A. N. (1971) · Journal of The Electrochemical Society · doi:10.1149/1.2407783 · Cited by 385
Li, H., Richter, G., & Maier, J. (2003) · Advanced Materials · doi:10.1002/adma.200304574 · Cited by 364
Enhanced Cycle Life of Si Anode for Li-Ion Batteries by Using Modified Elastomeric Binder
Liu, W., Yang, M., Wu, H., Chiao, S., & Wu, N. (2005) · Electrochemical and Solid-State Letters · doi:10.1149/1.1847685 · Cited by 336
Zheng, S.-F., Hu, J.-S., Zhong, L.-S., Song, W.-G., Wan, L.-J., & Guo, Y.-G. (2008) · Chemistry of Materials · doi:10.1021/cm7033855 · Cited by 290
Low Cost, Environmentally Benign Binders for Lithium-Ion Batteries
Lux, S. F., Schappacher, F., Balducci, A., Passerini, S., & Winter, M. (2010) · Journal of The Electrochemical Society · doi:10.1149/1.3291976 · Cited by 289
Xiao, L., Yang, Y., Yin, J., Li, Q., & Zhang, L. (2009) · Journal of Power Sources · doi:10.1016/j.jpowsour.2009.06.043 · Cited by 191
Qiu, Y., Yang, S., Deng, H., Jin, L., & Li, W. (2010) · Journal of Materials Chemistry · doi:10.1039/c0jm00101e · Cited by 191
Zhang, S. S., & Jow, T. R. (2002) · Journal of Power Sources · doi:10.1016/s0378-7753(02)00107-6 · Cited by 171
Duncan, H., Abu-Lebdeh, Y., & Davidson, I. J. (2010) · Journal of The Electrochemical Society · doi:10.1149/1.3321710 · Cited by 168
Self-citationCo-doped MnO: a possible anode material for lithium batteries
Pasero, D., Reeves‐McLaren, N., & West, A. R. (2004) · Journal of Power Sources · doi:10.1016/j.jpowsour.2004.07.037 · Cited by 161
Wang, J., KING, P., & Huggins, R. A. (1986) · Solid State Ionics · doi:10.1016/0167-2738(86)90212-2 · Cited by 155
Electrochemical Analysis of Lithiated Graphite Anodes
Verbrugge, M. W., & Koch, B. J. (2003) · Journal of The Electrochemical Society · doi:10.1149/1.1553788 · Cited by 144
Cited by
Metal Oxides and Oxysalts as Anode Materials for Li Ion Batteries
Reddy, M. V., Subba Rao, G. V., & Chowdari, B. V. R. (2013) · Chemical Reviews · doi:10.1021/cr3001884 · Cited by 2,921
Mixed Transition‐Metal Oxides: Design, Synthesis, and Energy‐Related Applications
Yuan, C., Wu, H. B., Xie, Y., & Lou, X. W. (. (2014) · Angewandte Chemie International Edition · doi:10.1002/anie.201303971 · Cited by 2,304
Metal Oxide Hollow Nanostructures for Lithium‐ion Batteries
Wang, Z., Zhou, L., & (David) Lou, X. W. (2012) · Advanced Materials · doi:10.1002/adma.201200469 · Cited by 1,506
Metal–organic frameworks as platforms for clean energy
Li, S.-L., & Xu, Q. (2013) · Energy & Environmental Science · doi:10.1039/c3ee40507a · Cited by 970
Metal organic frameworks for electrochemical applications
Morozan, A., & Jaouen, F. (2012) · Energy & Environmental Science · doi:10.1039/c2ee22989g · Cited by 870
Metadata
- Authors
- Courtel, F. M., Duncan, H., Abu-Lebdeh, Y., & Davidson, I. J.
- Venue
- Journal of Materials Chemistry
- Publisher
- Royal Society of Chemistry (RSC)
- Published
- 2011
- Volume
- 21
- Issue
- 27
- Pages
- 10206
- ISSN
- 0959-9428 (ISSN-L)
- 1364-5501
- OpenAlex
- W2063199751
- Cited by
- 362
- References
- 29
- FWCI
- 23.17
- Type
- journal article
- Language
- en
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.